- 您现在的位置：买卖IC网 > PDF目录80246 > LSN2-T/10-W3G-C (MURATA POWER SOLUTIONS INC) 1-OUTPUT 33 W DC-DC REG PWR SUPPLY MODULE PDF资料下载
参数资料
| 型号： | LSN2-T/10-W3G-C |
| 厂商： | MURATA POWER SOLUTIONS INC |
| 元件分类： | 电源模块 |
| 英文描述： | 1-OUTPUT 33 W DC-DC REG PWR SUPPLY MODULE |
| 封装： | ROHS COMPLIANT, SIP-12 |
| 文件页数： | 10/15页 |
| 文件大小： | 302K |
| 代理商： | LSN2-T/10-W3G-C |
LSN2 Series
Non-isolated, DOSA-SIP, 6/10/16A
Selectable-Output DC/DC Converters
www.murata-ps.com
email: sales@murata-ps.com
25 Jun 2010
MDC_LSN2.B07Δ Page 4 of 15
(1)
All models are tested and specied with external 1 || 10μF ceramic/tantalum output capacitors and
a 22μF external input capacitor. All capacitors are low ESR types. These capacitors are necessary
to accommodate our test equipment and may not be required to achieve specied performance in
your applications. All models are stable and regulate within spec under no-load conditions.
General conditions for Specications are +25°C, VIN = nominal, VOUT = nominal, full load. “Nominal”
output voltage is +5V for D12 models and +3.3V for W3 models.
(2)
Input Back Ripple Current is tested and specied over a 5-20MHz bandwidth. Input ltering is
CIN = 2 x 100μF tantalum, CBUS = 1000μF electrolytic, LBUS = 1μH.
(3)
Note that Maximum Power Derating curves indicate an average current at nominal input voltage. At
higher temperatures and/or lower airow, the DC/DC converter will tolerate brief full current outputs
if the total RMS current over time does not exceed the derating curve.
(4)
Mean Time Before Failure is calculated using the Telcordia (Belcore) SR-332 Method 1, Case 3,
ground xed conditions, TPCBOARD = +25°C, full output load, natural air convection.
(5)
The On/Off Control may be driven with external logic or by applying appropriate external voltages
which are referenced to –Input Common. The On/Off Control Input should use either an open
collector/open drain transistor or logic gate which does not exceed +VIN. A 68K
: external pullup
resistor to +VIN will cause the “ON” state for negative logic models.
(6)
Short circuit shutdown begins when the output voltage under increasing load degrades approxi-
mately 2% from the selected setting.
(7)
If Sense is connected remotely at the load, up to 0.5 Volts difference is allowed between the Sense
and +VOUT pins to compensate for ohmic voltage drop in the power lines. A larger voltage drop may
cause the converter to exceed maximum power dissipation.
(8)
Output noise may be further reduced by adding an external lter. See I/O Filtering and Noise Reduction.
(9)
All models are fully operational and meet published specications, including “cold start” at –40°C.
VOUT is nominal.
(10)
Regulation specications describe the deviation as the line input voltage or output load current is
varied from a nominal midpoint value to either extreme.
(11)
Other input or output voltage ranges are available under scheduled quantity special order.
(12)
Maximum PC board temperature is measured with the sensor in the center.
(13)
Do not exceed maximum power specications when adjusting the output trim.
(14)
When Sequencing is not used, the Power Good output is TRUE at any time the output is within
approximately ±10% of the voltage set point. Power Good basically indicates if the converter is in
regulation. Power Good detects Over Temperature if the PWM has shut down due to OT. Power
Good does not directly detect Over Current.
If Sequencing is in progress, Power Good will falsely indicate TRUE (valid) before the output
reaches its setpoint. Ignore Power Good if Sequencing is in transition.
(15)
The maximum output capacitive loads depend on the the Equivalent Series Resistance (ESR) of
the external output capacitor.
(16)
Do not use Pre-bias startup and sequencing together. See Technical Notes below.
(17)
After short circuit shutdown, if the load is partially removed such that the load still exceeds the
overcurrent (OC) detection, the converter will remain in hiccup restart mode.
(18)
For best noise performance, leave the Track/Sequence pin OPEN when not used.
PERFORMANCE/FUNCTIONAL SPECIFICATION NOTES
ABSOLUTE MAXIMUM RATINGS
Input Voltage (Continuous or transient)
W3 models
+7 Volts
12V models
+15 Volts
On/Off Control
–0.3V min. to +VIN max.
Input Reverse Polarity Protection
See Fuse section
Output Current (7)
Current-limited. Devices can
withstand sustained short circuit
without damage.
Storage Temperature
–55 to +125°C
Lead Temperature
See soldering guidelines
These are stress ratings. Exposure of devices to greater than any of these conditions may
adversely affect long-term reliability. Proper operation under conditions other than those listed in
the Performance/Functional Specications Table is not implied.
Soldering Guidelines
Murata Power Solutions recommends the specications below when installing these
converters. These specications vary depending on the solder type. Exceeding these
specications may cause damage to the product. Be cautious when there is high atmo-
spheric humidity. We strongly recommend a mild pre-bake (100° C. for 30 minutes). Your
production environment may differ; therefore please thoroughly review these guidelines
with your process engineers.
Wave Solder Operations for through-hole mounted products (THMT)
For Sn/Ag/Cu based solders:
Maximum Preheat Temperature
115° C.
Maximum Pot Temperature
270° C.
Maximum Solder Dwell Time
7 seconds
For Sn/Pb based solders:
Maximum Preheat Temperature
105° C.
Maximum Pot Temperature
250° C.
Maximum Solder Dwell Time
6 seconds
相关PDF资料 |
PDF描述 |
|---|---|
| LES50A48-1V2AJ | 1-OUTPUT 60 W DC-DC REG PWR SUPPLY MODULE |
| LSN-1.8/10-D3 | 1-OUTPUT DC-DC REG PWR SUPPLY MODULE |
| LQD30A48-3V3-1V8RA | 2-OUTPUT 76.5 W DC-DC REG PWR SUPPLY MODULE |
| LM3705XDMMX-463/NOPB | 2-CHANNEL POWER SUPPLY SUPPORT CKT, PDSO10 |
| LM3705XDBP-463/NOPB | 2-CHANNEL POWER SUPPLY SUPPORT CKT, PBGA9 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LSN2-T30-D12 | 制造商:MURATA 制造商全称:Murata Manufacturing Co., Ltd. 功能描述:DOSA-SIP, 30A POL DC/DC Converters |
| LSN2-T30-D12-C | 制造商:MURATA 制造商全称:Murata Manufacturing Co., Ltd. 功能描述:DOSA-SIP, 30A POL DC/DC Converters |
| LSN2-T30-D12G-C | 制造商:MURATA 制造商全称:Murata Manufacturing Co., Ltd. 功能描述:DOSA-SIP, 30A POL DC/DC Converters |
| LSN-3.3/10-D12 | 功能描述:DC/DC转换器 33W 12V to 3.3V 10A RoHS:否 制造商:Murata 产品: 输出功率: 输入电压范围:3.6 V to 5.5 V 输入电压（标称）: 输出端数量:1 输出电压（通道 1）:3.3 V 输出电流（通道 1）:600 mA 输出电压（通道 2）: 输出电流（通道 2）: 安装风格:SMD/SMT 封装 / 箱体尺寸: |
| LSN-3.3/10-D12B | 功能描述:DC/DC转换器 33W 12V to 3.3V 10A RoHS:否 制造商:Murata 产品: 输出功率: 输入电压范围:3.6 V to 5.5 V 输入电压（标称）: 输出端数量:1 输出电压（通道 1）:3.3 V 输出电流（通道 1）:600 mA 输出电压（通道 2）: 输出电流（通道 2）: 安装风格:SMD/SMT 封装 / 箱体尺寸: |
发布紧急采购，3分钟左右您将得到回复。