- 您现在的位置：买卖IC网 > PDF目录98000 > LM26480QSQ-CF/NOPB (NATIONAL SEMICONDUCTOR CORP) 2.4 A SWITCHING REGULATOR, 2500 kHz SWITCHING FREQ-MAX, QCC24 PDF资料下载
参数资料
| 型号： | LM26480QSQ-CF/NOPB |
| 厂商： | NATIONAL SEMICONDUCTOR CORP |
| 元件分类： | 稳压器 |
| 英文描述： | 2.4 A SWITCHING REGULATOR, 2500 kHz SWITCHING FREQ-MAX, QCC24 |
| 封装： | 4 X 4 MM, 0.80 MM HEIGHT, ROHS COMPLIANT, LLP-24 |
| 文件页数： | 7/30页 |
| 文件大小： | 2455K |
| 代理商： | LM26480QSQ-CF/NOPB |
第1页第2页第3页第4页第5页第6页当前第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页
output voltage is relatively low compared to the voltage drop
across an ordinary rectifier diode.
CURRENT LIMITING
A current limit feature allows the converter to protect itself and
external components during overload conditions. PWM mode
implements current limiting using an internal comparator that
trips at 2.0A for both bucks (typ). If the output is shorted to
ground the device enters a timed current limit mode where the
NFET is turned on for a longer duration until the inductor cur-
rent falls below a low threshold, ensuring inductor current has
more time to decay, thereby preventing runaway.
PFM OPERATION
At very light loads, the converter enters PFM mode and op-
erates with reduced switching frequency and supply current
to maintain high efficiency.
The part will automatically transition into PFM mode when ei-
ther of two conditions occurs for a duration of 32 or more clock
cycles:
A. The inductor current becomes discontinuous
or
B. The peak PMOS switch current drops below the I
MODE
level
During PFM operation, the converter positions the output volt-
age slightly higher than the nominal output voltage during
PWM operation, allowing additional headroom for voltage
drop during a load transient from light to heavy load. The PFM
comparators sense the output voltage via the feedback pin
and control the switching of the output FETs such that the
output voltage ramps between 0.8% and 1.6% (typical) above
the nominal PWM output voltage. If the output voltage is be-
low the ‘high’ PFM comparator threshold, the PMOS power
switch is turned on. It remains on until the output voltage ex-
ceeds the ‘high’ PFM threshold or the peak current exceeds
the I
PFM level set for PFM mode. The typical peak current in
PFM mode is:
Once the PMOS power switch is turned off, the NMOS power
switch is turned on until the inductor current ramps to zero.
When the NMOS zero-current condition is detected, the
NMOS power switch is turned off. If the output voltage is be-
low the ‘high’ PFM comparator threshold (see following fig-
ure), the PMOS switch is again turned on and the cycle is
repeated until the output reaches the desired level. Once the
output reaches the ‘high’ PFM threshold, the NMOS switch is
turned on briefly to ramp the inductor current to zero and then
both output switches are turned off and the part enters an
extremely low power mode. Quiescent supply current during
this ‘sleep’ mode is less than 30 A, which allows the part to
achieve high efficiencies under extremely light load condi-
tions. When the output drops below the ‘low’ PFM threshold,
the cycle repeats to restore the output voltage to ~1.6% above
the nominal PWM output voltage.
If the load current should increase during PFM mode (see
figure below) causing the output voltage to fall below the
‘low2’ PFM threshold, the part will automatically transition into
fixed-frequency PWM mode.
SW1, SW2 CONTROL
SW1 and SW2 are enabled/disabled through the external en-
able pins.
The Modulation mode PWM/PFM is by default automatic and
depends on the load as described above in the functional de-
scription. The modulation mode can be factory trimmed, forc-
ing the buck to operate in PWM mode regardless of the load
condition.
15
www.national.com
LM26480
相关PDF资料 |
PDF描述 |
|---|---|
| LM26480SQ-BF/NOPB | 2.4 A SWITCHING REGULATOR, 2400 kHz SWITCHING FREQ-MAX, QCC24 |
| LM26480SQX-BF/NOPB | 2.4 A SWITCHING REGULATOR, 2400 kHz SWITCHING FREQ-MAX, QCC24 |
| LM2661M/NOPB | SWITCHED CAPACITOR CONVERTER, 80 kHz SWITCHING FREQ-MAX, PDSO8 |
| LM2660MMX/NOPB | SWITCHED CAPACITOR CONVERTER, 40 kHz SWITCHING FREQ-MAX, PDSO8 |
| LM2661MM/NOPB | SWITCHED CAPACITOR CONVERTER, 80 kHz SWITCHING FREQ-MAX, PDSO8 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LM26480QSQX-8D/NOPB | 制造商:Texas Instruments 功能描述:Externally Programmable Dual High-Curren |
| LM26480QSQX-AA/NOPB | 功能描述:低压差稳压器 - LDO RoHS:否 制造商:Texas Instruments 最大输入电压:36 V 输出电压:1.4 V to 20.5 V 回动电压（最大值）:307 mV 输出电流:1 A 负载调节:0.3 % 输出端数量: 输出类型:Fixed 最大工作温度:+ 125 C 安装风格:SMD/SMT 封装 / 箱体:VQFN-20 |
| LM26480QSQX-CF/NOPB | 功能描述:低压差稳压器 - LDO RoHS:否 制造商:Texas Instruments 最大输入电压:36 V 输出电压:1.4 V to 20.5 V 回动电压（最大值）:307 mV 输出电流:1 A 负载调节:0.3 % 输出端数量: 输出类型:Fixed 最大工作温度:+ 125 C 安装风格:SMD/SMT 封装 / 箱体:VQFN-20 |
| LM26480SQ-AA | 制造商:Texas Instruments 功能描述:DC/ DC STEP DOWN, DUAL LINEAR REG, IC |
| LM26480SQ-AA/NOPB | 功能描述:线性稳压器 - 标准 DUAL HI-CRNT STEP- DOWN DC/DC RoHS:否 制造商:STMicroelectronics 输出类型: 极性: 输出电压:1.8 V 输出电流:150 mA 负载调节: 最大输入电压:5.5 V 线路调整率: 最大工作温度:+ 125 C 安装风格:SMD/SMT 封装 / 箱体:SOT-323-5L |
发布紧急采购，3分钟左右您将得到回复。