参数资料
型号: LPC11C12FBD48
厂商: NXP Semiconductors N.V.
元件分类: 32位微控制器
英文描述: Cortex-M0 with 16 kB flash, 8 kB SRAM, CAN and CANopen drivers on-chip
中文描述: Cortex-M0,16KB闪存,8 KB静态随机存储器,CAN和CANopen片上驱动
封装: LPC11C12FBD48/301<SOT313-2 (LQFP48)|<<http://www.nxp.com/packages/SOT313-2.html<1<Always Pb-free,;
文件页数: 21/62页
文件大小: 487K
代理商: LPC11C12FBD48
LPC11CX2_CX4
All information provided in this document is subject to legal disclaimers.
NXP B.V. 2011. All rights reserved.
Product data sheet
Rev. 3 — 27 June 2011
21 of 62
NXP Semiconductors
LPC11Cx2/Cx4
32-bit ARM Cortex-M0 microcontroller
7.11.2.6
Time-out function
A ‘TXD dominant time-out’ timer is started when the CAN_TXD signal of the C_CAN
controller is set LOW. If the LOW state on the CAN_TXD signal persists for longer than
t
to(dom)TXD
, the transmitter is disabled, releasing the bus lines to recessive state. This
function prevents a hardware and/or software application failure from driving the bus lines
to a permanent dominant state (blocking all network communications). The TXD dominant
time-out timer is reset when the CAN_TXD signal is set HIGH. The TXD dominant
time-out time also defines the minimum possible bit rate of 40 kbit/s.
7.12 10-bit ADC
The LPC11Cx2/Cx4 contains one ADC. The ADC is a single 10-bit successive
approximation ADC with eight channels.
7.12.1
Features
10-bit successive approximation ADC.
Input multiplexing among 8 pins.
Power-down mode.
Measurement range 0 V to V
DD
.
10-bit conversion time
2.44
s (up to 400 kSamples/s).
Burst conversion mode for single or multiple inputs.
Optional conversion on transition of input pin or timer match signal.
Individual result registers for each ADC channel to reduce interrupt overhead.
7.13 General purpose external event counter/timers
The LPC11Cx2/Cx4 includes two 32-bit counter/timers and two 16-bit counter/timers. The
counter/timer is designed to count cycles of the system derived clock. It can optionally
generate interrupts or perform other actions at specified timer values, based on four
match registers. Each counter/timer also includes one capture input to trap the timer value
when an input signal transitions, optionally generating an interrupt.
7.13.1
Features
A 32-bit/16-bit timer/counter with a programmable 32-bit/16-bit prescaler.
Counter or timer operation.
One capture channel per timer, that can take a snapshot of the timer value when an
input signal transitions. A capture event may also generate an interrupt.
Four match registers per timer that allow:
Continuous operation with optional interrupt generation on match.
Stop timer on match with optional interrupt generation.
Reset timer on match with optional interrupt generation.
Up to four external outputs corresponding to match registers, with the following
capabilities:
Set LOW on match.
Set HIGH on match.
相关PDF资料
PDF描述
LPC11D14FBD100 32-bit ARM Cortex-M0 microcontroller; 32 kB flash and 8 kB SRAM; 4 x 40 segment LCD driver
LPC11U12FBD48 32-bit ARM Cortex-M0 microcontroller; up to 16 kB flash; 6 kB SRAM; USB device; USART; 2 SSPs
LPCXpresso
LPD-1 Phase Detectors 1000mV DC output , + 7dBmRF
LPDA-8003 LPDA-8003 Log Periodic Dipole Antenna
相关代理商/技术参数
参数描述
LPC11C12FBD48/301 功能描述:ARM微控制器 - MCU 32-bit Cortex M0 16KB 8K RAM CAN RoHS:否 制造商:STMicroelectronics 核心:ARM Cortex M4F 处理器系列:STM32F373xx 数据总线宽度:32 bit 最大时钟频率:72 MHz 程序存储器大小:256 KB 数据 RAM 大小:32 KB 片上 ADC:Yes 工作电源电压:1.65 V to 3.6 V, 2 V to 3.6 V, 2.2 V to 3.6 V 工作温度范围:- 40 C to + 85 C 封装 / 箱体:LQFP-48 安装风格:SMD/SMT
LPC11C12FBD48/301, 功能描述:ARM微控制器 - MCU 32b 16K Flash 40I/O RoHS:否 制造商:STMicroelectronics 核心:ARM Cortex M4F 处理器系列:STM32F373xx 数据总线宽度:32 bit 最大时钟频率:72 MHz 程序存储器大小:256 KB 数据 RAM 大小:32 KB 片上 ADC:Yes 工作电源电压:1.65 V to 3.6 V, 2 V to 3.6 V, 2.2 V to 3.6 V 工作温度范围:- 40 C to + 85 C 封装 / 箱体:LQFP-48 安装风格:SMD/SMT
LPC11C12FBD48/301,15 制造商:NXP Semiconductors 功能描述:Bulk
LPC11C12FBD48-301 制造商:PHILIPS 制造商全称:NXP Semiconductors 功能描述:32-bit ARM Cortex-M0 microcontroller; 16/32 kB flash, 8 kB SRAM; C_CAN
LPC11C14FB301 制造商:PHILIPS 制造商全称:NXP Semiconductors 功能描述:32-bit ARM Cortex-M0 microcontroller; 16/32 kB flash, 8 kB SRAM C_CAN