- 您现在的位置：买卖IC网 > PDF目录79688 > LM2577MX-12/NOPB (NATIONAL SEMICONDUCTOR CORP) 6 A SWITCHING REGULATOR, 62 kHz SWITCHING FREQ-MAX, PDSO24 PDF资料下载
参数资料
| 型号： | LM2577MX-12/NOPB |
| 厂商： | NATIONAL SEMICONDUCTOR CORP |
| 元件分类： | 稳压器 |
| 英文描述： | 6 A SWITCHING REGULATOR, 62 kHz SWITCHING FREQ-MAX, PDSO24 |
| 封装： | 0.300 INCH, SO-24 |
| 文件页数： | 31/34页 |
| 文件大小： | 1008K |
| 代理商： | LM2577MX-12/NOPB |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页当前第31页第32页第33页第34页
Electrical Characteristics — LM1577-ADJ, LM2577-ADJ (Continued)
Specifications with standard type face are for T
J = 25C, and those in bold type face apply over full Operating Temperature
Range. Unless otherwise specified, V
IN = 5V, VFEEDBACK = VREF, and ISWITCH = 0.
LM1577-ADJ LM2577-ADJ
Units
Symbol
Parameter
Conditions
Typical
Limit
(Limits)
(Notes 3, 4)
(Note 5)
DEVICE PARAMETERS
I
L
Switch Leakage
V
SWITCH = 65V
10
A
Current
V
FEEDBACK = 1.5V (Switch Off)
300/600
A(max)
V
SAT
Switch Saturation
I
SWITCH = 2.0A
0.5
V
Voltage
V
COMP = 2.0V (Max Duty Cycle)
0.7/0.9
V(max)
NPN Switch
V
COMP = 2.0V
4.3
A
Current Limit
3.7/3.0
A(min)
5.3/6.0
A(max)
THERMAL PARAMETERS (All Versions)
θ
JA
Thermal Resistance
K Package, Junction to Ambient
35
C/W
θ
JC
K Package, Junction to Case
1.5
θ
JA
T Package, Junction to Ambient
65
θ
JC
T Package, Junction to Case
2
θ
JA
N Package, Junction to
85
Ambient (Note 8)
θ
JA
M Package, Junction
100
to Ambient (Note 8)
θ
JA
S Package, Junction to
37
Ambient (Note 9)
Note 1: Absolute Maximum Ratings indicate limits beyond which damage to the device may occur. Operating ratings indicate conditions the device is intended to
be functional, but device parameter specifications may not be guaranteed under these conditions. For guaranteed specifications and test conditions, see the Electrical
Characteristics.
Note 2: Due to timing considerations of the LM1577/LM2577 current limit circuit, output current cannot be internally limited when the LM1577/LM2577 is used as a
step-up regulator. To prevent damage to the switch, its current must be externally limited to 6.0A. However, output current is internally limited when the LM1577/
LM2577 is used as a flyback or forward converter regulator in accordance to the Application Hints.
Note 3: All limits guaranteed at room temperature (standard type face) and at temperature extremes (boldface type). All limits are used to calculate Outgoing Quality
Level, and are 100% production tested.
Note 4: A military RETS electrical test specification is available on request. At the time of printing, the LM1577K-12/883, LM1577K-15/883, and LM1577K-ADJ/883
RETS specifications complied fully with the boldface limits in these columns. The LM1577K-12/883, LM1577K-15/883, and LM1577K-ADJ/883 may also be procured
to Standard Military Drawing specifications.
Note 5: All limits guaranteed at room temperature (standard type face) and at temperature extremes (boldface type). All room temperature limits are 100% produc-
tion tested. All limits at temperature extremes are guaranteed via correlation using standard Statistical Quality Control (SQC) methods.
Note 6: External components such as the diode, inductor, input and output capacitors can affect switching regulator performance. When the LM1577/LM2577 is used
as shown in the Test Circuit, system performance will be as specified by the system parameters.
Note 7: A 1.0 M
resistor is connected to the compensation pin (which is the error amplifier’s output) to ensure accuracy in measuring AVOL. In actual applications,
this pin’s load resistance should be
≥10 M, resulting in AVOL that is typically twice the guaranteed minimum limit.
Note 8: Junction to ambient thermal resistance with approximately 1 square inch of pc board copper surrounding the leads. Additional copper area will lower thermal
resistance further. See thermal model in “Switchers Made Simple” software.
Note 9: If the TO-263 package is used, the thermal resistance can be reduced by increasing the PC board copper area thermally connected to the package. Using
0.5 square inches of copper area,
θJA is 50C/W; with 1 square inch of copper area, θJA is 37C/W; and with 1.6 or more square inches of copper area, θJA is 32C/W.
www.national.com
6
相关PDF资料 |
PDF描述 |
|---|---|
| LSP3122AK33E | SWITCHING CONTROLLER, PSSO5 |
| LES015ZH-2N | 1-OUTPUT 15 W DC-DC REG PWR SUPPLY MODULE |
| LES008YD-11V | 1-OUTPUT 15 W DC-DC REG PWR SUPPLY MODULE |
| LES008YD-2N1H | 1-OUTPUT 15 W DC-DC REG PWR SUPPLY MODULE |
| LES008ZDN1H | 1-OUTPUT 15 W DC-DC REG PWR SUPPLY MODULE |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LM2577MX-15 | 功能描述:IC REG MULTI CONFIG 15V 24SOIC RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:SIMPLE SWITCHER® 产品培训模块:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 标准包装:1 系列:- 类型:降压（降压） 输出类型:固定 输出数:1 输出电压:3.3V 输入电压:4.5 V ~ 24 V PWM 型:- 频率 - 开关:- 电流 - 输出:125mA 同步整流器:无 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:SOT-23-6 包装:Digi-Reel® 供应商设备封装:SOT-6 其它名称:MAX1836EUT33#TG16DKR |
| LM2577MX-ADJ | 功能描述:IC REG MULTI CONFIG ADJ 24SOIC RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:SIMPLE SWITCHER® 产品培训模块:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 标准包装:1 系列:- 类型:降压（降压） 输出类型:固定 输出数:1 输出电压:3.3V 输入电压:4.5 V ~ 24 V PWM 型:- 频率 - 开关:- 电流 - 输出:125mA 同步整流器:无 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:SOT-23-6 包装:Digi-Reel® 供应商设备封装:SOT-6 其它名称:MAX1836EUT33#TG16DKR |
| LM2577N-12 | 制造商:Rochester Electronics LLC 功能描述: 制造商:Texas Instruments 功能描述: |
| LM2577N-12/NOPB | 功能描述:IC REG MULTI CONFIG 12V 3A 16DIP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:SIMPLE SWITCHER® 产品培训模块:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 标准包装:1 系列:- 类型:降压（降压） 输出类型:固定 输出数:1 输出电压:3.3V 输入电压:4.5 V ~ 24 V PWM 型:- 频率 - 开关:- 电流 - 输出:125mA 同步整流器:无 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:SOT-23-6 包装:Digi-Reel® 供应商设备封装:SOT-6 其它名称:MAX1836EUT33#TG16DKR |
| LM2577N-15 | 制造商:NSC 制造商全称:National Semiconductor 功能描述:SIMPLE SWITCHER-R Step-Up Voltage Regulator |
发布紧急采购，3分钟左右您将得到回复。