参数资料
| 型号： | LT1113CN8#PBF |
| 厂商： | Linear Technology |
| 文件页数： | 16/16页 |
| 文件大小： | 0K |
| 描述： | IC PREC OP-AMP JFET DUAL 8-DIP |
| 标准包装： | 50 |
| 放大器类型： | J-FET |
| 电路数： | 2 |
| 转换速率： | 3.9 V/µs |
| 增益带宽积： | 5.6MHz |
| 电流 - 输入偏压： | 320pA |
| 电压 - 输入偏移： | 500µV |
| 电流 - 电源： | 5.3mA |
| 电压 - 电源，单路/双路(±)： | ±4.5 V ~ 20 V |
| 工作温度： | 0°C ~ 70°C |
| 安装类型： | 通孔 |
| 封装/外壳： | 8-DIP（0.300"，7.62mm） |
| 供应商设备封装： | 8-PDIP |
| 包装： | 管件 |
| 产品目录页面： | 1317 (CN2011-ZH PDF) |
9
LT1113
1113fb
U
S
A
O
PPLICATI
WU
U
I FOR ATIO
This means the LT1113 will beat out any dual JFET op amp,
only the lowest noise bipolar op amps have the edge
(at low source resistances). As the source resistance
increases from 5k to 50k, the LT1113 will match the best
bipolar op amps for noise performance, since the thermal
noise of the transducer (4kTR) begins to dominate the
total noise. A further increase in source resistance, above
50k, is where the op amp’s current noise component (2qIB
RTRANS) will eventually dominate the total noise. At these
high source resistances, the LT1113 will out perform
the lowest noise bipolar op amp due to the inherently low
current noise of FET input op amps. Clearly, the LT1113
will extend the range of high impedance transducers
that can be used for high signal to noise ratios. This
makes the LT1113 the best choice for high impedance,
capacitive transducers.
The high input impedance JFET front end makes the
LT1113 suitable in applications where very high charge
sensitivity is required. Figure 2 illustrates the LT1113 in its
inverting and noninverting modes of operation. A charge
amplifier is shown in the inverting mode example; here the
gain depends on the principal of charge conservation at
the input of the LT1113. The charge across the transducer
capacitance, CS, is transferred to the feedback capacitor
CF, resulting in a change in voltage, dV, equal to dQ/CF.
Figure 1. Comparison of LT1113 and LT1124 Total Output 1kHz Voltage Noise Versus Source Resistance
SOURCE RESISTANCE (
)
100
1
10
1k
100M
1113 F01
100k
100
10M
10k
1M
RESISTOR NOISE ONLY
INPUT
NOISE
VOLTAGE
(nV/
√
Hz)
Vn = AV √Vn
2
(OP AMP) + 4kTR + 2q IB R
2
+
–
CS
RS
VO
CS
RS
LT1124
LT1113
LT1124*
LT1113*
SOURCE RESISTANCE = 2RS = R
* PLUS RESISTOR
PLUS RESISTOR 1000pF CAPACITOR
LT1113
LT1124
The LT1113 dual in the plastic and ceramic DIP packages
are pin compatible with and directly replace such JFET op
amps as the OPA2111 and OPA2604 with improved noise
performance. Being the lowest noise dual JFET op amp
available to date, the LT1113 can replace many bipolar op
amps that are used in amplifying low level signals from
high impedance transducers. The best bipolar op amps
will eventually loose out to the LT1113 when transducer
impedance increases due to higher current noise. The low
voltage noise of the LT1113 allows it to surpass every dual
and most single JFET op amps available. For the best
performance versus area available anywhere, the LT1113
is offered in the narrow SO-8 surface mount package with
standard pinout and no degradation in performance.
The low voltage and current noise offered by the LT1113
makes it useful in a wide range of applications, especially
where high impedance, capacitive transducers are used
such as hydrophones, precision accelerometers and photo
diodes. The total output noise in such a system is the gain
times the RMS sum of the op amp input referred voltage
noise, the thermal noise of the transducer, and the op amp
bias current noise times the transducer impedance.
Figure 1 shows total input voltage noise versus source
resistance. In a low source resistance (<5k) application
the op amp voltage noise will dominate the total noise.
相关PDF资料 |
PDF描述 |
|---|---|
| LTC1152CN8#PBF | IC OPAMP 0-DRFT R-R IN/OUT 8DIP |
| OP293FSZ | IC OPAMP GP 35KHZ DUAL 8SOIC |
| 929500-01-14 | CONN HEADER .100 SNGL R/A 14POS |
| 929400-01-15 | CONN HEADER .100 SNGL STR 15POS |
| LTC2051HVHMS8#PBF | IC OP-AMP ZERO-DRIFT DUAL 8-MSOP |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LT1113CS8 | 功能描述:IC PREC OP-AMP JFET DUAL 8SOIC RoHS:否 类别:集成电路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 标准包装:50 系列:- 放大器类型:J-FET 电路数:2 输出类型:- 转换速率:3.5 V/µs 增益带宽积:1MHz -3db带宽:- 电流 - 输入偏压:30pA 电压 - 输入偏移:2000µV 电流 - 电源:200µA 电流 - 输出 / 通道:- 电压 - 电源，单路/双路(±):7 V ~ 36 V，±3.5 V ~ 18 V 工作温度:0°C ~ 70°C 安装类型:通孔 封装/外壳:8-DIP（0.300"，7.62mm） 供应商设备封装:8-PDIP 包装:管件 |
| LT1113CS8#PBF | 功能描述:IC PREC OP-AMP JFET DUAL 8SOIC RoHS:是 类别:集成电路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 标准包装:2,500 系列:- 放大器类型:通用 电路数:4 输出类型:- 转换速率:0.6 V/µs 增益带宽积:1MHz -3db带宽:- 电流 - 输入偏压:45nA 电压 - 输入偏移:2000µV 电流 - 电源:1.4mA 电流 - 输出 / 通道:40mA 电压 - 电源，单路/双路(±):3 V ~ 32 V，±1.5 V ~ 16 V 工作温度:0°C ~ 70°C 安装类型:表面贴装 封装/外壳:14-TSSOP（0.173"，4.40mm 宽） 供应商设备封装:14-TSSOP 包装:带卷 (TR) 其它名称:LM324ADTBR2G-NDLM324ADTBR2GOSTR |
| LT1113CS8#PBF | 制造商:Linear Technology 功能描述:IC OP-AMP 5.6MHZ 3.9V/ SOIC-8 |
| LT1113CS8#TR | 功能描述:IC OPAMP DUAL PREC JFET LN 8SOIC RoHS:否 类别:集成电路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 标准包装:1 系列:- 放大器类型:通用 电路数:4 输出类型:满摆幅 转换速率:0.028 V/µs 增益带宽积:105kHz -3db带宽:- 电流 - 输入偏压:3nA 电压 - 输入偏移:100µV 电流 - 电源:3.3µA 电流 - 输出 / 通道:12mA 电压 - 电源，单路/双路(±):2.7 V ~ 12 V，±1.35 V ~ 6 V 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:14-TSSOP（0.173"，4.40mm 宽） 供应商设备封装:14-TSSOP 包装:剪切带 (CT) 其它名称:OP481GRUZ-REELCT |
| LT1113CS8#TRPBF | 功能描述:IC PREC OP-AMP JFET DUAL 8SOIC RoHS:是 类别:集成电路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 标准包装:1 系列:- 放大器类型:通用 电路数:4 输出类型:满摆幅 转换速率:0.028 V/µs 增益带宽积:105kHz -3db带宽:- 电流 - 输入偏压:3nA 电压 - 输入偏移:100µV 电流 - 电源:3.3µA 电流 - 输出 / 通道:12mA 电压 - 电源，单路/双路(±):2.7 V ~ 12 V，±1.35 V ~ 6 V 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:14-TSSOP（0.173"，4.40mm 宽） 供应商设备封装:14-TSSOP 包装:剪切带 (CT) 其它名称:OP481GRUZ-REELCT |
发布紧急采购，3分钟左右您将得到回复。