参数资料
型号: LM3622AMX-4.2/NOPB
厂商: NATIONAL SEMICONDUCTOR CORP
元件分类: 稳压器
英文描述: BATTERY CHARGE CONTROLLER, PDSO8
封装: SOIC-8
文件页数: 7/9页
文件大小: 190K
代理商: LM3622AMX-4.2/NOPB
Typical Application
The low dropout linear charger shown in Figure 2 provides
constant current and constant voltage charging of 1-cell
lithium-ion battery packs. J1 and J2 are used for selecting
the operation of the low-voltage detection. The LM3622 ini-
tializes the charge cycle based on the battery voltage and
the enable status of the low-voltage detection.
When the low-voltage detection is disabled, the LM3622
starts the charge cycle constant current mode if the battery
voltage is below the controller’s regulation level. In constant
current mode, the LM3622 modulates the base drive of Q2 to
regulate a constant 100mV across the current sense resistor
R1, thus generating charge current of
I-charge = 0.1V/R1
which is equal to 0.5A in this case.
Once the battery voltage reaches the target regulation level
set by the LM3622, Q2 is controlled to regulate the voltage
across the battery, and the constant voltage mode of the
charging cycle starts. Once the charger is in the constant
voltage mode, the charger maintains a regulated voltage
across the battery and the charging current is dependent on
the state of the charge of the battery. As the cell approaches
a fully charged condition, the charge current falls to a very
low value.
When the low-voltage detection is enabled and the initial
battery voltage is below the low-voltage threshold, the
LM3622 turns Q2 off and forces the LV pin low to drive Q1 on
to start a wake up charge phase. Q1 in conjunction with R2
provides a low current source to recondition the battery.
During the wake up charge mode, Q1 is driven into satura-
tion and the wake up charge current is programmed by R2,
I-charge (wake) = (V
IN –VCE1– VD1 – LVth)/R2
where V
IN is the input supply voltage, VCE1 is the collector-
emitter on state voltage of Q1, V
D1 is the diode forward
voltage of D1, and LVth is the low-voltage threshold level set
by switch J2.
Once the battery voltage reaches the low-voltage threshold,
the LV pin transitions to a high-impedance state to end the
wake up charge phase, and the EXT pin resumes the base
drive of Q2 to start the constant current mode. The charging
cycle is completed in constant voltage mode when the bat-
tery is fully charged. Figure 3 shows the timing diagram of
the charge cycle with the low-voltage detection enabled.
D1 is a general-purpose silicon diode used for isolating the
battery from the charger circuitry that could discharge the
battery when the input source is removed. Changing D1 to a
Schottky diode will reduce the overall dropout voltage of the
circuit, but the penalty is higher leakage current associated
with Schottky diodes.
10097413
FIGURE 2. Low Dropout, Constant Current/Constant Voltage Li-ion Battery Charger
LM3622
www.national.com
7
相关PDF资料
PDF描述
LT1934ES6#PBF 0.49 A SWITCHING REGULATOR, PDSO6
LM2575-12WUTR 3.2 A SWITCHING REGULATOR, 63 kHz SWITCHING FREQ-MAX, PSSO5
LX1552CPW 1 A SWITCHING CONTROLLER, 500 kHz SWITCHING FREQ-MAX, PDSO20
LFSWGM-TTL-600 SQUARE, 0.6 MHz, WAVEFORM GENERATION, PDIP4
LM4041DIZ-1.2T&R 1-OUTPUT TWO TERM VOLTAGE REFERENCE, 1.225 V, PBCY3
相关代理商/技术参数
参数描述
LM3622AMX-8.1 制造商:未知厂家 制造商全称:未知厂家 功能描述:Battery Management
LM3622AMX-8.2 功能描述:IC CTRLR LI-ION BATT CHRG 8-SOIC RoHS:是 类别:集成电路 (IC) >> PMIC - 电池管理 系列:- 标准包装:1 系列:- 功能:充电管理 电池化学:锂离子(Li-Ion)、锂聚合物(Li-Pol) 电源电压:3.75 V ~ 6 V 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:SC-74A,SOT-753 供应商设备封装:SOT-23-5 包装:剪切带 (CT) 产品目录页面:669 (CN2011-ZH PDF) 其它名称:MCP73831T-2ACI/OTCT
LM3622AMX-8.4 功能描述:IC CTRLR LI-ION BATT CHRG 8-SOIC RoHS:是 类别:集成电路 (IC) >> PMIC - 电池管理 系列:- 标准包装:1 系列:- 功能:充电管理 电池化学:锂离子(Li-Ion)、锂聚合物(Li-Pol) 电源电压:3.75 V ~ 6 V 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:SC-74A,SOT-753 供应商设备封装:SOT-23-5 包装:剪切带 (CT) 产品目录页面:669 (CN2011-ZH PDF) 其它名称:MCP73831T-2ACI/OTCT
LM3622B-8.4 WAF 制造商:Texas Instruments 功能描述:
LM3622M-4.1 制造商:NSC 制造商全称:National Semiconductor 功能描述:Lithium-Ion Battery Charger Controller