- 您现在的位置：买卖IC网 > PDF目录44979 > LT1082IQ#TR (LINEAR TECHNOLOGY CORP) 2.8 A SWITCHING REGULATOR, 75 kHz SWITCHING FREQ-MAX, PSSO5 PDF资料下载
参数资料
| 型号： | LT1082IQ#TR |
| 厂商： | LINEAR TECHNOLOGY CORP |
| 元件分类： | 稳压器 |
| 英文描述： | 2.8 A SWITCHING REGULATOR, 75 kHz SWITCHING FREQ-MAX, PSSO5 |
| 封装： | PLASTIC, D2PAK-5 |
| 文件页数： | 12/12页 |
| 文件大小： | 179K |
| 代理商： | LT1082IQ#TR |
9
LT1082
sn1082 1082fas
OPERATIO
U
KT/q = 26mV at 25
°C
tS = pulse width
fS = pulse frequency
IC = LT1082 VC source current (≈ 200A)
VC = LT1082 operating VC voltage (1V to 2V)
R3 = resistor used to set mid-frequency “zero” in LT1082
frequency compensation network.
With tS = 0.6s, fS = 80kHz, VC = 1.5V, and R3 = 2k, offset
voltage shift is
≈ 5mV. This is not particularly bothersome,
but note that high offset could result if R3 were reduced to
a much lower value. Also, the synchronizing transistor
must sink higher currents with low values of R3, so larger
drives may have to be used. The transistor must be
capable of pulling the VC pin to within 100mV of ground to
ensure synchronizing.
Total power dissipation is the sum of supply current times
input voltage plus switch power:
PTOT = (IIN)(VIN) + PSW
In a typical example, using negative-to-positive converter
to generate 5V at 0.5A from a – 45V input, duty cycle is
approximately 12%, and switch current is about 0.5A,
yielding:
IIN = 4.5mA + 0.5(0.004 + DC/28) = 8.7mA
PSW = (0.5)2 1.2 (0.12) = 0.036W
PTOT = (45V)(8.7mA) + 0.036 = 0.43W
Temperature rise in a plastic miniDIP would be 90
°C/W
times 0.43W, or approximately 39
°C. The maximum am-
bient temperature would be limited to 100
°C (commercial
temperature limit) minus 39
°C, or 61°C.
In most applications, full load current is used to calculate
die temperature. However, if overload conditions must
also be accounted for, four approaches are possible. First,
if loss of regulated output is acceptable under overload
conditions, the internal
thermal limit of the LT1082 will
protect the die in most applications by shutting off switch
current.
Thermal limit is not a tested parameter, however,
and should be considered only for noncritical applications
with temporary overloads. A second approach is to use the
larger TO-220 (T) package which, even without a heat sink,
may limit die temperatures to safe levels under overload
conditions. In critical situations, heat sinking of these
packages is required; especially if overload conditions
must be tolerated for extended periods of time.
The third approach for lower current applications is to
leave the second switch emitter (miniDIP only) open. This
increases switch “on” resistance by 2:1, but reduces
switch current limit by 2:1 also, resulting in a net 2:1
reduction in I2R switch dissipation under current limit
conditions.
The fourth approach is to clamp the VC pin to a voltage less
than its internal clamp level of 2V. The LT1082 switch
current limit is zero at approximately 1V on the VC pin and
1.6A at 2V on the VC pin. Peak switch current can be
externally clamped between these two levels with a diode.
See AN19 for details.
LT1082 Synchronizing
The LT1082 can be externally synchronized in the fre-
quency range of 75kHz to 90kHz. This is accomplished as
shown in the accompanying figures. Synchronizing oc-
curs when the VC pin is pulled to ground with an external
transistor. To avoid disturbing the DC characteristics of
the internal error amplifier, the width of the synchronizing
pulse should be under 1
s. C2 sets the pulse width at ≈
0.6
s. The effect of a synchronizing pulse on the LT1082
amplifier offset can be calculated from:
V
KT
q
tf
I
V
R
I
OS
SS
C
=
()( )
+
3
VIN
GND
VC
LT1082
VN2222*
C1
R3
C2
350pF
D2
1N4148
R2
2.2k
D1
1N4148
*SILICONIX OR EQUIVALENT
1082 OP01
FROM 5V
LOGIC
Synchronizing the LT1082
相关PDF资料 |
PDF描述 |
|---|---|
| LT1171ITTR | 5.5 A SWITCHING REGULATOR, 115 kHz SWITCHING FREQ-MAX, PZFM5 |
| LT1170CT#PBF06 | 11 A SWITCHING REGULATOR, 115 kHz SWITCHING FREQ-MAX, PZFM5 |
| LT1172CS | 1.25 A SWITCHING REGULATOR, 100 kHz SWITCHING FREQ-MAX, PDSO16 |
| 5962-9207901MPA | 1.25 A SWITCHING REGULATOR, 100 kHz SWITCHING FREQ-MAX, CDIP8 |
| 5962-9207901MPX | 1.25 A SWITCHING REGULATOR, 100 kHz SWITCHING FREQ-MAX, CDIP8 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LT1082IT | 功能描述:IC REG MULTI CONFIG 1A TO220-5 RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 设计资源:Design Support Tool 标准包装:1 系列:- 类型:升压（升压） 输出类型:固定 输出数:1 输出电压:3V 输入电压:0.75 V ~ 2 V PWM 型:- 频率 - 开关:- 电流 - 输出:100mA 同步整流器:是 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:SOT-23-5 细型，TSOT-23-5 包装:剪切带 (CT) 供应商设备封装:TSOT-23-5 其它名称:AS1323-BTTT-30CT |
| LT1082IT#06 | 制造商:Linear Technology 功能描述:1A High Voltage, Efficiency Switching Voltage Regulator |
| LT1082IT#30PBF | 制造商:Linear Technology 功能描述:IC REG MULTI CONFIG 1A TO220-5 |
| LT1082IT#PBF | 功能描述:IC REG MULTI CONFIG 1A TO220-5 RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 标准包装:250 系列:- 类型:降压（降压） 输出类型:固定 输出数:1 输出电压:1.2V 输入电压:2.05 V ~ 6 V PWM 型:电压模式 频率 - 开关:2MHz 电流 - 输出:500mA 同步整流器:是 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:6-UFDFN 包装:带卷 (TR) 供应商设备封装:6-SON（1.45x1） 产品目录页面:1032 (CN2011-ZH PDF) 其它名称:296-25628-2 |
| LT1082IT#PBF | 制造商:Linear Technology 功能描述:Switching Regulator IC |
发布紧急采购，3分钟左右您将得到回复。