参数资料
| 型号： | LT1128ACN8#PBF |
| 厂商： | Linear Technology |
| 文件页数： | 7/28页 |
| 文件大小： | 0K |
| 描述： | IC OP-AMP LOW NOISE SNGL 8-DIP |
| 标准包装： | 50 |
| 放大器类型： | 通用 |
| 电路数： | 1 |
| 转换速率： | 6 V/µs |
| 增益带宽积： | 20MHz |
| 电流 - 输入偏压： | 25nA |
| 电压 - 输入偏移： | 10µV |
| 电流 - 电源： | 7.4mA |
| 电压 - 电源，单路/双路(±)： | ±4 V ~ 18 V |
| 工作温度： | -40°C ~ 85°C |
| 安装类型： | 通孔 |
| 封装/外壳： | 8-DIP（0.300"，7.62mm） |
| 供应商设备封装： | 8-PDIP |
| 包装： | 管件 |
第1页第2页第3页第4页第5页第6页当前第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页
LT1028/LT1128
15
1028fb
applicaTions inForMaTion
Frequency Response
The LT1028’s Gain, Phase vs Frequency plot indicates that
the device is stable in closed-loop gains greater than +2 or
–1becausephasemarginisabout50°atanopen-loopgain
of 6dB. In the voltage follower configuration phase margin
seems inadequate. This is indeed true when the output is
shorted to the inverting input and the noninverting input
is driven from a 50Ω source impedance. However, when
feedback is through a parallel R-C network (provided CF
< 68pF), the LT1028 will be stable because of interaction
between the input resistance and capacitance and the
feedback network. Larger source resistance at the non-
inverting input has a similar effect. The following voltage
follower configurations are stable:
Another configuration which requires unity-gain stability
is shown below. When CF is large enough to effectively
short the output to the input at 15MHz, oscillations can
occur.TheinsertionofRS2≥500ΩwillpreventtheLT1028
from oscillating. When RS1 ≥ 500Ω, the additional noise
contribution due to the presence of RS2 will be minimal.
When RS1 ≤ 100Ω, RS2 is not necessary, because RS1
represents a heavy load on the output through the CF
short. When 100Ω < RS1 < 500Ω, RS2 should match RS1.
For example, RS1 = RS2 = 300Ω will be stable. The noise
increase due to RS2 is 40%.
If CF is only used to cut noise bandwidth, a similar effect
can be achieved using the over-compensation terminal.
The Gain, Phase plot also shows that phase margin is
about45°atgainof10(20dB).Thefollowingconfiguration
has a high (≈70%) overshoot without the 10pF capacitor
because of additional phase shift caused by the feedback
resistor–inputcapacitancepole.Thepresenceofthe10pF
capacitor cancels this pole and reduces overshoot to 5%.
1028 F09
–
+
33pF
2k
LT1028
50
–
+
LT1028
50
500
1028 F10
C1
R1
RS1
RS2
LT1028
–
+
1028 F11
10pF
10k
50
1.1k
–
+
LT1028
Figure 9
Over-Compensation
The LT1028/LT1128 are equipped with a frequency over-
compensation terminal (Pin 5). A capacitor connected
between Pin 5 and the output will reduce noise bandwidth.
DetailsareshownontheSlewRate,Gain-BandwidthProd-
uct vs Over-Compensation Capacitor plot. An additional
benefit is increased capacitive load handling capability.
Figure 10
Figure 11
相关PDF资料 |
PDF描述 |
|---|---|
| LT6604CUFF-5#PBF | IC AMP DIFF LN DUAL 34-QFN |
| PFC-W1206LF-03-3012-B-1059 | RES PREC 30.1KOHM 333MW .1% 1206 |
| 172469-1 | CONN RCPT HSG FLAG .250 NATURAL |
| LT6604CUFF-2.5#PBF | IC AMP DIFF LN DUAL 34-QFN |
| 2-172076-6 | CONN RCPT HSG 1POS .250 BLUE |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LT1128AM | 制造商:LINER 制造商全称:Linear Technology 功能描述:Ultra Low Noise Precision High Speed Op Amps |
| LT1128AMJ8 | 制造商:LINER 制造商全称:Linear Technology 功能描述:Ultra Low Noise Precision High Speed Op Amps |
| LT1128C | 制造商:LINER 制造商全称:Linear Technology 功能描述:Ultra Low Noise Precision High Speed Op Amps |
| LT1128CJ8 | 制造商:LINER 制造商全称:Linear Technology 功能描述:Ultra Low Noise Precision High Speed Op Amps |
| LT1128CN8 | 功能描述:IC OP-AMP LOW NOISE SNGL 8-DIP RoHS:否 类别:集成电路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 标准包装:50 系列:- 放大器类型:J-FET 电路数:2 输出类型:- 转换速率:3.5 V/µs 增益带宽积:1MHz -3db带宽:- 电流 - 输入偏压:30pA 电压 - 输入偏移:2000µV 电流 - 电源:200µA 电流 - 输出 / 通道:- 电压 - 电源，单路/双路(±):7 V ~ 36 V，±3.5 V ~ 18 V 工作温度:0°C ~ 70°C 安装类型:通孔 封装/外壳:8-DIP（0.300"，7.62mm） 供应商设备封装:8-PDIP 包装:管件 |
发布紧急采购，3分钟左右您将得到回复。