PS No. 5760-9/9
LC7535M
This catalog provides information as of May, 1998. Specifications and information herein are subject to change
without notice.
s No products described or contained herein are intended for use in surgical implants, life-support systems, aerospace
equipment, nuclear power control systems, vehicles, disaster/crime-prevention equipment and the like, the failure of
which may directly or indirectly cause injury, death or property loss.
s Anyone purchasing any products described or contained herein for an above-mentioned use shall:
Accept full responsibility and indemnify and defend SANYO ELECTRIC CO., LTD., its affiliates, subsidiaries and
distributors and all their officers and employees, jointly and severally, against any and all claims and litigation and all
damages, cost and expenses associated with such use:
Not impose any responsibility for any fault or negligence which may be cited in any such claim or litigation on
SANYO ELECTRIC CO., LTD., its affiliates, subsidiaries and distributors or any of their officers and employees
jointly or severally.
s Information (including circuit diagrams and circuit parameters) herein is for example only; it is not guaranteed for
volume production. SANYO believes information herein is accurate and reliable, but no guarantees are made or implied
regarding its use or any infringements of intellectual property rights or other rights of third parties.
Usage Notes
The state of the internal analog switches are undefined when power is first applied. Applications should apply external
muting to the output signal until the control data has been set up.
To prevent the high-frequency digital signals transmitted over the CL, DI, and CE pin lines from entering the analog
signal system, these lines should either be covered by the ground pattern or shielded cables should be used.
80-kHz low-pass weighting
Flat overall
Output level, VO – dBV
Total
harmonic
distortion,
THD
—
%
THD – Output Level Characteristics (1)
80-kHz low-pass weighting
Volume control set to –20 dB
Output level, VO – dBV
Total
harmonic
distortion,
THD
—
%
THD – Output Level Characteristics (2)