- 您现在的位置：买卖IC网 > PDF目录44975 > LSN-T/10-D12J-C (MURATA POWER SOLUTIONS INC) 1-OUTPUT 51 W DC-DC REG PWR SUPPLY MODULE PDF资料下载
参数资料
| 型号： | LSN-T/10-D12J-C |
| 厂商： | MURATA POWER SOLUTIONS INC |
| 元件分类： | 电源模块 |
| 英文描述： | 1-OUTPUT 51 W DC-DC REG PWR SUPPLY MODULE |
| 封装： | ROHS COMPLIANT, SIP-10/11 |
| 文件页数： | 9/12页 |
| 文件大小： | 465K |
| 代理商： | LSN-T/10-D12J-C |
LSN-T/10-D12
Single Adjustable Output, Non-isolated, 12Vin, 10A, SIP, DC/DC Converters
Technical enquiries email: sales@murata-ps.com, tel: +1 508 339 3000
www.murata-ps.com
LSN-T10-D12.B01 Page 6 of 12
D12 Models Voltage Trim Equation:
VTRIM (in Volts) = 0.7 –(0.0667 x (VO – 0.7525))
where VO is the desired output voltage.
The D12 xed trim voltages to set the output voltage are:
VOUT 0.7525V
1.0V
1.2V
1.5V
1.8V
2V
2.5V
3.3V
5V
RTRIM
(k
Ω)
Open
41.424 22.46
13.05
9.024
7.417
5.009
3.122
1.472
RTRIM (
Ω) = _____________ –1000
VO – 0.7525
10500
D12 Models Resistor Trim Equation:
Pre-Biased Startup
Newer systems with multiple power voltages have an additional problem
besides startup sequencing. Some sections have power already partially ap-
plied (possibly because of earlier power sequencing) or have leakage power
present so that the DC/DC converter must power up into an existing voltage.
This power may either be stored in an external bypass capacitor or supplied
by an active source.
This “pre-biased” condition can also occur with some types of program-
mable logic or because of blocking diode leakage or small currents passed
through forward biased ESD diodes. Conventional DC/DC’s may fail to start up
correctly if there is output voltage already present. And some external circuits
are adversely affected when the low side MOSFET in a synchronous rectier
converter sinks current at start up.
The LSN2 series includes a pre-bias startup mode to prevent these initializa-
tion problems. Essentially, the converter acts as a simple buck converter until
the output reaches its set point voltage at which time it converts to a synchro-
nous rectier design. This feature is variously called “monotonic” because
the voltage does not decay (from low side MOSFET shorting) or produce a
negative transient once the input power is applied and the startup sequence
begins.
Output Adjustments
The LSN-T/10-D12J includes an output adjustment and trimming function
which is fully compatible with competitive units. The output voltage may be
varied using a single trim resistor from the Trim input to Power Common or an
external DC trim voltage applied between the Trim input and Power Common.
For resistor trim adjustments, be sure to use a precision low-tempco resistor
(±100 ppm/°C) mounted close to the converter with short leads. Since the
output accuracy is ±2% (typical), you may need to vary this resistance slightly.
For adjustments using an external voltage reference, the equivalent input im-
pedance looking in to the Trim input is approximately 5,000 Ohms. Therefore
you may have to compensate for this in the source resistance of your external
reference. Although ltered internally, the Trim input is sensitive and therefore
susceptible to noise pickup with longer leads. Consider adding a small bypass
capacitor, 0.1μF or larger mounted adjacent to the converter between the Trim
and Power Common if there is noise in the application.
The Trim input voltage range is offset against the 0.7 Volt reference of the
PWM. Also note that the Trim input is inverting (lower trim voltage produces
higher output voltage and vice versa). Do not exceed the voltage range or
maximum power rating.
where VO is the desired output voltage.
VOUT
0.7525V
1.0V
1.2V
1.5V
1.8V
2V
2.5V
3.3V
5V
VTRIM
(V)
Open
0.6835 0.670
0.650
0.630
0.617
0.583
0.530 0.4166
Trim Connections
相关PDF资料 |
PDF描述 |
|---|---|
| LSN-T/10-D12NH-C | 1-OUTPUT 51 W DC-DC REG PWR SUPPLY MODULE |
| LSN-T/16-W3J-C | 1-OUTPUT DC-DC REG PWR SUPPLY MODULE |
| LSN-0.75/16-W3J-C | 1-OUTPUT DC-DC REG PWR SUPPLY MODULE |
| LSN-1.5/16-W3H-C | 1-OUTPUT DC-DC REG PWR SUPPLY MODULE |
| LSN-1.2/16-W3H-C | 1-OUTPUT DC-DC REG PWR SUPPLY MODULE |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LSNUT-T6X2-F | 制造商:NANOTEC 功能描述:NUT T6X2 制造商:NANOTEC 功能描述:NUT, T6X2 |
| LS-NVP/B-W1 | 制造商:Black Box Corporation 功能描述:1 year warranty for LS-NVP/B |
| LS-NVP/B-W3 | 制造商:Black Box Corporation 功能描述:3 year warranty for LS-NVP/B |
| LSO(GOLD) | 制造商:PRECIC 功能描述: |
| LSOU | 功能描述:熔丝座 125V/15A Box Cover Units RoHS:否 制造商:Littelfuse 产品: 电流额定值:30 A 电压额定值:1000 VDC 极数:1 系列: 安装风格:DIN Rail 端接类型: 轴类型: 工作温度范围: |
发布紧急采购，3分钟左右您将得到回复。