LFEC10E-3QN208C (Lattice) PDF资料下载 Datasheet(89/163 页)

您现在的位置：买卖IC网 > PDF目录4588 > LFEC10E-3QN208C (Lattice Semiconductor Corporation)IC FPGA 10.2KLUTS 147I/O 208QFP PDF资料下载

参数资料

型号：	LFEC10E-3QN208C
厂商：	Lattice Semiconductor Corporation
文件页数：	89/163页
文件大小：	0K
描述：	IC FPGA 10.2KLUTS 147I/O 208QFP
标准包装：	24
系列：	EC
逻辑元件/单元数：	10200
RAM 位总计：	282624
输入/输出数：	147
电源电压：	1.14 V ~ 1.26 V
安装类型：	表面贴装
工作温度：	0°C ~ 85°C
封装/外壳：	208-BFQFP
供应商设备封装：	208-PQFP（28x28）

2-28

Architecture

LatticeECP/EC Family Data Sheet

Polarity Control Logic

In a typical DDR Memory interface design, the phase relation between the incoming delayed DQS strobe and the

internal system Clock (during the READ cycle) is unknown.

The LatticeECP/EC family contains dedicated circuits to transfer data between these domains. To prevent setup

and hold violations at the domain transfer between DQS (delayed) and the system Clock a clock polarity selector is

used. This changes the edge on which the data is registered in the synchronizing registers in the input register

block. This requires evaluation at the start of each READ cycle for the correct clock polarity.

Prior to the READ operation in DDR memories DQS is in tristate (pulled by termination). The DDR memory device

drives DQS low at the start of the preamble state. A dedicated circuit detects this transition. This signal is used to

control the polarity of the clock to the synchronizing registers.

sysI/O Buffer

Each I/O is associated with a flexible buffer referred to as a sysI/O buffer. These buffers are arranged around the

periphery of the device in eight groups referred to as Banks. The sysI/O buffers allow users to implement the wide

variety of standards that are found in today’s systems including LVCMOS, SSTL, HSTL, LVDS and LVPECL.

sysI/O Buffer Banks

LatticeECP/EC devices have eight sysI/O buffer banks; each is capable of supporting multiple I/O standards. Each

sysI/O bank has its own I/O supply voltage (VCCIO), and two voltage references VREF1 and VREF2 resources allow-

ing each bank to be completely independent from each other. Figure 2-34 shows the eight banks and their associ-

ated supplies.

In the LatticeECP/EC devices, single-ended output buffers and ratioed input buffers (LVTTL, LVCMOS, PCI and PCI-

X) are powered using VCCIO. LVTTL, LVCMOS33, LVCMOS25 and LVCMOS12 can also be set as fixed threshold

input independent of VCCIO. In addition to the bank VCCIO supplies, the LatticeECP/EC devices have a VCC core logic

power supply, and a VCCAUX supply that power all differential and referenced buffers.

Each bank can support up to two separate VREF voltages, VREF1 and VREF2 that set the threshold for the refer-

enced input buffers. In the LatticeECP/EC devices, some dedicated I/O pins in a bank can be configured to be a

reference voltage supply pin. Each I/O is individually configurable based on the bank’s supply and reference volt-

ages.

相关代理商/技术参数	参数描述
LFEC10E-3QN208I	功能描述:FPGA - 现场可编程门阵列 10.2K LUTs 147 I/O RoHS:否制造商:Altera Corporation 系列:Cyclone V E 栅极数量: 逻辑块数量:943 内嵌式块RAM - EBR:1956 kbit 输入/输出端数量:128 最大工作频率:800 MHz 工作电源电压:1.1 V 最大工作温度:+ 70 C 安装风格:SMD/SMT 封装 / 箱体:FBGA-256
LFEC10E-3T100C	制造商:LATTICE 制造商全称:Lattice Semiconductor 功能描述:LatticeECP/EC Family Data Sheet
LFEC10E-3T100I	制造商:LATTICE 制造商全称:Lattice Semiconductor 功能描述:LatticeECP/EC Family Data Sheet
LFEC10E-3T144C	制造商:LATTICE 制造商全称:Lattice Semiconductor 功能描述:LatticeECP/EC Family Data Sheet
LFEC10E-3T144I	制造商:LATTICE 制造商全称:Lattice Semiconductor 功能描述:LatticeECP/EC Family Data Sheet

发布紧急采购，3分钟左右您将得到回复。

(若只采购一条型号，填写一行即可)

*型号	*数量	厂商	批号	封装

添加更多采购