参数资料
型号: LSN-1/16-W3J
厂商: CD TECHNOLOGIES INC
元件分类: 电源模块
英文描述: 1-OUTPUT DC-DC REG PWR SUPPLY MODULE
文件页数: 3/8页
文件大小: 504K
代理商: LSN-1/16-W3J
LSN-16A W3 Models
N O N - I S O L A T E D , W I D E I N P U T D C / D C C O N V E R T E R S
3
Performance/Functional Specications
Typical @ TA = +25°C under nominal line voltage and full-load conditions unless noted.
All models are tested/specied with external 22F tantalum input and output capacitors.
These capacitors are necessary to accommodate our test equipment and may not be
required to achieve specied performance in your applications. All models are stable and
regulate within spec under no-load conditions.
See Technical Notes and Performance Curves for details.
The On/Off Control is designed to be driven with open-collector logic or the appli-
cation of appropriate voltages (referenced to Common, pin 3). Applying a voltage to On/Off
Control when no input voltage is applied to the converter may cause permanent damage.
Output noise may be further reduced with the installation of additional external output
ltering. See I/O Filtering and Noise Reduction.
MTBF’s are calculated using Telcordia SR-332(Bellcore), ground xed, TA = +25°C, full
power, natural convection, +67°C pcb temperature.
Input Ripple Current is tested/specied over a 5-20MHz bandwidth with an external
2 x 100F input capacitor and a simulated source impedance of 1000F and 1H. See I/O
Filtering, Input Ripple Current, and Output Noise for details.
Setting accuracy for LSN-T/16-W3 is ±2%.
Input voltage must be 4.5V minimum for 3.3V output.
T E C H N I C A L
N O T E S
Input Voltage:
Continuous or transient
6 Volts (0.75, 1, 1.2, 1.5, 1.8, 2, 2.5 VOUT)
7 Volts (3.3VOUT and "T" models)
On/Off Control (Pin 1)
+VIN
Input Reverse-Polarity Protection
None
Output Overvoltage Protection
None
Output Current
Current limited. Devices can
withstand sustained output short
circuits without damage.
Storage Temperature
–40 to +125°C
Lead Temperature
See Reow Solder Prole
These are stress ratings. Exposure of devices to any of these conditions may adversely
affect long-term reliability. Proper operation under conditions other than those listed in the
Performance/Functional Specications Table is not implied.
Absolute Maximum Ratings
I/O Filtering and Noise Reduction
All models in the LSN W3 Series are tested and specied with external
22F tantalum input and output capacitors. These capacitors are necessary
to accommodate our test equipment and may not be required to achieve
desired performance in your application. The LSN's are designed with high-
quality, high-performance internal I/O caps, and will operate within spec in
most applications with no additional external components.
In particular, the LSN's input capacitors are specied for low ESR and are
fully rated to handle the units' input ripple currents. Similarly, the internal
output capacitors are specied for low ESR and full-range frequency
response.
In critical applications, input/output ripple/noise may be further reduced using
ltering techniques, the simplest being the installation of external I/O caps.
External input capacitors serve primarily as energy-storage devices. They
minimize high-frequency variations in input voltage (usually caused by IR
drops in conductors leading to the DC/DC) as the switching converter draws
pulses of current. Input capacitors should be selected for bulk capacitance (at
appropriate frequencies), low ESR, and high rms-ripple-current ratings. The
switching nature of modern DC/DC's requires that the dc input voltage
source have low ac impedance at the frequencies of interest. Highly inductive
source impedances can greatly affect system stability.Your specic system
conguration may necessitate additional considerations.
Input
Input Voltage Range
3-5.5 Volts (5V nominal)
Input Current:
Normal Operating Conditions
See Ordering Guide
Inrush Transient
0.02A2 sec
Standby/Off Mode
8mA
Output Short-Circuit Condition
60-110mA average (model dependent)
Input Reected Ripple Current 10-20mAp-p, model dependent
Input Filter Type
Capacitive
Overvoltage Protection
None
Reverse-Polarity Protection
None
Undervoltage Shutdown
None
On/Off Control
On = open or low (<0.4V max.)
Off = high (>2.5V to VIN max.), 1mA
Output
VOUT Accuracy (50% load)
±1.5%
Temperature Coefcient
±0.02%/°C
Minimum Loading
No load
Maximum Capacitive Load
5000F (electrolytic),
2000F (0.02
ESR, OSCON)
VOUT Trim Range
±10%
Ripple/Noise (20MHz BW)
See Ordering Guide
Total Accuracy
3% over line/load/temperature
Efciency
See Ordering Guide
Overcurrent Detection and Short-Circuit Protection:
Current-Limiting Detection Point
24 Amps
Short-Circuit Detection Point
98% of VOUT set
SC Protection Technique
Hiccup with auto recovery
Short-Circuit Current
600mA average
Dynamic Characteristics
Transient Response (50% load step)
30-70sec to ±2% of nal value
(model dependent)
Start-Up Time:
VIN to VOUT and On/Off to VOUT
7msec
Switching Frequency
300 ±50kHz
Environmental
Calculated MTBF
TBD
Operating Temperature: (Ambient)
Without Derating (Natural convection) –40 to +63/71°C (model dependent,
see Derating Curves)
With Derating
See Derating Curves
PC-Board Temperature
+100°C maximum
Thermal Shutdown
+115°C (110 to 125°C)
Physical
Dimensions
1.3" x 0.53" x 0.34" (33.03 x 13.46 x 8.64)
Pin Dimensions/Material
0.112"x 0.062" (2.84 x 1.57mm) rectangular
copper with gold plate over nickel underplate
Weight
0.28 ounces (7.8g)
Flamability Rating
UL94V-0
相关PDF资料
PDF描述
LSN-T/10-D12-C 1-OUTPUT 51 W DC-DC REG PWR SUPPLY MODULE
LSN-T/10-D12NJ-C 1-OUTPUT 51 W DC-DC REG PWR SUPPLY MODULE
LSN-T/10-D12H-C 1-OUTPUT 51 W DC-DC REG PWR SUPPLY MODULE
LSN-T/10-D12J-C 1-OUTPUT 51 W DC-DC REG PWR SUPPLY MODULE
LSN-T/10-D12NH-C 1-OUTPUT 51 W DC-DC REG PWR SUPPLY MODULE
相关代理商/技术参数
参数描述
LSN1210D5 制造商:Datel 功能描述:
LSN1210D5C 制造商:Datel 功能描述:
LSN1510D12J 制造商:Datel 功能描述:
LSN1510D5 制造商:Datel 功能描述:
LSN16A-D12 制造商:MURATA 制造商全称:Murata Manufacturing Co., Ltd. 功能描述:Single Output, Non-Isolated, 12VIN, 0.75-5VOUT 16 Amp in DC/DCs SIP Packages