- 您现在的位置：买卖IC网 > PDF目录80074 > L6928Q1 (STMICROELECTRONICS) 1.65 A SWITCHING REGULATOR, 1400 kHz SWITCHING FREQ-MAX, DSO8 PDF资料下载
参数资料
| 型号： | L6928Q1 |
| 厂商： | STMICROELECTRONICS |
| 元件分类： | 稳压器 |
| 英文描述： | 1.65 A SWITCHING REGULATOR, 1400 kHz SWITCHING FREQ-MAX, DSO8 |
| 封装： | 3 X 3 MM, 1.08 MM HEIGHT, LEAD FREE, VFQFPN-8 |
| 文件页数： | 15/16页 |
| 文件大小： | 268K |
| 代理商： | L6928Q1 |
Operation description
L6928
8/16
4.1
Modes of operation
Depending on the SYNC pin value the device can operate in low consumption or low noise
mode. If the SYNC pin is high (higher than 1.3V) the low consumption mode is selected
while the low noise mode is selected if the SYNC pin is low (lower than 0.5V).
4.1.1
Low consumption mode
In this mode of operation, at light load, the device operates discontinuously based on the
COMP pin voltage, in order to keep the efficiency very high also in these conditions. While
the device is not switching the load discharges the output capacitor and the output voltage
goes down. When the feedback voltage goes lower than the internal reference, the COMP
pin voltage increases and when an internal threshold is reached, the device starts to switch.
In these conditions the peak current limit is set approximately in the range of 200mA-
400mA, depending on the slope compensation (see related section).
Once the device starts to switch the output capacitor is recharged. The feedback pin
increases and, when it reaches a value slightly higher than the reference voltage, the output
of the error amplifier goes down until a clamp is activated. At this point, the device stops to
switch. In this phase, most of the internal circuitries are off, so reducing the device
consumption down to a typical value of 25
A.
4.1.2
Low noise mode
If for noise reasons, the very low frequencies of the low consumption mode are undesirable,
the low noise mode can be selected. In low noise mode, the efficiency is a little bit lower
compared with the low consumption mode in very light load conditions but for medium-high
load currents the efficiency values are very similar.
Basically, the device switches with its internal free running frequency of 1.4MHz. Obviously,
in very light load conditions, the device could skip some cycles in order to keep the output
voltage in regulation.
4.1.3
Synchronization
The device can also be synchronized with an external signal from 1MHz up to 2MHz.
In this case the low noise mode is automatically selected. The device will eventually skip
some cycles in very light load conditions.
The internal synchronization circuit is inhibited in shortcircuit and overvoltage conditions in
order to keep the protections effective (see relative sections).
相关PDF资料 |
PDF描述 |
|---|---|
| LSP3123N50E | 7.5 A SWITCHING REGULATOR, 173 kHz SWITCHING FREQ-MAX, PDIP8 |
| LSP3123T50E | 7.5 A SWITCHING REGULATOR, 173 kHz SWITCHING FREQ-MAX, SFM5 |
| LQS50A48-2V5EKJ | 1-OUTPUT 200 W DC-DC REG PWR SUPPLY MODULE |
| LS4501-7EPD7TB1 | 1-OUTPUT 100 W AC-DC PWR FACTOR CORR MODULE |
| LSH-6455P | 5 A SWITCHING REGULATOR, PSFM5 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| L6928Q1TR | 功能描述:直流/直流开关调节器 HIGH EFFICIENCY MONO LITHIC SYNCHRONOUS RoHS:否 制造商:International Rectifier 最大输入电压:21 V 开关频率:1.5 MHz 输出电压:0.5 V to 0.86 V 输出电流:4 A 输出端数量: 最大工作温度: 安装风格:SMD/SMT 封装 / 箱体:PQFN 4 x 5 |
| L6928TQ1TR | 制造商:STMICROELECTRONICS 制造商全称:STMicroelectronics 功能描述:High efficiency monolithic synchronous step down regulator |
| L6928TR | 制造商:STMICROELECTRONICS 制造商全称:STMicroelectronics 功能描述:High efficiency monolithic synchronous step down regulator |
| L-693 | 制造商:RHOMBUS-IND 制造商全称:Rhombus Industries Inc. 功能描述:Common Mode Choke |
| L693 10A | 制造商:BELLING LEE 功能描述:FUSE QUICK BLOW 10A 制造商:BELLING LEE 功能描述:FUSE, QUICK BLOW, 10A 制造商:BELLING LEE 功能描述:FUSE, QUICK BLOW, 10A; Voltage Rating VAC:440V; Voltage Rating VDC:230V; Fuse Current:10A; Breaking Capacity:-; Fuse Size Metric:6.3mm x 32mm; Fuse Size Imperial:1/4" x 1-1/4"; Blow Characteristic:Fast Acting; Fuse Size Code:3AG ;RoHS Compliant: Yes |
发布紧急采购，3分钟左右您将得到回复。