参数资料
型号: LB11983
厂商: SANYO SEMICONDUCTOR CO LTD
元件分类: 运动控制电子
英文描述: BRUSHLESS DC MOTOR CONTROLLER, 1 A, PDIP20
封装: 0.300 INCH, DIP-20
文件页数: 7/7页
文件大小: 94K
代理商: LB11983
LB11983
PS No.7117-7/7
Sample Application Circuit (Reference)
Notes 1. Be sure to connect the VC pin to VCC directly before use.
2. For the constant of capacitor, etc., our value established through examination is given for reference.
Adjust the value according to the motor to be used when considering this IC.
3. If the output is not oscillated with the motor used, a capacitor inserted between output coil ends is not necessary.
4. Pins 5 through 7 (UIN, VIN, and WIN) are not to be used by a user. These are connected inside IC and should
always be kept independent and open.
5. NC pins (14 and 18) are not connected inside IC and can be used as relay pins.
SANYO Semiconductor Co.,Ltd. assumes no responsibility for equipment failures that result from using
products at values that exceed, even momentarily, rated values (such as maximum ratings, operating condition
ranges, or other parameters) listed in products specifications of any and all SANYO Semiconductor Co.,Ltd.
products described or contained herein.
SANYO Semiconductor Co.,Ltd. strives to supply high-quality high-reliability products, however, any and all
semiconductor products fail or malfunction with some probability. It is possible that these probabilistic failures or
malfunction could give rise to accidents or events that could endanger human lives, trouble that could give rise
to smoke or fire, or accidents that could cause damage to other property. When designing equipment, adopt
safety measures so that these kinds of accidents or events cannot occur. Such measures include but are not
limited to protective circuits and error prevention circuits for safe design, redundant design, and structural
design.
Upon using the technical information or products described herein, neither warranty nor license shall be granted
with regard to intellectual property rights or any other rights of SANYO Semiconductor Co.,Ltd. or any third
party. SANYO Semiconductor Co.,Ltd. shall not be liable for any claim or suits with regard to a third party's
intellctual property rights which has resulted from the use of the technical information and products mentioned
above.
Information (including circuit diagrams and circuit parameters) herein is for example only; it is not guaranteed
for volume production.
Any and all information described or contained herein are subject to change without notice due to
product/technology improvement, etc. When designing equipment, refer to the "Delivery Specification" for the
SANYO Semiconductor Co.,Ltd. product that you intend to use.
In the event that any or all SANYO Semiconductor Co.,Ltd. products described or contained herein are
controlled under any of applicable local export control laws and regulations, such products may require the
export license from the authorities concerned in accordance with the above law.
No part of this publication may be reproduced or transmitted in any form or by any means, electronic or
mechanical, including photocopying and recording, or any information storage or retrieval system, or otherwise,
without the prior written consent of SANYO Semiconductor Co.,Ltd.
This catalog provides information as of September, 2008. Specifications and information herein are subject
to change without notice.
0.022
μF to 0.047μF
Connect to VCC
LB11983
VOUT
WOUT
MCOM
VCC
UIN
VIN
WIN
C1
C2
CX
0.022
μF
0.022
μF
0.022
μF
0.022
μF
0.022
μF
0.5
Ω
0.1
μF
0.47
μF
1
2
3
4
5
6
7
8
9
10
UOUT
RF
NC
VC
FC
BFGO
GND
NC
PCOUT
VCOIN
Top view
20
19
18
17
16
15
14
13
12
11
560k
Ω
相关PDF资料
PDF描述
LB11988HR BRUSHLESS DC MOTOR CONTROLLER, 1.3 A, PDSO28
LB11998V BRUSHLESS DC MOTOR CONTROLLER, 1.3 A, PDSO30
LB1617M BRUSHLESS DC MOTOR CONTROLLER, 1.5 A, PDSO30
LB1649 BRUSH DC MOTOR CONTROLLER, 1 A, PDIP12
LB1651 BRUSH DC MOTOR CONTROLLER, 2 A, PDIP20
相关代理商/技术参数
参数描述
LB11983-E 功能描述:马达/运动/点火控制器和驱动器 FAN MOTOR RoHS:否 制造商:STMicroelectronics 产品:Stepper Motor Controllers / Drivers 类型:2 Phase Stepper Motor Driver 工作电源电压:8 V to 45 V 电源电流:0.5 mA 工作温度:- 25 C to + 125 C 安装风格:SMD/SMT 封装 / 箱体:HTSSOP-28 封装:Tube
LB11985 制造商:SANYO 制造商全称:Sanyo Semicon Device 功能描述:VCR Capstan Motor Brushless Motor Driver
LB11985H 制造商:SANYO 制造商全称:Sanyo Semicon Device 功能描述:VCR Capstan Motor Brushless Motor Driver
LB11987 制造商:未知厂家 制造商全称:未知厂家 功能描述:Refrigerator Fan Motor Driver - Preliminary
LB11988 制造商:SANYO 制造商全称:Sanyo Semicon Device 功能描述:For Refrigerator Fan Motor Driver