- 您现在的位置：买卖IC网 > PDF目录2082 > LM1894M/NOPB (National Semiconductor)IC DYNAM NOISE REDUCT SYS 14SOIC PDF资料下载
参数资料
| 型号： | LM1894M/NOPB |
| 厂商： | National Semiconductor |
| 文件页数： | 2/19页 |
| 文件大小： | 0K |
| 描述： | IC DYNAM NOISE REDUCT SYS 14SOIC |
| 标准包装： | 55 |
| 类型： | 动态噪音抑制 |
| 应用： | 车载系统，播放器，电视 |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 14-SOIC（0.154"，3.90mm 宽） |
| 供应商设备封装： | 14-SOICN |
| 包装： | 管件 |
| 配用： | LM1894MTBD-ND - BOARD EVALUATION LM1894 |
| 其它名称： | *LM1894M *LM1894M/NOPB LM1894M |
SNAS551C – DECEMBER 1994 – REVISED APRIL 2013
APPLICATION HINTS
The DNR system should always be placed before tone and volume controls as shown in Figure 1. This is
because any adjustment of these controls would alter the noise floor seen by the DNR control path. The
sensitivity resistors R1 and R2 may need to be switched with the input selector, depending on the noise floors of
different sources, i.e., tape, FM, phono. To determine the value of R1 and R2 in a tape system for instance;
apply tape noise (no program material) and adjust the ratio of R1 and R2 to open slightly the bandwidth of the
main signal path. This can easily be done by viewing the capacitor voltage of pin 10 with an oscilloscope, or by
using the circuit of Figure 14. This circuit gives an LED display of the voltage on the peak detector capacitor.
Adjust the values of R1 and R2 (their sum is always 1 k
Ω) to light the LEDs of pin 1 and pin 18. The LED bar
graph does not indicate signal level, but rather instantaneous bandwidth of the two filters; it should not be used
as a signal-level indicator. For greater flexibility in setting the bandwidth sensitivity, R1 and R2 could be replaced
by a 1 k
Ω potentiometer.
To change the minimum and maximum value of bandwidth, the integrating capacitors, C3 and C12, can be
scaled up or down. Since the bandwidth is inversely proportional to the capacitance, changing this 0.0039
μF
capacitor to 0.0033
μF will change the typical bandwidth from 965 Hz–34 kHz to 1.1 kHz–40 kHz. With C3 and
C12 set at 0.0033
μF, the maximum bandwidth is typically 34 kHz. A double pole double throw switch can be
used to completely bypass DNR.
The capacitor on pin 10 in conjunction with internal resistors sets the attack and decay times. The attack time
can be altered by changing the size of C10. Decay times can be decreased by paralleling a resistor with C10,
and increased by increasing the value of C10.
When measuring the amount of noise reduction of the DNR system, the frequency response of the cassette
should be flat to 10 kHz. The CCIR weighting network has substantial gain to 8 kHz and any additional roll-off in
the cassette player will reduce the benefits of DNR noise reduction. A typical signal-to-noise measurement circuit
is shown in Figure 15. The DNR system should be switched from maximum bandwidth to nominal bandwidth with
tape noise as a signal source. The reduction in measured noise is the signal-to-noise ratio improvement.
Figure 14. Bar Graph Display of Peak Detector Voltage
10
Copyright 1994–2013, Texas Instruments Incorporated
Product Folder Links: LM1894
相关PDF资料 |
PDF描述 |
|---|---|
| LM2903MX | IC COMPARATOR DUAL 0.4MA 8-SOIC |
| LM2903PT | IC COMPARATOR DUAL GP 8TSSOP |
| LM293AMX | IC COMPARATOR DUAL DIFF 8-SOP |
| LM311DR2 | IC COMPARATOR SGL HI VOLT 8SOIC |
| LM319M | IC COMPARATOR DUAL HS 14-SOP |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LM1894MT | 制造商:未知厂家 制造商全称:未知厂家 功能描述: |
| LM1894MTBD | 功能描述:BOARD EVALUATION LM1894 RoHS:否 类别:编程器，开发系统 >> 评估演示板和套件 系列:- 标准包装:1 系列:PCI Express® (PCIe) 主要目的:接口，收发器，PCI Express 嵌入式:- 已用 IC / 零件:DS80PCI800 主要属性:- 次要属性:- 已供物品:板 |
| LM1894MX | 功能描述:特殊用途放大器 RoHS:否 制造商:Texas Instruments 通道数量:Single 共模抑制比（最小值）: 输入补偿电压: 工作电源电压:3 V to 5.5 V 电源电流:5 mA 最大功率耗散: 最大工作温度:+ 70 C 最小工作温度:- 40 C 安装风格:SMD/SMT 封装 / 箱体:QFN-20 封装:Reel |
| LM1894MX/NOPB | 功能描述:特殊用途放大器 RoHS:否 制造商:Texas Instruments 通道数量:Single 共模抑制比（最小值）: 输入补偿电压: 工作电源电压:3 V to 5.5 V 电源电流:5 mA 最大功率耗散: 最大工作温度:+ 70 C 最小工作温度:- 40 C 安装风格:SMD/SMT 封装 / 箱体:QFN-20 封装:Reel |
| LM1894N | 制造商:Rochester Electronics LLC 功能描述:- Bulk 制造商:OC White Company 功能描述:Dynamic Noise Reduction System 14-Pin PDIP Rail |
发布紧急采购，3分钟左右您将得到回复。