- 您现在的位置：买卖IC网 > PDF目录79679 > LC005A 1-OUTPUT 5 W DC-DC REG PWR SUPPLY MODULE PDF资料下载
参数资料
| 型号： | LC005A |
| 元件分类： | 电源模块 |
| 英文描述： | 1-OUTPUT 5 W DC-DC REG PWR SUPPLY MODULE |
| 封装： | 32 X 25.40 MM, 10.20 MM HEIGHT, LOW PROFILE, MODULE |
| 文件页数： | 3/20页 |
| 文件大小： | 369K |
| 代理商： | LC005A |
Lucent Technologies Inc.
11
Data Sheet
December 1999
18 Vdc to 36 Vdc or 36 Vdc to 75 Vdc Inputs, 5 W
LC/LW005-Series Power Modules:
Feature Descriptions
Overcurrent Protection
To provide protection in a fault (output overload) condi-
tion, the unit is equipped with internal current-limiting
circuitry and can endure current limiting for an unlim-
ited duration. At the point of current-limit inception, the
unit shifts from voltage control to current control. If the
output voltage is pulled very low during a severe fault,
the current-limit circuit can exhibit either foldback or
tailout characteristics (output-current decrease or
increase). The unit operates normally once the output
current is brought back into its specied range.
Output Overvoltage Protection
The output overvoltage clamp consists of control cir-
cuitry, almost entirely independent of the secondary
regulation circuitry, that monitors the voltage on the
output terminals. This control loop has a higher voltage
set point than the primary loop (see Feature Specica-
tions table). In a fault condition, the overvoltage clamp
ensures that the output voltage does not exceed
VO, clamp, max. This provides a redundant voltage-
control that reduces the risk of output overvoltage.
If totally redundant overvoltage protection is needed in
the user application, it is recommended that an exter-
nal overvoltage protection circuitry be used on the user
application board assembly for additional protection.
For external overvoltage protection circuit suggestions,
contact technical support.
Input Undervoltage Lockout
At input voltages below the input undervoltage lockout
limit, the module operation is disabled. The module will
begin to operate at an input voltage between the under-
voltage lockout limit and the minimum operating input
voltage.
Remote On/Off (Optional)
Positive logic, device code sufx “4,” remote on/off
turns the module on during a logic-high voltage on the
REMOTE ON/OFF pin, and off during a logic low.
To turn the power module on and off, the user must
supply a switch to control the voltage between the
on/off terminal and the VI(–) terminal (Von/off). The
switch may be an open collector or equivalent
The maximum Ion/off during a logic low is 10 mA. The
switch should maintain a logic-low voltage while sinking
10 mA.
During a logic high, the maximum Von/off generated by
the power module is 15 V. The maximum allowable
leakage current of the switch at Von/off = 15 V is 50
A.
8-758(C).a
Figure 19. Remote On/Off Implementation
Synchronization (Optional)
With external circuitry, the unit is capable of synchroni-
zation at 300 kHz from an independent time base with
a switching rate of 600 kHz. The synchronization signal
should be applied when the unit is operating to ensure
the unit functions properly.
8-2712(C)
Figure 20. Synchronization Information
+
Ion/off
–
Von/off
REMOTE
ON/OFF
VI(+)
VI(–)
ISYNC
SYNC
VI(–)
348
BAS16
OR
EQUIVALENT
ISYNC =
1.67 s
9 mA
± 1 mA
0 mA
ISYNC = 25% DUTY CYCLE, 600 kHz
A 600 kHz SYNCHRONIZATION SIGNAL
WILL CAUSE THE POWER MODULE TO
HAVE A SWITCHING FREQUENCY OF
300 kHz.
相关PDF资料 |
PDF描述 |
|---|---|
| LX1555IDM-TR | 1 A SWITCHING CONTROLLER, 500 kHz SWITCHING FREQ-MAX, PDSO8 |
| LSP3122KAE | 6.9 A SWITCHING REGULATOR, 173 kHz SWITCHING FREQ-MAX, PSSO5 |
| LPC9DP | 2-OUTPUT 65 W DC-DC REG PWR SUPPLY MODULE |
| LM385BCOA-2.5713 | 1-OUTPUT TWO TERM VOLTAGE REFERENCE, 2.5 V, PDSO8 |
| LT1847CJ | SWITCHING CONTROLLER, 500 kHz SWITCHING FREQ-MAX, CDIP |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LC010 | 制造商:MA-COM 制造商全称:M/A-COM Technology Solutions, Inc. 功能描述:Power Modules: 18 Vdc to 36 Vdc or 36 Vdc to 75 Vdc Inputs, 10 W and 15 W |
| LC010A | 功能描述:DC/DC转换器 5V 2A 10W 6-Pin RoHS:否 制造商:Murata 产品: 输出功率: 输入电压范围:3.6 V to 5.5 V 输入电压（标称）: 输出端数量:1 输出电压（通道 1）:3.3 V 输出电流（通道 1）:600 mA 输出电压（通道 2）: 输出电流（通道 2）: 安装风格:SMD/SMT 封装 / 箱体尺寸: |
| LC010A2 | 功能描述:DC/DC转换器 STEP DWN 24Vin 2-PIN RoHS:否 制造商:Murata 产品: 输出功率: 输入电压范围:3.6 V to 5.5 V 输入电压（标称）: 输出端数量:1 输出电压（通道 1）:3.3 V 输出电流（通道 1）:600 mA 输出电压（通道 2）: 输出电流（通道 2）: 安装风格:SMD/SMT 封装 / 箱体尺寸: |
| LC010AJ | 制造商:MA-COM 制造商全称:M/A-COM Technology Solutions, Inc. 功能描述:Power Modules: 18 Vdc to 36 Vdc or 36 Vdc to 75 Vdc Inputs, 10 W and 15 W |
发布紧急采购，3分钟左右您将得到回复。