- 您现在的位置：买卖IC网 > PDF目录80309 > LK5540-9ERT (POWER-ONE INC) 2-OUTPUT 150 W AC-DC PWR FACTOR CORR MODULE PDF资料下载
参数资料
| 型号： | LK5540-9ERT |
| 厂商： | POWER-ONE INC |
| 元件分类： | 电源模块 |
| 英文描述： | 2-OUTPUT 150 W AC-DC PWR FACTOR CORR MODULE |
| 封装： | HEAT SINK, METAL, CASE K02, MODULE |
| 文件页数： | 17/28页 |
| 文件大小： | 606K |
| 代理商： | LK5540-9ERT |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页当前第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页
Cassette Style
150 Watt AC-DC Converters
K Series PFC
Edition 01/01.2001
24/28
Vo1+
Vo1–
D
UD
ID
Rp
Input
11007
NPN output (D5...DD):
Connector pin D is internally connected via the collector-
emitter path of a NPN transistor to the negative potential of
output 1.
UD
< 0.4 V (logic low) corresponds to a monitored
voltage level (
Ui and/or Uo1)
> U
t + Uh. The current ID
through the open collector should not exceed 20 mA. The
NPN output is not protected against external overvoltages.
UD should not exceed 40 V.
Ui, Uo1 status
D output,
UD
Ui or Uo1 < Ut
high, H,
ID ≤ 25 A at UD = 40 V
Ui and Uo1 > Ut + Uh
low, L,
UD ≤ 0.4 V at ID = 20 mA
Fig. 37
Option D5...DD: NPN output, Uo1
≤ 40 V, I
D
≤ 20 mA
Table 19: D-output logic signals
Version of D
Ui < Ut resp. Uo < Ut
Ui > Ut + Uh resp. Uo > Ut
Conguration
D1, D2, D3, D4, D0
low
high
JFET
D5, D6, D7, D8, D9, DD
high
low
NPN
Option D Undervoltage monitor
The input and/or output undervoltage monitoring circuit op-
erates independently of the built-in input undervoltage lock-
out circuit. A logic "low" (JFET output) or "high" signal (NPN
output) is generated at pin 20 as soon as one of the moni-
tored voltages drops below the preselected threshold level
Ut. The return for this signal is Vo1–. The D output reco-
vers when the monitored voltage(s) exceed(s)
Ut + Uh. The
Table 18: Undervoltage monitoring functions
Output type
Monitoring
Minimum adjustment range
Typical hysteresis
Uho [% of Ut]
JFET
NPN
U i
Uo1
of threshold level
U t
for
U t min...U t max
Uti
Uto
Uho
D1
D5
no
yes
-
3.5...40 V 1
2.5...0.6
D2
D6
yes
no
355 V DC 4
--
D3
D7
yes
355 V DC 4
(0.95...0.985
Uo1) 2
"0"
D4
D8
no
yes
-
(0.95...0.985
Uo1) 2
"0"
D0
D9
no
yes
-
3.5...40 V 3
2.5...0.6
yes
355 V DC 4
3.5...40 V 3
2.5...0.6
DD
yes
355 V DC4
3.5...40 V 1
2.5...0.6
1 Threshold level adjustable by potentiometer
2 Fixed value. Tracking if Uo1 adjusted via R-input, option P or sense lines.
3 The threshold level permanently adjusted according to customer specication
±2% at 25°C. Any value within the specied range is
basically possible but causes a special type designation in addition to the standard option designations (D0/D9)!
4 Option D monitors the boost regulator output voltage. The trigger level is adjusted in the factory to 355 V DC.
threshold level
Uti is adjusted in the factory. The threshold
level
Uto is either adjusted by a potentiometer, accessible
through a hole in the front cover, or factory adjusted to a
xed value specied by the customer.
Option D exists in various versions D0...DD as shown in the
following table.
Vo1+
Vo1–
D
UD
ID
Rp
Input
11006
Fig. 36
Option D0...D4: JFET output, ID
≤ 2.5 mA
JFET output (D0…D4):
Connector pin D is internally connected via the drain-
source path of a JFET (self-conducting type) to the nega-
tive potential of output 1.
UD
≤ 0.4 V (logic low) corresponds
to a monitored voltage level (
Ui and/or Uo1)
<U
t. The cur-
rent
ID through the JFET should not exceed 2.5 mA. The
JFET is protected by a 0.5 W Zener diode of 8.2 V against
external overvoltages.
Ui, Uo1 status
D output,
UD
Ui or Uo1 < Ut
low, L,
UD ≤ 0.4 V at ID = 2.5 mA
Ui and Uo1 > Ut + Uh
high, H,
ID ≤ 25 A at UD = 5.25 V
相关PDF资料 |
PDF描述 |
|---|---|
| LFC789D25CPWR | SPECIALTY ANALOG CIRCUIT, PDSO8 |
| LT1374IR-5#TRPBF | 8.5 A SWITCHING REGULATOR, 560 kHz SWITCHING FREQ-MAX, PSSO7 |
| LM4051AIX3-1.2+T | 1-OUTPUT TWO TERM VOLTAGE REFERENCE, 1.225 V, PDSO3 |
| LES25A48-1V5REJ | 1-OUTPUT 37.5 W DC-DC REG PWR SUPPLY MODULE |
| LM22674QMRX-ADJ | 0.9 A SWITCHING REGULATOR, 600 kHz SWITCHING FREQ-MAX, PDSO8 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LK5660-7R | 功能描述:线性和开关式电源 24V/3A OUT AC-DC CONVERTER RoHS:否 制造商:TDK-Lambda 产品:Switching Supplies 开放式框架/封闭式:Enclosed 输出功率额定值:800 W 输入电压:85 VAC to 265 VAC 输出端数量:1 输出电压（通道 1）:20 V 输出电流（通道 1）:40 A 商用/医用: 输出电压（通道 2）: 输出电流（通道 2）: 安装风格:Rack 长度: 宽度: 高度: |
| LK5660-9ER | 制造商:Power-One 功能描述:AC/DC PS DUAL-OUT 24V/24V 5.2A/5.2A 280W 15PIN - Bulk |
| LK-590-001 | 功能描述:LED MODULE 1W AMBER RoHS:是 类别:光电元件 >> LED - 高亮度电源模块 系列:- 标准包装:36 系列:5027 TFFC STAR K2 颜色:暖白色 配置:星形 在特定电流下的光通量 - 测试:75lm 电流 - 测试:350mA 电流 - 最大:1.5A 带连接器:无 驱动器电路:无 波长:- 电压:- |
| LK-590-001-FC | 功能描述:LED MODULE 1W AMBER W/CONN RoHS:是 类别:光电元件 >> LED - 高亮度电源模块 系列:- 标准包装:36 系列:5027 TFFC STAR K2 颜色:暖白色 配置:星形 在特定电流下的光通量 - 测试:75lm 电流 - 测试:350mA 电流 - 最大:1.5A 带连接器:无 驱动器电路:无 波长:- 电压:- |
| LK-59A-1 | 制造商:ITT Interconnect Solutions 功能描述:OBS - Bulk |
发布紧急采购，3分钟左右您将得到回复。