- 您现在的位置：买卖IC网 > PDF目录19336 > LT1186FCS (Linear Technology)IC SWTCH REG CCFL DAC PROG16SOIC PDF资料下载
参数资料
| 型号： | LT1186FCS |
| 厂商： | Linear Technology |
| 文件页数： | 8/16页 |
| 文件大小： | 0K |
| 描述： | IC SWTCH REG CCFL DAC PROG16SOIC |
| 标准包装： | 50 |
| 系列： | Bits-to-Nits™ |
| 类型： | CCFL 控制器 |
| 频率： | 175 ~ 225 kHz |
| 电流 - 电源： | 6mA |
| 电源电压： | 3 V ~ 6.5 V |
| 工作温度： | 0°C ~ 100°C |
| 封装/外壳： | 16-SOIC（0.154"，3.90mm 宽） |
| 供应商设备封装： | 16-SOIC |
| 包装： | 管件 |
LT1186F
PI N FU N CTIO N S
AGND (Pin 5): This is the low current analog ground. It is
the negative sense terminal for the internal 1.24V refer-
ence and the I CCFL summing voltage in the LT1186F.
Connect low current signal paths that terminate to ground
and frequency compensation components that terminate
to ground directly to this pin for best regulation and
performance.
SHDN (Pin 6): Pulling this pin low causes complete
regulator shutdown with quiescent current typically re-
duced to 35 μ A. If the pin is not used, use a pull-up resistor
to force a logic high level (maximum of 6V) or tie directly
to V CC . In a shutdown condition, the DAC retains its last
output current setting and returns to this level when the
logic-low signal at the shutdown pin is removed.
CLK (Pin 7): This pin is the shift clock for the DAC. This
clock synchronizes the serial data and is a Schmitt
trigger input. In standard SPI mode, the clock shifts data
into D IN and out of D OUT on the rising and falling edges
of the clock respectively. In pulse mode, the rising edge
of the clock either increments or decrements the counter.
This action depends on the choice of a 1-wire interface
(increment only) or a 2-wire interface (increment/decre-
ment).
CS (Pin 8): This pin is the chip select input for the DAC. In
SPI mode, a logic low on the CS pin enables the DAC to
receive and transfer 8-bit serial data. After the serial input
data is shifted in, a rising edge of CS transfers the data into
the counter, the DAC assumes the new I OUT value and the
D OUT pin returns to the high impedance state. On power
up, a logic high places the DAC into pulse mode. Pulling CS
low after this places the DAC into SPI mode until V CC
resets.
D IN or UP/DN (Pin 9): This pin is the digital input for the
DAC. In SPI mode, the 8-bit serial data is shifted into the
D IN input on each rising edge of the clock signal. In pulse
mode, on power up, a logic high at D IN transfers the pin
function from D IN to UP/DN, puts the counter into incre-
ment-only mode and the pin function shifts to up or down
increment control of DAC output current. If UP/DN re-
ceives a logic-low signal, the counter configures to incre-
ment/decrement mode until V CC resets.
8
D OUT (Pin 10): This pin is the digital output for the DAC. In
SPI mode, D OUT is in three-state until CS falls low. The
D OUT pin then serially transfers the previous 8-bit data on
every falling edge of the clock. When CS rises high again,
D OUT returns to a three-state condition. In pulse mode,
D OUT is always three-stated.
I OUT (Pin 11): This pin is the analog current output for the
DAC and provides an output current of 50 ± 3 μ A over
temperature. This pin can be biased from – 20V to 2V for
a 3.3V V CC supply voltage or from – 20V to 2.5V for a 5V
V CC supply voltage. However, this pin is tied to the I CCFL pin
and provides the programming current which sets operat-
ing lamp current. The I OUT pin has very little bias voltage
change when it is tied to the I CCFL pin as I CCFL is regulated.
The programming current is sourced from the I OUT pin and
sunk by the I CCFL pin.
V CC (Pin 12): This is the supply pin for the LT1186F. The
IC accepts an input voltage range of 3V minimum to 6.5V
maximum with little change in quiescent current (zero
switch current). An internal, low-dropout regulator pro-
vides a 2.4V supply for most of the internal circuitry.
Supply current increases as switch current increases at a
rate approximately 1/50 of switch current. This corre-
sponds to a forced Beta of 50 for the power switch. The IC
incorporates undervoltage lockout by sensing regulator
dropout and locking out switching for input voltages
below 2.5V. Hysteresis is not used to maximize the useful
range of input voltage. The typical input voltage is a 3.3V
or 5V logic supply.
ROYER (Pin 13): This pin connects to the center-tapped
primary of the Royer converter and is used with the BAT
pin in a floating-lamp configuration where lamp current is
controlled by sensing Royer primary-side converter cur-
rent. This pin is the inverting terminal of a high-side
current sense amplifier. The typical quiescent current is
50 μ A into the pin. If the CCFL regulator is not used in a
floating-lamp configuration, tie the Royer and BAT pins
together.
相关PDF资料 |
PDF描述 |
|---|---|
| EPF10K30AQC240-3N | IC FLEX 10KA FPGA 30K 240-PQFP |
| DEM09SN | CONN DSUB RCPT 9 POS SLD CUP |
| 787171-7 | CONN 68POS .05 AMPLMT RECP RTAGL |
| RAC05-12DA-ST | CONV AC/DC 90-264VAC +/-12V 0.2A |
| VI-2NM-CY-S | CONVERTER MOD DC/DC 10V 50W |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LT1186FCS#PBF | 功能描述:IC SWTCH REG CCFL DAC PROG16SOIC RoHS:是 类别:集成电路 (IC) >> PMIC - 照明，镇流器控制器 系列:Bits-to-Nits™ 产品培训模块:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 标准包装:2,500 系列:- 类型:CCFL 控制器 频率:40 ~ 80 kHz 电流 - 电源:5mA 电流 - 输出:- 电源电压:4.5 V ~ 5.5 V 工作温度:-40°C ~ 85°C 封装/外壳:16-SOIC（0.154"，3.90mm 宽） 供应商设备封装:16-SOIC 包装:带卷 (TR) 其它名称:90-3991V+V01 |
| LT1186FCS#TR | 功能描述:IC REG SW CCFL DAC PROG 16SOIC RoHS:否 类别:集成电路 (IC) >> PMIC - 照明，镇流器控制器 系列:Bits-to-Nits™ 产品培训模块:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 标准包装:2,500 系列:- 类型:CCFL 控制器 频率:40 ~ 80 kHz 电流 - 电源:5mA 电流 - 输出:- 电源电压:4.5 V ~ 5.5 V 工作温度:-40°C ~ 85°C 封装/外壳:16-SOIC（0.154"，3.90mm 宽） 供应商设备封装:16-SOIC 包装:带卷 (TR) 其它名称:90-3991V+V01 |
| LT1186FCS#TRPBF | 功能描述:IC SW REG CCFL DAC PROG 16SOIC RoHS:是 类别:集成电路 (IC) >> PMIC - 照明，镇流器控制器 系列:Bits-to-Nits™ 产品培训模块:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 标准包装:2,500 系列:- 类型:CCFL 控制器 频率:40 ~ 80 kHz 电流 - 电源:5mA 电流 - 输出:- 电源电压:4.5 V ~ 5.5 V 工作温度:-40°C ~ 85°C 封装/外壳:16-SOIC（0.154"，3.90mm 宽） 供应商设备封装:16-SOIC 包装:带卷 (TR) 其它名称:90-3991V+V01 |
| LT1186FIS | 功能描述:IC SWTCH REG CCFL DAC PROG16SOIC RoHS:否 类别:集成电路 (IC) >> PMIC - 照明，镇流器控制器 系列:Bits-to-Nits™ 产品培训模块:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 标准包装:2,500 系列:- 类型:CCFL 控制器 频率:40 ~ 80 kHz 电流 - 电源:5mA 电流 - 输出:- 电源电压:4.5 V ~ 5.5 V 工作温度:-40°C ~ 85°C 封装/外壳:16-SOIC（0.154"，3.90mm 宽） 供应商设备封装:16-SOIC 包装:带卷 (TR) 其它名称:90-3991V+V01 |
| LT1186FIS#PBF | 功能描述:IC SW REG CCFL DAC PROG 16SOIC RoHS:是 类别:集成电路 (IC) >> PMIC - 照明，镇流器控制器 系列:Bits-to-Nits™ 产品培训模块:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 标准包装:2,500 系列:- 类型:CCFL 控制器 频率:40 ~ 80 kHz 电流 - 电源:5mA 电流 - 输出:- 电源电压:4.5 V ~ 5.5 V 工作温度:-40°C ~ 85°C 封装/外壳:16-SOIC（0.154"，3.90mm 宽） 供应商设备封装:16-SOIC 包装:带卷 (TR) 其它名称:90-3991V+V01 |
发布紧急采购，3分钟左右您将得到回复。