参数资料
型号: LMC555MX
厂商: NATIONAL SEMICONDUCTOR CORP
元件分类: 模拟波形发生器
英文描述: PULSE; RECTANGULAR, 3 MHz, TIMER, PDSO8
封装: PLASTIC, SOIC-8
文件页数: 11/15页
文件大小: 425K
代理商: LMC555MX
Application Info
MONOSTABLE OPERATION
In this mode of operation, the timer functions as a one-shot
(
Figure 1). The external capacitor is initially held discharged
by internal circuitry. Upon application of a negative trigger
pulse of less than 1/3 V
S to the Trigger terminal, the flip-flop
is set which both releases the short circuit across the capaci-
tor and drives the output high.
The voltage across the capacitor then increases exponen-
tially for a period of t
H = 1.1 RAC, which is also the time that
the output stays high, at the end of which time the voltage
equals 2/3 V
S. The comparator then resets the flip-flop which
in turn discharges the capacitor and drives the output to its
low state.
Figure 2 shows the waveforms generated in this
mode of operation. Since the charge and the threshold level
of the comparator are both directly proportional to supply
voltage, the timing internal is independent of supply.
Reset overrides Trigger, which can override threshold.
Therefore the trigger pulse must be shorter than the desired
t
H. The minimum pulse width for the Trigger is 20ns, and it is
400ns for the Reset. During the timing cycle when the output
is high, the further application of a trigger pulse will not effect
the circuit so long as the trigger input is returned high at least
10s before the end of the timing interval. However the cir-
cuit can be reset during this time by the application of a
negative pulse to the reset terminal. The output will then re-
main in the low state until a trigger pulse is again applied.
When the reset function is not use, it is recommended that it
be connected to V
+ to avoid any possibility of false triggering.
Figure 3 is a nomograph for easy determination of RC values
for various time delays.
Note: In monstable operation, the trigger should be driven high before the
end of timing cycle.
ASTABLE OPERATION
If the circuit is connected as shown in
Figure 4 (Trigger and
Threshold terminals connected together) it will trigger itself
and free run as a multivibrator. The external capacitor
charges through R
A +RB and discharges through RB. Thus
the duty cycle may be precisely set by the ratio of these two
resistors.
In this mode of operation, the capacitor charges and dis-
charges between 1/3 V
S and 2/3 VS. As in the triggered
mode, the charge and discharge times, and therefore the fre-
quency are independent of the supply voltage.
Figure 5 shows the waveform generated in this mode of
operation.
DS008669-4
FIGURE 1. Monostable (One-Shot)
DS008669-10
VCC = 5V
Top Trace: Input 5V/Div.
TIME = 0.1 ms/Div.
Middle Trace: Output 5V/Div.
RA = 9.1k
Bottom Trace: Capacitor Voltage 2V/Div.
C = 0.01F
FIGURE 2. Monostable Waveforms
DS008669-11
FIGURE 3. Time Delay
DS008669-5
FIGURE 4. Astable (Variable Duty Cycle Oscillator)
www.national.com
5
相关PDF资料
PDF描述
LMC7669IN SWITCHED CAPACITOR CONVERTER, PDIP8
LMC7669MJ SWITCHED CAPACITOR CONVERTER, CDIP8
LMC835VX 1 CHANNEL(S), EQUALIZER CIRCUIT, PQCC28
LMD5D 2-OUTPUT 50 W DC-DC REG PWR SUPPLY MODULE
LMD48S 1-OUTPUT 75 W DC-DC REG PWR SUPPLY MODULE
相关代理商/技术参数
参数描述
LMC556C 制造商:Black Box Corporation 功能描述:High Density Media Converter System II Module, 10-/100-Mbps, Single-Strand, Mana
LMC556C-W1 制造商:Black Box Corporation 功能描述:1 YEAR WARRANTY FOR LMC556C
LMC556C-W3 制造商:Black Box Corporation 功能描述:3 YEAR WARRANTY FOR LMC556C
LMC557C-W3 制造商:Black Box Corporation 功能描述:3 YEAR WARRANTY FOR LMC557C
LMC558C-W1 制造商:Black Box Corporation 功能描述:1 YEAR WARRANTY FOR LMC558C