- 您现在的位置：买卖IC网 > PDF目录79711 > LP3906SQJXXI (NATIONAL SEMICONDUCTOR CORP) 2 A DUAL SWITCHING CONTROLLER, 2000 kHz SWITCHING FREQ-MAX, QCC24 PDF资料下载
参数资料
| 型号： | LP3906SQJXXI |
| 厂商： | NATIONAL SEMICONDUCTOR CORP |
| 元件分类： | 稳压器 |
| 英文描述： | 2 A DUAL SWITCHING CONTROLLER, 2000 kHz SWITCHING FREQ-MAX, QCC24 |
| 封装： | 5 X 4 MM, 0.80 MM HEIGHT, LLP-24 |
| 文件页数： | 29/40页 |
| 文件大小： | 4197K |
| 代理商： | LP3906SQJXXI |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页当前第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页
MODE BOUNCE
PFM-PWM transition at low load current.
To improve efficiency at lower load currents LP3906 buck
converters employ an automatically invoked PFM mode for
the low load operation. The PFM mode operates with a much
lower value quiescent current (I
Q) than the PWM mode of op-
eration that is used in the higher load currents.
As shown in the datasheet section about SW operation, there
is a DC voltage difference between the two modes of opera-
tion, with Vout PFM being typically 1.2% higher than Vout
PWM. So there is a DC voltage level transition and some as-
sociated dynamic perturbation at the mode transition point.
The transition between the two modes of operation has an
associated hysterisis in the transition current value, That is,
the transition point for increasing current (PFM to PWM) is at
a higher value that the decreasing current (PWM to PFM).
This hysterisis is to ensure that in the event that the load cur-
rent values equals the PFM PWM transition value, the device
will not make multiple transitions between modes; this re-
duces the noise at this load by eliminating multiple transitions
between modes (also known as mode bounce).
Under some conditions of high Vin and Low Vout the hystersis
value is reduced and some amount of mode bounce can oc-
cur. Under these conditions, the regulator still maintains DC
regulation, however the output ripple is more pronounced.
Refer to the attached Vout vs Vin chart below that shows the
operational area that may exhibit this increased output ripple.
If the application is expected to be operated in the area of
concern AND have a static load current of the transition cur-
rent value, the user can avoid the possible noise increase by
invoking the components’ “Force PWM mode”.
LP3906 Buck Converter
V
OUT vs VIN Operating Range
during PFM-PWM-PPM Transition
20197865
35
www.national.com
LP3906
相关PDF资料 |
PDF描述 |
|---|---|
| LTC3560ES6#PBF | 2.1 A SWITCHING REGULATOR, 2700 kHz SWITCHING FREQ-MAX, PDSO6 |
| LES10A48-5V0J | 1-OUTPUT 50 W DC-DC REG PWR SUPPLY MODULE |
| LS4001-7EPDD | 1-OUTPUT 100 W AC-DC PWR FACTOR CORR MODULE |
| LS4001-7ERV3 | 1-OUTPUT 100 W AC-DC PWR FACTOR CORR MODULE |
| LS4001-7PD1T | 1-OUTPUT 100 W AC-DC PWR FACTOR CORR MODULE |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LP3906SQ-JXXI/NOPB | 功能描述:其他电源管理 DUAL 1.5A BUCK /DUAL 300MA LDO RoHS:否 制造商:Texas Instruments 输出电压范围: 输出电流:4 mA 输入电压范围:3 V to 3.6 V 输入电流: 功率耗散: 工作温度范围:- 40 C to + 110 C 安装风格:SMD/SMT 封装 / 箱体:VQFN-48 封装:Reel |
| LP3906SQ-JXXI/NOPB | 制造商:Texas Instruments 功能描述:IC DUAL STEP-DOWN DC/DC LINEAR REG LLP24 |
| LP3906SQ-JXXIEV | 功能描述:BOARD EVALUATION LP3906SQ-JXXI RoHS:否 类别:编程器，开发系统 >> 评估板 - DC/DC 与 AC/DC（离线）SMPS 系列:PowerWise® 产品培训模块:Obsolescence Mitigation Program 标准包装:1 系列:True Shutdown™ 主要目的:DC/DC，步升 输出及类型:1，非隔离 功率 - 输出:- 输出电压:- 电流 - 输出:1A 输入电压:2.5 V ~ 5.5 V 稳压器拓扑结构:升压 频率 - 开关:3MHz 板类型:完全填充 已供物品:板 已用 IC / 零件:MAX8969 |
| LP3906SQ-JXXIEV/NOPB | 功能描述:低压差稳压器 - LDO LP3906 Eval Brd RoHS:否 制造商:Texas Instruments 最大输入电压:36 V 输出电压:1.4 V to 20.5 V 回动电压（最大值）:307 mV 输出电流:1 A 负载调节:0.3 % 输出端数量: 输出类型:Fixed 最大工作温度:+ 125 C 安装风格:SMD/SMT 封装 / 箱体:VQFN-20 |
| LP3906SQ-PPXP | 制造商:Texas Instruments 功能描述:Power Management Unit 24-Pin LLP EP T/R |
发布紧急采购，3分钟左右您将得到回复。