- 您现在的位置：买卖IC网 > PDF目录14796 > LT1076IT#PBF (Linear Technology)IC REG MULTI CONFIG ADJ 2A TO220 PDF资料下载
参数资料
| 型号： | LT1076IT#PBF |
| 厂商： | Linear Technology |
| 文件页数： | 9/16页 |
| 文件大小： | 0K |
| 描述： | IC REG MULTI CONFIG ADJ 2A TO220 |
| 标准包装： | 50 |
| 类型： | 降压（降压），升压（升压），反相，回扫 |
| 输出类型： | 可调式 |
| 输出数： | 1 |
| 输出电压： | 2.5 V ~ 50 V |
| 输入电压： | 8 V ~ 45 V |
| 频率 - 开关： | 100kHz |
| 电流 - 输出： | 2A |
| 同步整流器： | 无 |
| 工作温度： | -40°C ~ 85°C |
| 安装类型： | 通孔 |
| 封装/外壳： | TO-220-5 成形引线 |
| 包装： | 管件 |
| 供应商设备封装： | TO-220-5 |
| 产品目录页面： | 1325 (CN2011-ZH PDF) |
LT1074/LT1076
PI DESCRIPTIO S
current is well controlled even when switch duty cycle
must be extremely low. Theoretical switch “on” time for a
buck converter in continuous mode is:
SHUTDOWN PIN
The shutdown pin is used for undervoltage lockout, micro-
power shutdown, soft-start, delayed start, or as a general
t ON =
V OUT + V D
V IN ? f
purpose on/off control of the regulator output. It controls
switching action by pulling the I LIM pin low, which forces
the switch to a continuous “off” state. Full micropower
V D = Catch diode forward voltage ( ≈ 0.5V)
f = Switching frequency
At f = 100kHz, t ON must drop to 0.2 μ s when V IN = 25V
and the output is shorted (V OUT = 0V). In current limit,
the LT1074 can reduce t ON to a minimum value of
≈ 0.6 μ s, much too long to control current correctly for
V OUT = 0. To correct this problem, switching frequency
is lowered from 100kHz to 20kHz as the FB pin drops
from 1.3V to 0.5V. This is accomplished by the circuitry
TO
OSCILLATOR
V OUT
shutdown is initiated when the shutdown pin drops below
0.3V.
The V/I characteristics of the shutdown pin are shown in
Figure 4. For voltages between 2.5V and ≈ V IN , a current of
10 μ A flows out of the shutdown pin. This current in-
creases to ≈ 25 μ A as the shutdown pin moves through the
2.35V threshold. The current increases further to ≈ 30 μ A at
the 0.3V threshold, then drops to ≈ 15 μ A as the shutdown
voltage fall below 0.3V. The 10 μ A current source is in-
cluded to pull the shutdown pin to its high or default state
when left open. It also provides a convenient pull-up for
delayed start applications with a capacitor on the shut-
down pin.
+
+2V
2.21V
Q1
R3
R1
When activated, the typical collector current of Q1 in
Figure 5, is ≈ 2mA. A soft-start capacitor on the I LIM pin will
V C
ERROR
AMPLIFIER
–
3k
FB
R2
EXTERNAL
DIVIDER
delay regulator shutdown in response to C1, by
≈ (5V)(C LIM )/2mA. Soft-start after full micropower shut-
down is ensured by coupling C2 to Q1.
2.21k
0
Figure 3. Frequency Shifting
LT1074?PD03
–5
–10
T j = 25 ° C
CURRENT FLOWS OUT
OF SHUTDOWN PIN
shown in Figure 3.
Q1 is off when the output is regulating (V FB = 2.21V). As
the output is pulled down by an overload, V FB will eventu-
ally reach 1.3V, turning on Q1. As the output continues to
drop, Q1 current increases proportionately and lowers the
–15
–20
–25
–30
–35
SHUTDOWN
THRESHOLD
frequency of the oscillator. Frequency shifting starts when
the output is ≈ 60% of normal value, and is down to its
minimum value of ? 20kHz when the output is ? 20% of
–40
0
0.5
1.0
1.5 2.0 2.5
VOLTAGE (V)
3.0
3.5 4.0
LT1074?PC05
normal value. The rate at which frequency is shifted is
determined by both the internal 3k resistor R3 and the
Figure 4. Shutdown Pin Characteristics
external divider resistors. For this reason, R2 should not
be increased to more than 4k ? , if the LT1074 will be
subjected to the simultaneous conditions of high input
voltage and output short-circuit.
sn1074 1074fds
9
相关PDF资料 |
PDF描述 |
|---|---|
| MAX6424UK20+T | IC MPU/RESET CIRC 2.00V SOT23-5 |
| LT1374CFE#PBF | IC REG BUCK ADJ 4.5A 16TSSOP |
| MAX6423XS43+T | IC MPU/RESET CIRC 4.30V SC70-4 |
| MAX6423XS42+T | IC MPU/RESET CIRC 4.20V SC70-4 |
| LTC3633EUFD#PBF | IC REG BUCK ADJ 3A DL 28QFN |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LT1076MK | 制造商:Linear Technology 功能描述: |
| LT1077ACN8 | 功能描述:IC PREC OP-AMP MICRPWR SNGL 8DIP RoHS:否 类别:集成电路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 标准包装:2,500 系列:- 放大器类型:通用 电路数:2 输出类型:满摆幅 转换速率:350 V/µs 增益带宽积:180MHz -3db带宽:320MHz 电流 - 输入偏压:12.5µA 电压 - 输入偏移:800µV 电流 - 电源:15mA 电流 - 输出 / 通道:85mA 电压 - 电源，单路/双路(±):2.5 V ~ 12.6 V，±1.25 V ~ 6.3 V 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:8-TSSOP，8-MSOP（0.118"，3.00mm 宽） 供应商设备封装:8-MSOP 包装:带卷 (TR) |
| LT1077ACN8#PBF | 功能描述:IC PREC OP-AMP MICRPWR SNGL 8DIP RoHS:是 类别:集成电路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 标准包装:2,500 系列:- 放大器类型:通用 电路数:4 输出类型:- 转换速率:0.6 V/µs 增益带宽积:1MHz -3db带宽:- 电流 - 输入偏压:45nA 电压 - 输入偏移:2000µV 电流 - 电源:1.4mA 电流 - 输出 / 通道:40mA 电压 - 电源，单路/双路(±):3 V ~ 32 V，±1.5 V ~ 16 V 工作温度:0°C ~ 70°C 安装类型:表面贴装 封装/外壳:14-TSSOP（0.173"，4.40mm 宽） 供应商设备封装:14-TSSOP 包装:带卷 (TR) 其它名称:LM324ADTBR2G-NDLM324ADTBR2GOSTR |
| LT1077AIN8 | 功能描述:IC PREC OP-AMP MICRPWR SNGL 8DIP RoHS:否 类别:集成电路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 标准包装:73 系列:Over-The-Top® 放大器类型:通用 电路数:4 输出类型:满摆幅 转换速率:0.07 V/µs 增益带宽积:200kHz -3db带宽:- 电流 - 输入偏压:1nA 电压 - 输入偏移:285µV 电流 - 电源:50µA 电流 - 输出 / 通道:25mA 电压 - 电源，单路/双路(±):2 V ~ 44 V，±1 V ~ 22 V 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:16-WFDFN 裸露焊盘 供应商设备封装:16-DFN-EP（5x3） 包装:管件 |
| LT1077AIN8#PBF | 功能描述:IC PREC OP-AMP MICRPWR SNGL 8DIP RoHS:是 类别:集成电路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 标准包装:73 系列:Over-The-Top® 放大器类型:通用 电路数:4 输出类型:满摆幅 转换速率:0.07 V/µs 增益带宽积:200kHz -3db带宽:- 电流 - 输入偏压:1nA 电压 - 输入偏移:285µV 电流 - 电源:50µA 电流 - 输出 / 通道:25mA 电压 - 电源，单路/双路(±):2 V ~ 44 V，±1 V ~ 22 V 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:16-WFDFN 裸露焊盘 供应商设备封装:16-DFN-EP（5x3） 包装:管件 |
发布紧急采购，3分钟左右您将得到回复。