
LSN2-T/30-D12 Series
DOSA-SIP, 30A POL DC/DC Converters
For full details go to
www.murata-ps.com/rohs
www.murata-ps.com
email: sales@murata-ps.com
25 Jun 2010
MDC_LSN2-T/30-D12 Series.B20Δ Page 1 of 16
FEATURES
■ Standard (DOSA compatible) SIP package
■ User-selectable outputs: 0.8 to 5Vdc
■ 30 Amps maximum output current
■ Meets RoHS-6 standards
■ Selectable phased start-up sequencing,
tracking and pre-bias operation
■ Wide range input voltages 6 to 14Vdc
■ To 150W with overtemperature shutdown
■ Very high efciency up to 94%
■ Fast settling, high di/dt IOUT slew rate
■ Meets UL 60950-1, CAN/CSA-C22.2 60950-
1, IEC 60950-1, EN60950-1 safety approvals,
2nd edition
■ Extensive self-protection with short circuit
“hiccup” shutdown
■ Output overvoltage/overcurrent protection
■ Input under and overvoltage shutdown
Figure 1. LSN2 -T/30-D12 Series Simplied Schematic
Typical topology is shown.
+INPUT
COMMON
VTRACK/SEQUENCE
INPUT
PWM
CONTROLLER
CURRENT
SENSE
REFERENCE &
ERROR AMP
VCC
ON/OFF
CONTROL
VOUT
TRIM
POWER
GOOD
OUTPUT
+OUTPUT
10.5
+SENSE
COMMON
Only one phase of two is shown.
DESCRIPTION
These miniature point-of-load (POL) switching
DC/DCs are an ideal regulation and supply ele-
ment for mixed voltage systems. The converter
is fully compatible with the Distributed-power
Open Standards Alliance specication
(www.dosapower.com). LSN2-T/30-D12 can
power CPU’s, programmable logic and mixed
voltage systems with little heat and low noise.
A typical application uses a master isolated
12V DC supply and the LSN2-T/30-D12 con-
verter for local 1.8V and 3.3V DC supplies.
All system isolation resides in the central
supply, leaving lower cost POL regulation
right at the load. Unlike linear regulators, the
LSN2-T/30-D12 can deliver very high power
(up to 150W) in a tiny area with no heat sink-
ing and no external components needed. The
converter features quick transient response
(to 25μsec) and very fast current slew rates
(to 20A/μsec).
LSN2-T/30-D12 is an open-frame SIP
using advanced surface mount (SMT)
assembly and test techniques. The extraor-
dinary performance is achieved with a fully
synchronous xed-frequency buck topology
delivering high efciency, tight line/load
regulation, stable no-load operation and no
output reverse conduction.
Output voltage, selected with an
external programming resistor or DC volt-
age into the trim pin, means OEM’s can
stock one model for multiple applications.
Also included are protection for out-of-
limit voltages, currents and temperature.
Other functions: a remote On/Off control,
optional Power Good output, a phased
start-up sequence and tracking system,
and a load Sense input.
Typical unit
Contents
Page
Description, Photograph, Connection Diagram
1
Ordering Guide, Model Numbering, Soldering Guidelines
2
Mechanical Specs, Input/Output Pinout
3
Detailed Electrical Specications
4
Technical Notes
5
Performance Data
13