- 您现在的位置：买卖IC网 > PDF目录79748 > LK1001-9ERD4T 1-OUTPUT 150 W AC-DC REG PWR SUPPLY MODULE PDF资料下载
参数资料
| 型号： | LK1001-9ERD4T |
| 元件分类： | 电源模块 |
| 英文描述： | 1-OUTPUT 150 W AC-DC REG PWR SUPPLY MODULE |
| 封装： | HEAT SINK, METAL, CASE K02, MODULE |
| 文件页数： | 25/27页 |
| 文件大小： | 640K |
| 代理商： | LK1001-9ERD4T |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页当前第25页第26页第27页
K-Family
DC-DC Converters >100 W
Rugged Environment
8 - 8
Edition 2/96 - Melcher AG
MELCHER
The Power Partners.
8.1
Input Fuse
A fuse mounted inside the converter protects the module
against severe defects. This fuse may not fully protect the
module when the input voltage exceeds 200 V DC! In appli-
cations where the converters operate at source voltages
above 200 V DC an external fuse or a circuit breaker at sys-
tem level should be installed!
Table 5: Fuse Specification
Module
Fuse type
Fuse rating
AK 1
fast-blow
Little fuse 314
30.0 A, 125 V
BK 1
fast-blow
Little fuse 314
25.0 A, 125 V
CK 2
slow-blow
SPT
12.5 A, 250 V
DK 2
slow-blow
SPT
8 A, 250 V
EK 2
slow-blow
SPT
4 A, 250 V
FK 2
slow-blow
SPT
16 A, 250 V
LK 2
slow-blow
SPT
4 A, 250 V
1 Fuse size 6.3
× 32 mm
2 Fuse size 5
× 20 mm
Input Transient Protection
A suppressor diode or a VDR (depending upon the input
voltage range) together with the input fuse and a symmetri-
cal input filter form an effective protection against high input
transient voltages which typically occur in most installa-
tions, but especially in battery driven mobile applications.
Nominal battery voltages in use are: 12, 24, 36, 48, 60, 72,
110 and 220 V. In most cases each nominal value is speci-
fied to a tolerance of –30 %/+25%.
In certain applications, surges according to RIA 12 are
specified in addition to those defined in IEC 571-1. The
power supply must not switch off during these surges and
since their energy can not practically be absorbed an ex-
tremely wide input range is required.The EK input range for
110 V batteries has been designed to meet this requirement
and is available upon customer request.
Input Under-/Overvoltage Cut-out
If the input voltage remains below approx. 0.8
Ui min or ex-
ceeds approx. 1.1
Ui max, an internally generated inhibit sig-
nal disables the output(s). When checking this function the
absolute maximum input voltage rating
U i abs should be
considered!
Inrush Current Limitation
The C/D/E/LK modules of the versions -7, -6, -5 incorpo-
rate a NTC resistor in the input circuitry which - at initial turn
on - reduces the peak inrush current value by a factor of
5...10 to protect connectors and switching devices from
damage. Subsequent switch-on cycles within short periods
will cause an increase of the peak inrush current value due
to the warming-up of the NTC resistor. See also option E.
Inrush Current Peak Value
The inrush current peak value/initial switch-on cycle) can
be determined by following calculation: (See also Input In-
rush Current Characteristic)
Ui source
Iinr p = ––––––––––––––––
(
Rs ext + Ri + RNTC)
Rs ext
Ri
RNTC
Iinr p
Ui source
+
Ci int
Fig. 4
Equivalent circuit for input impedance
Input Inrush Current Characteristic
1
23
t [ms]
0
50
100
Ii inr [A]
150
CK
EK, LK
DK
Fig. 5
Typical inrush current versus time at Ui max, Rext = 0.
For AK/BK and FK as well as for application related val-
ues use the formula given in section "Inrush Current Peak
Value" to get realistic results.
相关PDF资料 |
PDF描述 |
|---|---|
| LK1001-9PV3TB1 | 1-OUTPUT 150 W AC-DC REG PWR SUPPLY MODULE |
| LK1001-9RD0 | 1-OUTPUT 150 W AC-DC REG PWR SUPPLY MODULE |
| LK1001-9RD2TB1 | 1-OUTPUT 150 W AC-DC REG PWR SUPPLY MODULE |
| LK1001-9RD4B1 | 1-OUTPUT 150 W AC-DC REG PWR SUPPLY MODULE |
| LK1301-7EPDDT | 1-OUTPUT 150 W AC-DC REG PWR SUPPLY MODULE |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LK100-24P | 制造商:未知厂家 制造商全称:未知厂家 功能描述:Optoelectronic |
| LK100-28P | 制造商:未知厂家 制造商全称:未知厂家 功能描述:Optoelectronic |
| LK10051R0K-T | 功能描述:固定电感器 INDCTR STD MULTILYR 0402 1uH 10% RoHS:否 制造商:AVX 电感:10 uH 容差:20 % 最大直流电流:1 A 最大直流电阻:0.075 Ohms 工作温度范围:- 40 C to + 85 C 自谐振频率:38 MHz Q 最小值:40 尺寸:4.45 mm W x 6.6 mm L x 2.92 mm H 屏蔽:Shielded 端接类型:SMD/SMT 封装 / 箱体:6.6 mm x 4.45 mm |
| LK10051R0K-T | 制造商:TAIYO YUDEN 功能描述:Inductor Series:LF LK |
| LK10051R0K-TV | 功能描述:FIXED IND 1UH 20MA 640 MOHM SMD 制造商:taiyo yuden 系列:LK 包装:剪切带（CT） 零件状态:在售 类型:多层 材料 - 磁芯:- 电感:1μH 容差:±10% 额定电流:20mA 屏蔽:无屏蔽 DC 电阻（DCR）:640 毫欧 不同频率时的 Q 值:20 @ 10MHz 频率 - 自谐振:60MHz 等级:AEC-Q200 工作温度:-40°C ~ 85°C 频率 - 测试:10MHz 安装类型:表面贴装 封装/外壳:0402（1005 公制） 供应商器件封装:0402（1005 公制） 大小/尺寸:0.039" 长 x 0.020" 宽（1.00mm x 0.50mm） 高度 - 安装（最大值）:0.022"（0.55mm） 标准包装:1 |
发布紧急采购，3分钟左右您将得到回复。