- 您现在的位置：买卖IC网 > Datasheet目录868 > LSM2-T/30-D12R-C (Murata Power Solutions Inc)CONV DC/DC 125W 30A 12V SMD Datasheet资料下载
参数资料
| 型号： | LSM2-T/30-D12R-C |
| 厂商： | Murata Power Solutions Inc |
| 文件页数： | 6/12页 |
| 文件大小： | 0K |
| 描述： | CONV DC/DC 125W 30A 12V SMD |
| 标准包装： | 1 |
| 系列： | LSM2 |
| 类型： | 非隔离（POL） |
| 输出数： | 1 |
| 电压 - 输入（最小）： | 8.3V |
| 电压 - 输入（最大）： | 13.2V |
| Voltage - Output 1： | 0.8 ~ 5 V |
| 电流 - 输出（最大）： | 30A |
| 电源（瓦） - 制造商系列： | 125W |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 8-DIP SMD 模块 |
| 尺寸/尺寸： | 1.30" L x 0.53" W x 0.34" H（33.0mm x 13.5mm x 8.6mm） |
| 包装： | 标准包装 |
| 工作温度： | -40°C ~ 85°C |
| 效率： | 94% |
| 电源（瓦特）- 最大： | 125W |
| 其它名称： | 811-1793-6 |
LSM2-T/30-D12 Series
DOSA-SMT, 30A POL DC/DC Converters
Speci?cation Notes continued:
(7) If Sense is connected remotely at the load, up to 0.5 Volts difference is allowed between the
Sense and +V OUT pins to compensate for ohmic voltage drop in the power lines. A larger volt-
age drop may cause the converter to exceed maximum power dissipation.
(8) Output noise may be further reduced by adding an external ?lter. See I/O Filtering and Noise Reduc-
tion.
(9) All models are fully operational and meet published speci?cations, including “cold start” at –40° C.
(10) Regulation speci?cations describe the deviation as the line input voltage or output load current
Resistor Trim Equation
1200
R TRIM (in Ohms) = --------------------- -100
V OUT – 0.8
is varied from a nominal midpoint value to either extreme.
(11) Other input or output voltage ranges will be reviewed under scheduled quantity special order.
(12) Maximum continuous power requires that all on-board components not exceed +128 ° C pack-
age temperature.
(13) Do not exceed maximum power speci?cations when adjusting the output trim.
(14) The “R” option includes extra ground pads. These pads offer two important features. In addition
The ?xed trim resistors to set the output voltage are:
V OUT 0.8V. 1.0V. 1.2V.
Rtrim (Ohms) Open 5.90 KΩ 2.90 KΩ
1.5V.
1.614
KΩ
1.8V.
1.10 KΩ
to carrying extra current, they also help dissipate additional heat. MPS strongly recommends
soldering the “R” pads to a thick ground plane with sizable area. The Operating Temperature
speci?cation listed above assumes that these additional ground pads are connected to
a substantial ground plane below the converter ( at least several square inches).
V OUT
Rtrim (Ohms)
2.0V.
0.90 KΩ
2.5V.
605 Ω
3.3V.
380 Ω
5.0V.
185.71
Ω
(15) The maximum output capacitive loads depend on the the Equivalent Series Resistance (ESR)
of the external output capacitor. Larger caps will reduce output noise but may slow transient
response.
(16) Do not use Pre-bias startup and sequencing together. If you do not use the track function, leave
the seq/trk pin open.
(17) After short circuit shutdown, if the load is partially removed such that the load still exceeds the
overcurrent (OC) detection, the converter will remain in hiccup restart mode.
(18) Output current limiting is disabled at start up to avoid overcurrent shutdown while charging
external bypass capacitors.
Output Adjustments
The LSM2-T/30-D12 series includes a special output voltage trimming fea-
ture which is fully compatible with competitive units. The output voltage may
be varied using a single trim resistor from the Trim Input to Power Common.
Use a precision, low-tempco resistor ( ± 100 ppm/ ο C) mounted close to
the converter with short leads. Be aware that the voltage accuracy is ± 1.5%
(typical) therefore adjust this resistance to achieve your desired output.
Voltage Reference,
Figure 2. Voltage Trim Connections
Voltage Trim
The LSM2 Series may also be trimmed using an external low-noise voltage
applied between the Trim input and Output Common. Be aware that the inter-
nal “load” impedance looking into Trim pin is below 1000 Ohms and includes
factors from the output voltage. Therefore, use a low impedance source
resistance in your external voltage reference.
The ?xed trim voltages to set the output voltage are:
V OUT (typ.)
Vtrim (Volts)
0.80V.
Open
1.0V.
0.731V.
1.2V.
0.719V.
1.5V.
0.7V.
1.8V.
0.682V
Figure 1. Trim Resistor Connections
V OUT (typ.)
Vtrim (Volts)
2.0 V.
0.669V.
2.5V.
0.638V.
3.3V.
0.589V.
5.0V.
0.484V.
Soldering Guidelines
Vtrim = 0.7434 – [(((Vout – 0.7434) ÷ 1620) – 0.000035) x 100] where Vout
= desired voltage
Murata Power Solutions recommends the speci?cations below when installing these converters. These speci?cations vary depending on the solder type. Exceeding these speci?ca-
tions may cause damage to the product. Your production environment may differ therefore please thoroughly review these guidelines with your process engineers.
Re?ow Solder Operations for surface-mount products (SMT)
For Sn/Ag/Cu based solders:
For Sn/Pb based solders:
Preheat Temperature
Time over Liquidus
Maximum Peak Temperature
Cooling Rate
Less than 1 oC. per second
45 to 75 seconds
260 oC.
Less than 3 oC. per second
Preheat Temperature
Time over Liquidus
Maximum Peak Temperature
Cooling Rate
Less than 1 oC. per second
60 to 75 seconds
235 oC.
Less than 3 oC. per second
www.murata-ps.com/support
MDC_LSM2_T30_D12 Series.D01 Δ Page 6 of 12
相关PDF资料 |
PDF描述 |
|---|---|
| LSN-T/10-D12N-C | CONV DC/DC 10A 0.75-5.25V SIP |
| LSN-T/16-D12-C | CONV DC/DC 80W 16A 0.75-5V SIP |
| LSN-T/16-W3-C | CONV DC/DC 16A .75-3.3V SIP |
| LSN2-T/16-W3N-C | CONV DC/DC 52.8W 16A.75-3.3V SIP |
| LSN2-T/30-D12-C | CONV DC/DC 150W 30A 0.8-5V SIP |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LSM2-T30-D12R-C | 制造商:MURATA 制造商全称:Murata Manufacturing Co., Ltd. 功能描述:DOSA-SMT, 30A POL DC/DC Converters |
| LSM2-T-30-D12R-C-CIS | 制造商:MURATA 制造商全称:Murata Manufacturing Co., Ltd. 功能描述:DOSA-SMT, 30A POL DC/DC Converters |
| LSM2T6W3C | 制造商:MURATA 功能描述:Pb Free |
| LSM2U | 功能描述:限位开关 LIMIT SWITCH RoHS:否 制造商:Honeywell 触点形式:SPDT 执行器:Non-Contact 电流额定值:30 mA 电压额定值 AC: 电压额定值 DC:3.6 V 工作力:10 g IP 等级:IP 67 NEMA 额定值:1, 4, 12, 13 端接类型:4-Pin M12 Connector 安装:SMD/SMT |
| LSM-3.3/10-D12 | 功能描述:DC/DC转换器 33W 12V to 3.3V 10A SMT Package RoHS:否 制造商:Murata 产品: 输出功率: 输入电压范围:3.6 V to 5.5 V 输入电压（标称）: 输出端数量:1 输出电压（通道 1）:3.3 V 输出电流（通道 1）:600 mA 输出电压（通道 2）: 输出电流（通道 2）: 安装风格:SMD/SMT 封装 / 箱体尺寸: |
发布紧急采购，3分钟左右您将得到回复。