参数资料
型号: LT1117CST
厂商: Linear Technology
文件页数: 7/16页
文件大小: 0K
描述: IC REG LDO ADJ .8A SOT-223
标准包装: 78
稳压器拓扑结构: 正,可调式
输出电压: 1.25 V ~ 13.7 V
输入电压: 2.45 V ~ 15 V
电压 - 压降(标准): 1.1V @ 800mA
稳压器数量: 1
电流 - 输出: 800mA
电流 - 限制(最小): 800mA
工作温度: 0°C ~ 125°C
安装类型: 表面贴装
封装/外壳: TO-261-4,TO-261AA
供应商设备封装: SOT-223
包装: 管件
LT1117/LT1117-2.85
LT1117-3.3/LT1117-5
APPLICATIONS INFORMATION
The LT1117 family of 3-terminal regulators are easy to
use. They are protected against short circuit and thermal
overloads. Thermal protection circuitry will shut down the
regulator should the junction temperature exceed 165°C
at the sense point. These regulators are pin compatible
with older 3-terminal adjustable regulators, offer lower
dropout voltage and more precise reference tolerance.
Reference stability over temperature is improved over
older types of regulators.
Stability
The LT1117 family of regulators requires an output
capacitor as part of the device frequency compensation.
A minimum of 10μF of tantalum or 50μF of aluminum
electrolytic is required. The ESR of the output capacitor
should be less than 0.5Ω. Surface mount tantalum
capacitors, which have very low ESR, are available from
several manufacturers.
When using the LT1117 adjustable device, the adjust
terminal can be bypassed to improve ripple rejection.
When the adjust terminal is bypassed, the required value
of the output capacitor increases. The device will require
an output capacitor of 22μF tantalum or 150μF aluminum
electrolytic when the adjust pin is bypassed.
Protection Diodes
In normal operation, the LT1117 family does not need any
protection diodes. Older adjustable regulators required
protection diodes between the adjust pin and the output
and between the output and input to prevent over stressing
the die. The internal current paths on the LT1117 adjust
pin are limited by internal resistors. Therefore, even with
capacitors on the adjust pin, no protection diode is needed
to ensure device safety under short-circuit conditions.
The adjust pin can be driven, on a transient basis, ± 25V with
respect to the output without any device degradation.
Diodes between input and output are not usually needed.
The internal diode between the output and input pins of
the device can withstand microsecond surge currents of
10A to 20A. Normal power supply cycling can not generate
currents of this magnitude. Only with extremely large output
capacitors, such as 1000μF and larger, and with the input
pin instantaneously shorted to ground can damage occur.
A crowbar circuit at the input of the LT1117 in combination
with a large output capacitor could generate currents large
enough to cause damage. In this case a diode from output
to input is recommended, as shown in Figure 1.
D1
1N4002
(OPTIONAL)
Normally, capacitor values on the order of 100μF are
used in the output of many regulators to ensure good
LT1117
load transient response with large load current changes.
Output capacitance can be increased without limit and
larger values of output capacitance further improve stability
and transient response.
V IN
IN
ADJ
+
OUT
C ADJ
10 μ F
R1
R2
+
V OUT
C OUT
150 μ F
1117 F01
Figure 1
1117fd
7
相关PDF资料
PDF描述
LT1117CST-2.85#PBF IC REG LDO 2.85V .8A SOT-223
EB81-S0A2240Z CONN EDGEBOARD DUAL 44POS 5A
RCB75DHHT CONN EDGECARD 150PS DIP .050 SLD
ASC19DRAS CONN EDGECARD 38POS .100 R/A DIP
RYM36DTAN CONN EDGECARD 72POS R/A .156 SLD
相关代理商/技术参数
参数描述
LT1117CST#PBF 功能描述:IC REG LDO ADJ .8A SOT-223 RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - 线性 系列:- 产品培训模块:MIC5365/66 Ultra-small LDO Regulators 标准包装:1 系列:- 稳压器拓扑结构:正,固定式 输出电压:3V 输入电压:最高 5.5V 电压 - 压降(标准):0.155V @ 150mA 稳压器数量:1 电流 - 输出:150mA 电流 - 限制(最小):200mA 工作温度:-40°C ~ 125°C 安装类型:表面贴装 封装/外壳:4-UDFN 裸露焊盘,4-TMLF? 供应商设备封装:4-TMLF?(1x1) 包装:Digi-Reel® 其它名称:576-3192-6
LT1117CST#PBF 制造商:Linear Technology 功能描述:Linear Voltage Regulator IC
LT1117CST#TR 功能描述:IC REG LDO ADJ .8A SOT-223 RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - 线性 系列:- 产品培训模块:More Information on LDOs 标准包装:50 系列:- 稳压器拓扑结构:正,固定式 输出电压:3.3V 输入电压:最高 15V 电压 - 压降(标准):1.1V @ 800mA 稳压器数量:1 电流 - 输出:800mA 电流 - 限制(最小):800mA 工作温度:0°C ~ 125°C 安装类型:表面贴装 封装/外壳:TO-263-4,D²Pak(3 引线+接片),TO-263AA 供应商设备封装:D2PAK-3 包装:管件
LT1117CST#TRPBF 功能描述:IC REG LDO ADJ .8A SOT-223 RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - 线性 系列:- 产品培训模块:More Information on LDOs 标准包装:50 系列:- 稳压器拓扑结构:正,固定式 输出电压:3.3V 输入电压:最高 15V 电压 - 压降(标准):1.1V @ 800mA 稳压器数量:1 电流 - 输出:800mA 电流 - 限制(最小):800mA 工作温度:0°C ~ 125°C 安装类型:表面贴装 封装/外壳:TO-263-4,D²Pak(3 引线+接片),TO-263AA 供应商设备封装:D2PAK-3 包装:管件
LT1117CST-1.8 制造商:Exar Corporation 功能描述:Voltage Regulator