- 您现在的位置：买卖IC网 > PDF目录80106 > LT1054CDWE4 (TEXAS INSTRUMENTS INC) SWITCHED CAPACITOR REGULATOR, 35 kHz SWITCHING FREQ-MAX, PDSO16 PDF资料下载
参数资料
| 型号： | LT1054CDWE4 |
| 厂商： | TEXAS INSTRUMENTS INC |
| 元件分类： | 稳压器 |
| 英文描述： | SWITCHED CAPACITOR REGULATOR, 35 kHz SWITCHING FREQ-MAX, PDSO16 |
| 封装： | GREEN, PLASTIC, SOIC-16 |
| 文件页数： | 4/30页 |
| 文件大小： | 607K |
| 代理商： | LT1054CDWE4 |
第1页第2页第3页当前第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页
LT1054
SWITCHED-CAPACITOR VOLTAGE CONVERTERS
WITH REGULATORS
SLVS033F FEBRUARY 1990 REVISED NOVEMBER 2004
12
POST OFFICE BOX 655303
DALLAS, TEXAS 75265
APPLICATION INFORMATION
regulation (continued)
The error amplifier of the LT1054 drives the pnp switch to control the voltage across the input capacitor (CIN),
which determines the output voltage. When the reference and error amplifier of the LT1054 are used, an external
resistive divider is all that is needed to set the regulated output voltage. Figure 16 shows the basic regulator
configuration and the formula for calculating the appropriate resistor values. R1 should be 20 k
Ω or greater
because the reference current is limited to
±100 μA. R2 should be in the range of 100 kΩ to 300 kΩ. Frequency
compensation is accomplished by adjusting the ratio of CIN to COUT.
For best results, this ratio should be approximately 1:10. Capacitor C1, required for good load regulation, should
be 0.002
μF for all output voltages.
The functional block diagram shows that the maximum regulated output voltage is limited by the supply voltage.
For the basic configuration,
VOUT referenced to the ground terminal of the LT1054 must be less than the total
of the supply voltage minus the voltage loss due to the switches. The voltage loss versus output current due
to the switches can be found in the typical performance curves. Other configurations, such as the negative
doubler, can provide higher voltages at reduced output currents.
capacitor selection
While the exact values of CIN and COUT are noncritical, good-quality low-ESR capacitors, such as solid
tantalum, are necessary to minimize voltage losses at high currents. For CIN, the effect of the ESR of the
capacitor is multiplied by four, because switch currents are approximately two times higher than output current.
Losses occur on both the charge and discharge cycle, which means that a capacitor with 1
Ω of ESR for CIN
has the same effect as increasing the output impedance of the LT1054 by 4
Ω. This represents a significant
increase in the voltage losses. COUT alternately is charged and discharged at a current approximately equal
to the output current. The ESR of the capacitor causes a step function to occur in the output ripple at the switch
transitions. This step function degrades the output regulation for changes in output load current and should be
avoided. A technique used to gain both low ESR and reasonable cost is to parallel a smaller tantalum capacitor
with a large aluminum electrolytic capacitor.
output ripple
The peak-to-peak output ripple is determined by the output capacitor and the output current values.
Peak-to-peak output ripple is approximated as:
DV +
I
OUT
2fC
OUT
Where:
ΔV = peak-to-peak ripple
fOSC = oscillator frequency
For output capacitors with significant ESR, a second term must be added to account for the voltage step at the
switch transitions. This step is approximately equal to:
2I
OUT ESR of COUT
(5)
(6)
相关PDF资料 |
PDF描述 |
|---|---|
| LT1952MPGN-1 | SWITCHING CONTROLLER, 560 kHz SWITCHING FREQ-MAX, PDSO16 |
| LM4041DSD-122GT3 | 1-OUTPUT TWO TERM VOLTAGE REFERENCE, 1.225 V, PDSO5 |
| LS4301-9RD8TB1 | 1-OUTPUT 100 W AC-DC PWR FACTOR CORR MODULE |
| LS5660-7ERDDT | 2-OUTPUT 100 W AC-DC PWR FACTOR CORR MODULE |
| LS2320-9ERD5TB1 | 2-OUTPUT 100 W AC-DC REG PWR SUPPLY MODULE |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LT1054CDWG4 | 功能描述:电荷泵 Swed-Capacitor Vltg Converters RoHS:否 制造商:Maxim Integrated 功能:Inverting, Step Up 输出电压:- 1.5 V to - 5.5 V, 3 V to 11 V 输出电流:100 mA 电源电流:1 mA 最大工作温度:+ 70 C 封装 / 箱体:SOIC-8 Narrow 封装:Tube |
| LT1054CDWR | 功能描述:电荷泵 Bipolar Regulated V RoHS:否 制造商:Maxim Integrated 功能:Inverting, Step Up 输出电压:- 1.5 V to - 5.5 V, 3 V to 11 V 输出电流:100 mA 电源电流:1 mA 最大工作温度:+ 70 C 封装 / 箱体:SOIC-8 Narrow 封装:Tube |
| LT1054CDWRE4 | 功能描述:电荷泵 Switched-Capacitor Voltage Converter RoHS:否 制造商:Maxim Integrated 功能:Inverting, Step Up 输出电压:- 1.5 V to - 5.5 V, 3 V to 11 V 输出电流:100 mA 电源电流:1 mA 最大工作温度:+ 70 C 封装 / 箱体:SOIC-8 Narrow 封装:Tube |
| LT1054CDWRG4 | 功能描述:电荷泵 Swed-Capacitor Vltg Converters RoHS:否 制造商:Maxim Integrated 功能:Inverting, Step Up 输出电压:- 1.5 V to - 5.5 V, 3 V to 11 V 输出电流:100 mA 电源电流:1 mA 最大工作温度:+ 70 C 封装 / 箱体:SOIC-8 Narrow 封装:Tube |
| LT1054CN8 | 功能描述:IC REG SWITCHED CAP DBL INV 8DIP RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 标准包装:2,500 系列:- 类型:升压（升压） 输出类型:可调式 输出数:1 输出电压:1.24 V ~ 30 V 输入电压:1.5 V ~ 12 V PWM 型:电流模式，混合 频率 - 开关:600kHz 电流 - 输出:500mA 同步整流器:无 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:8-SOIC（0.154"，3.90mm 宽） 包装:带卷 (TR) 供应商设备封装:8-SOIC |
发布紧急采购，3分钟左右您将得到回复。