- 您现在的位置：买卖IC网 > PDF目录3296 > LT1122DS8#PBF (Linear Technology)IC OP-AMP JFET FASTSETTLNG 8SOIC PDF资料下载
参数资料
| 型号： | LT1122DS8#PBF |
| 厂商： | Linear Technology |
| 文件页数： | 13/14页 |
| 文件大小： | 0K |
| 描述： | IC OP-AMP JFET FASTSETTLNG 8SOIC |
| 标准包装： | 100 |
| 放大器类型： | J-FET |
| 电路数： | 1 |
| 转换速率： | 75 V/µs |
| 增益带宽积： | 13MHz |
| 电流 - 输入偏压： | 12pA |
| 电压 - 输入偏移： | 130µV |
| 电流 - 电源： | 7.8mA |
| 电压 - 电源，单路/双路(±)： | ±5 V ~ 18 V |
| 工作温度： | -40°C ~ 85°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 8-SOIC（0.154"，3.90mm 宽） |
| 供应商设备封装： | 8-SO |
| 包装： | 管件 |
| 产品目录页面： | 1317 (CN2011-ZH PDF) |
LT1122
8
1122fb
For more information www.linear.com/LT1122
APPLICATIONS INFORMATION
Settling Time Measurements
Settling time test circuits shown on some competitive
devices’ data sheets require:
1. A“flattop”pulsegenerator.Unfortunately,flattoppulse
generators are not commercially available.
2. A variable feedback capacitor around the device under
test. This capacitor varies over a four-to-one range.
Presumably, as each op amp is measured for settling
time, the capacitor is fine tuned to optimize settling
time for that particular device.
3. A small inductor load to optimize settling.
TheLT1122’ssettlingtimeis100%testedinthetestcircuit
shown. No “flat top” pulse generator is required. The test
circuit can be readily constructed, using commercially
available ICs. Of course, standard high frequency board
construction techniques should be followed. All LT1122s
are measured with a constant feedback capacitor. No fine
tuning is required.
Speed Boost/Overcompensation Terminal
Pin 8 of the LT1122 can be used to change the input stage
operating current of the device. Shorting Pin 8 to the posi-
tive supply (Pin 7) increases slew rate and bandwidth by
about 25%, but at the expense of a reduction in phase
marginbyapproximately18degrees.Unity-gaincapacitive
load handling decreases from typically 500pF to 100pF.
Conversely,connectinga15kresistorfromPin8toground
pulls 1mA out of Pin 8 (with V+ = 15V). This reduces slew
rate and bandwidth by 25%. Phase margin and capacitive
load handling improve; the latter typically increasing to
800pF.
High Speed Operation
As with most high speed amplifiers, care should be
taken with supply decoupling, lead dress and component
placement.
ThepowersupplyconnectionstotheLT1122mustmaintain
a low impedance to ground over a bandwidth of 20MHz.
This is especially important when driving a significant
resistive or capacitive load, since all current delivered to
the load comes from the power supplies. Multiple high
qualitybypasscapacitorsarerecommendedforeachpower
supply line in any critical application. A 0.1F ceramic and
a 1F electrolytic capacitor, as shown, placed as close as
possible to the amplifier (with short lead lengths to power
supply common) will assure adequate high frequency
bypassing, in most applications.
V+
7
2
6
3
4
1F
0.1F
1F
0.1F
V–
LT1122
1122 TA03
+
–
+
When the feedback around the op amp is resistive (RF),
a pole will be created with RF, the source resistance and
capacitance (RS, CS), and the amplifier input capacitance
(CIN ≈ 4pF). In low closed-loop gain configurations and
with RS and RF in the kilohm range, this pole can create
excess phase shift and even oscillation. A small capaci-
tor (CF) in parallel with RF eliminates this problem. With
RS (CS + CIN) = RFCF, the effect of the feedback pole is
completely removed.
RS
CS
CIN
RF
CF
OUTPUT
+
–
1122 TA04
相关PDF资料 |
PDF描述 |
|---|---|
| 1-215079-8 | CONN FMALE-ON-BRD 18POS VERT T/H |
| 5-534998-2 | 04 MODIV VRT DR CE 100/125 |
| 5-147104-2 | 04 MODIV VRT DR SFMNT10AU |
| LT1122DS8 | IC OP-AMP JFET FASTSETTLNG 8SOIC |
| 146138-5 | CONN RCPT 7POS VERT .100 GOLD |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LT1123 | 制造商:LINER 制造商全称:Linear Technology 功能描述:Low Dropout Regulator Driver |
| LT1123_05 | 制造商:LINER 制造商全称:Linear Technology 功能描述:Low Dropout Regulator Driver |
| LT1123CS8-2.85 | 制造商:未知厂家 制造商全称:未知厂家 功能描述:Interface IC |
| LT1123CST | 功能描述:IC REG CTRLR SGL 5V SOT223 RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - 线性晶体管驱动器 系列:- 产品培训模块:More Information on LDOs 标准包装:2,500 系列:- 类型:正，固定式 输出数:2 输出电压:2.8V，3.3V 电流 - 电源:12mA 输入电压:5 V ~ 22 V 工作温度:0°C ~ 70°C 封装/外壳:16-SOIC（0.154"，3.90mm 宽） 供应商设备封装:16-SOIC 包装:带卷 (TR) |
| LT1123CST#PBF | 功能描述:IC REG CTRLR SGL 5V SOT223 RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - 线性晶体管驱动器 系列:- 产品培训模块:More Information on LDOs 标准包装:2,500 系列:- 类型:正，固定式 输出数:2 输出电压:2.8V，3.3V 电流 - 电源:12mA 输入电压:5 V ~ 22 V 工作温度:0°C ~ 70°C 封装/外壳:16-SOIC（0.154"，3.90mm 宽） 供应商设备封装:16-SOIC 包装:带卷 (TR) |
发布紧急采购，3分钟左右您将得到回复。