- 您现在的位置：买卖IC网 > PDF目录178072 > LOG101AIDR Precision LOGARITHMIC AND LOG RATIO AMPLIFIER PDF资料下载
参数资料
| 型号： | LOG101AIDR |
| 英文描述： | Precision LOGARITHMIC AND LOG RATIO AMPLIFIER |
| 中文描述： | 精密对数和对数比率放大器 |
| 文件页数： | 10/13页 |
| 文件大小： | 281K |
| 代理商： | LOG101AIDR |
www.ti.com
LOG101
6
SBOS242B
FIGURE 6. Current Inverter/Current Source.
10M
+25mV
100k
–2.5V
+2.5V
OPA335
100
I
1 = 2.5nA to 1mA
I
2 = 2.5nA
V
OUT
C
1G
to 2.5k
REF3025
8
3
1
56
V–
LOG101
4
3
2.5V
V+
Chopper Op Amp
GND
FIGURE 5. Current Source with Offset Compensation.
Figure 5 shows a low-level current source using a series
resistor. The low offset op-amp reduces the effect of the
LOG101’s input offset voltage.
FREQUENCY RESPONSE
The frequency response curve seen in the Typical Charac-
teristic Curves is shown for constant DC I1 and I2 with a small
signal AC current on one input.
The 3dB frequency response of the LOG101 is a function of
the magnitude of the input current levels and of the value of the
frequency compensation capacitor. See Typical Characteristic
Curve “3dB Frequency Response” for details.
The transient response of the LOG101 is different for in-
creasing and decreasing signals. This is due to the fact that
a log amp is a nonlinear gain element and has different gains
Q
B
National
LM394
I
IN
I
OUT
D
1
OPA703
D
2
Q
A
2N2905
I
REF
R
REF
2N2905
+15V
–15V
I
REF =
6V
R
REF
3.6k
6V
IN834
FIGURE 3. Temperature Compensated Current Source.
SETTING THE REFERENCE CURRENT
When the LOG101 is used to compute logarithms, either I1 or
I2 can be held constant and becomes the reference current to
which the other is compared.
VOUT is expressed as:
VOUT = (1V) log (I1/I2)(1)
IREF can be derived from an external current source (such as
shown in Figure 3), or it may be derived from a voltage
source with one or more resistors. When a single resistor is
used, the value may be large depending on IREF. If IREF is
10nA and +2.5V is used:
RREF = 2.5V/10nA = 250M
A
1
+
R
2
R
1
+5V
R
3
V
REF = 100mV
R
3 >> R2
I
REF
–
V
OS
1
FIGURE 4. T Network for Reference Current.
A voltage divider may be used to reduce the value of the
resistor, as shown in Figure 4. When using this method, one
must consider the possible errors caused by the amplifier’s
input offset voltage. The input offset voltage of amplifier A1
has a maximum value of 1.5mV, making VREF a suggested
value of 100mV.
at different levels of input signals. Smaller input currents
require greater gains to maintain full dynamic range, and will
slow the frequency response of the LOG101.
FREQUENCY COMPENSATION
Frequency compensation for the LOG101 is obtained by
connecting a capacitor between pins 3 and 8. The size of the
capacitor is a function of the input currents, as shown in the
Typical Characteristic Curves (Minimum Value of Compen-
sation Capacitor). For any given application, the smallest
value of the capacitor which may be used is determined by
the maximum value of I2 and the minimum value of I1. Larger
values of CC will make the LOG101 more stable, but will
reduce the frequency response.
In an application, highest overall bandwidth can be achieved
by detecting the signal level at VOUT, then switching in
appropriate values of compensation capacitors.
NEGATIVE INPUT CURRENTS
The LOG101 will function only with positive input currents
(conventional current flows into pins 1 and 8). In situations
where negative input currents are needed, the circuits in
Figures 6, 7, and 8 may be used.
(2)
相关PDF资料 |
PDF描述 |
|---|---|
| LOGA671-J+M | DUAL COLOR LED, ORANGE/GREEN, 2.4 mm |
| LOS4601-2 | 15, 30 and 50 Watt AC-DC Converters |
| LP02C11T203DB | SLIDE SWITCH, SPDT, LATCHED, 0.02A, 20VDC, PANEL MOUNT |
| LP02C11T203DQ | SLIDE SWITCH, SPDT, LATCHED, 6A, 28VDC, PANEL MOUNT |
| LP02C31T203DQ | SLIDE SWITCH, SPDT, LATCHED, 6A, 28VDC, PANEL MOUNT |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LOG101AIDRE4 | 功能描述:对数放大器 LOGARITHMIC AMP RoHS:否 制造商:Texas Instruments 通道数量:3 带宽:3 dB 共模抑制比（最小值）: 输入补偿电压:+/- 7 mV 输入电压范围（最大值）:5.5 V 工作电源电压:4.5 V to 5.5 V 电源电流:+/- 15 mA 工作温度范围:- 40 C to +85 C 安装风格:SMD/SMT 封装 / 箱体:VQFN-16 封装:Reel |
| LOG102 | 制造商:TI 制造商全称:Texas Instruments 功能描述:LOGARITHMIC AND LOG RATIO AMPLIFIER |
| LOG102AID | 功能描述:对数放大器 Logarithmic and Log Ratio Amp RoHS:否 制造商:Texas Instruments 通道数量:3 带宽:3 dB 共模抑制比（最小值）: 输入补偿电压:+/- 7 mV 输入电压范围（最大值）:5.5 V 工作电源电压:4.5 V to 5.5 V 电源电流:+/- 15 mA 工作温度范围:- 40 C to +85 C 安装风格:SMD/SMT 封装 / 箱体:VQFN-16 封装:Reel |
| LOG102AID | 制造商:Texas Instruments 功能描述:IC AMP LOG SMD SOIC14 102 |
| LOG102AIDG4 | 功能描述:对数放大器 Logarithmic and Log Ratio Amp RoHS:否 制造商:Texas Instruments 通道数量:3 带宽:3 dB 共模抑制比（最小值）: 输入补偿电压:+/- 7 mV 输入电压范围（最大值）:5.5 V 工作电源电压:4.5 V to 5.5 V 电源电流:+/- 15 mA 工作温度范围:- 40 C to +85 C 安装风格:SMD/SMT 封装 / 箱体:VQFN-16 封装:Reel |
发布紧急采购，3分钟左右您将得到回复。