- 您现在的位置：买卖IC网 > PDF目录8585 > LT1227CN8#PBF (Linear Technology)IC VIDEO CURRNT FEEDBCK AMP 8DIP PDF资料下载
参数资料
| 型号： | LT1227CN8#PBF |
| 厂商： | Linear Technology |
| 文件页数： | 11/12页 |
| 文件大小： | 0K |
| 描述： | IC VIDEO CURRNT FEEDBCK AMP 8DIP |
| 标准包装： | 50 |
| 应用： | 电流反馈 |
| 电路数： | 1 |
| -3db带宽： | 140MHz |
| 转换速率： | 1100 V/µs |
| 电流 - 电源： | 10mA |
| 电流 - 输出 / 通道： | 60mA |
| 电压 - 电源，单路/双路(±)： | 4 V ~ 30 V，±2 V ~ 15 V |
| 安装类型： | 通孔 |
| 封装/外壳： | 8-DIP（0.300"，7.62mm） |
| 供应商设备封装： | 8-PDIP |
| 包装： | 管件 |
| 产品目录页面： | 1318 (CN2011-ZH PDF) |
8
LT1227
U
S
A
O
PPLICATI
WU
U
I FOR ATIO
RF = 1k, RG= 1k, RL = 100
VOUT
Small-Signal Rise Time, AV = +2
and inverting input bias current will change. The offset
voltage changes about 500
V per volt of supply mis-
match. The inverting bias current can change as much as
5.0
A per volt of supply mismatch, though typically the
change is less than 0.5
A per volt.
Slew Rate
The slew rate of a current feedback amplifier is not
independent of the amplifier gain configuration the way
slew rate is in a traditional op amp. This is because both the
input stage and the output stage have slew rate limitations.
In the inverting mode, and for higher gains in the
noninverting mode, the signal amplitude between the
input pins is small and the overall slew rate is that of the
output stage. For gains less than ten in the noninverting
mode, the overall slew rate is limited by the input stage.
The input stage slew rate of the LT1227 is approximately
125V/
s and is set by internal currents and capacitances.
The output slew rate is set by the value of the feedback
resistors and the internal capacitances. At a gain of ten
with a 1k feedback resistor and
±15V supplies, the output
slew rate is typically 1100V/
s. Larger feedback resistors
will reduce the slew rate as will lower supply voltages,
similar to the way the bandwidth is reduced.
The graph of Maximum Undistorted Output vs Frequency
relates the slew rate limitations to sinusoidal inputs for
various gain configurations.
AI01
VOUT
RF = 910, RG= 100, RL = 400
Large-Signal Transient Response, AV = +10
AI02
Capacitance on the Inverting Input
Current feedback amplifiers require resistive feedback
from the output to the inverting input for stable operation.
Take care to minimize the stray capacitance between the
output and the inverting input. Capacitance on the invert-
ing input to ground will cause peaking in the frequency
response (and overshoot in the transient response), but it
does not degrade the stability of the amplifier.
Capacitive Loads
The LT1227 can drive capacitive loads directly when the
proper value of feedback resistor is used. The graph of
Maximum Capacitive Load vs Feedback Resistor should
be used to select the appropriate value. The value shown
is for 5dB peaking when driving a 1k load at a gain of 2. This
is a worst case condition, the amplifier is more stable at
higher gains and driving heavier loads. Alternatively, a
small resistor (10
to 20) can be put in series with the
output to isolate the capacitive load from the amplifier
output. This has the advantage that the amplifier band-
width is only reduced when the capacitive load is present
and the disadvantage that the gain is a function of the load
resistance.
Power Supplies
The LT1227 will operate from single or split supplies from
±2V (4V total) to ±15V (30V total). It is not necessary to
use equal value split supplies, however the offset voltage
相关PDF资料 |
PDF描述 |
|---|---|
| AD669AR-REEL | IC DAC 16BIT MONO VREF 28-SOIC |
| AD817ARZ | IC OPAMP LP HS 8-SOIC |
| AD7840JN | IC DAC 14BIT LC2MOS VOUT 24-DIP |
| AD817ANZ | IC OPAMP HS LP 8-DIP |
| DAC8841FPZ | IC DAC 8BIT OCTAL 2-QUAD 24DIP |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LT1227CS8 | 功能描述:IC VIDEO CURRNT FEEDBK AMP 8SOIC RoHS:否 类别:集成电路 (IC) >> 线性 - 放大器 - 视频放大器和频缓冲器 系列:- 标准包装:1,000 系列:- 应用:驱动器 输出类型:差分 电路数:3 -3db带宽:350MHz 转换速率:1000 V/µs 电流 - 电源:14.5mA 电流 - 输出 / 通道:60mA 电压 - 电源，单路/双路(±):5 V ~ 12 V，±2.5 V ~ 6 V 安装类型:表面贴装 封装/外壳:20-VFQFN 裸露焊盘 供应商设备封装:20-QFN 裸露焊盘（4x4） 包装:带卷 (TR) |
| LT1227CS8#PBF | 功能描述:IC VIDEO CURRNT FEEDBK AMP 8SOIC RoHS:是 类别:集成电路 (IC) >> 线性 - 放大器 - 视频放大器和频缓冲器 系列:- 产品培训模块:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 标准包装:50 系列:- 应用:TFT-LCD 面板：VCOM 驱动器 输出类型:满摆幅 电路数:1 -3db带宽:35MHz 转换速率:40 V/µs 电流 - 电源:3.7mA 电流 - 输出 / 通道:1.3A 电压 - 电源，单路/双路(±):9 V ~ 20 V，±4.5 V ~ 10 V 安装类型:表面贴装 封装/外壳:8-TSSOP，8-MSOP（0.118"，3.00mm 宽）裸露焊盘 供应商设备封装:8-uMax-EP 包装:管件 |
| LT1227CS8#TR | 功能描述:IC AMP VID DIFF CURR FDBK 8SOIC RoHS:否 类别:集成电路 (IC) >> 线性 - 放大器 - 视频放大器和频缓冲器 系列:- 标准包装:1,000 系列:- 应用:驱动器 输出类型:差分 电路数:3 -3db带宽:350MHz 转换速率:1000 V/µs 电流 - 电源:14.5mA 电流 - 输出 / 通道:60mA 电压 - 电源，单路/双路(±):5 V ~ 12 V，±2.5 V ~ 6 V 安装类型:表面贴装 封装/外壳:20-VFQFN 裸露焊盘 供应商设备封装:20-QFN 裸露焊盘（4x4） 包装:带卷 (TR) |
| LT1227CS8#TRPBF | 功能描述:IC VIDEO CURRNT FEEDBK AMP 8SOIC RoHS:是 类别:集成电路 (IC) >> 线性 - 放大器 - 视频放大器和频缓冲器 系列:- 标准包装:1,000 系列:- 应用:驱动器 输出类型:差分 电路数:3 -3db带宽:350MHz 转换速率:1000 V/µs 电流 - 电源:14.5mA 电流 - 输出 / 通道:60mA 电压 - 电源，单路/双路(±):5 V ~ 12 V，±2.5 V ~ 6 V 安装类型:表面贴装 封装/外壳:20-VFQFN 裸露焊盘 供应商设备封装:20-QFN 裸露焊盘（4x4） 包装:带卷 (TR) |
| LT1227CS8PBF | 制造商:Linear Technology 功能描述:Video Amp 140MHz Current Feedback SOIC8 |
发布紧急采购，3分钟左右您将得到回复。