参数资料
型号: LT1245IS8#TRPBF
厂商: Linear Technology
文件页数: 8/16页
文件大小: 0K
描述: IC REG CTRLR ISO PWM CM 8-SOIC
标准包装: 2,500
PWM 型: 电流模式
输出数: 1
频率 - 最大: 500kHz
占空比: 48%
电源电压: 8.2 V ~ 25 V
降压:
升压:
回扫:
反相:
倍增器:
除法器:
Cuk:
隔离:
工作温度: -40°C ~ 100°C
封装/外壳: 8-SOIC(0.154",3.90mm 宽)
包装: 带卷 (TR)
LT1241 Series
A PPLICATI
S I FOR ATIO
Oscillator Discharge Time: t d =
Oscillator Frequency: f OSC =
for various values of R T and C T appear in the Typical
Performance Characteristics section. Frequency and
deadtime can also be calculated using the following
formulas:
Oscillator Rise Time: t r = 0.583 ? RC
3 . 46 ? RC
( 0 . 0164 ) R ? 11 . 73
Oscillator Period: T OSC = t r + t d
1
T OSC
Maximum Duty Cycle:
LT1241, LT1244, LT1245
t r T OSC ? t d
D MAX = =
2 T OSC 2 T OSC
frequency for LT1241, LT1244 and LT1245. The oscillator
of LT1241 series devices will run at frequencies up to
1MHz, allowing 500kHz output switching frequencies for
all devices.
Error Amplifier
The LT1241 series of devices contain a fully compensated
error amplifier with a DC gain of 90dB and a unity-gain
frequency of 1MHz. Phase margin at unity-gain is 80 ° . The
noninverting input is internally committed to a 2.5V refer-
ence point derived from the 5V reference of Pin 8. The
inverting input (Pin 2) and the output (Pin 1) are made
available to the user. The output voltage in a regulator
circuit is normally fed back to the inverting input of the
error amplifier through a resistive divider.
The output of the error amplifier is made available for
external loop compensation. The output current of the
LT1242, LT1243 D MAX =
t r
T OSC
=
T OSC ? t d
T OSC
error amplifier is limited to approximately 0.8mA sourcing
and approximately 6mA sinking. In a current mode PWM
the peak switch current is a function of the output voltage
of the error amplifier. In the LT1241 series devices the
The above formulas will give values that will be accurate
to approximately ± 5%, at the oscillator, over the full
operating frequency range. This is due to the fact that the
oscillator trip levels are constant versus frequency and the
discharge current and initial oscillator frequency are
trimmed. Some fine adjustment may be required to achieve
more accurate results. Once the final R T /C T combination is
selected the oscillator characteristics will be repeatable
from device to device. Note that there will be some slight
differences between maximum duty cycle at the oscillator
and maximum duty cycle at the output due to the finite rise
and fall times of the output.
The output switching frequency will be equal to the
oscillator frequency for LT1242 and LT1243. The output
switching frequency will be equal to one-half the oscillator
8
output of the error amplifier is offset by two diodes (1.4V
at 25 ° C), divided by a factor of three, and fed to the
inverting input of the current sense comparator. For error
amplifier output voltages less than 1.4V the duty cycle of
the output stage will be zero. The maximum offset that can
appear at the current sense input is limited by a 1V clamp.
This occurs when the error amplifier output reaches 4.4V
at 25 ° C.
The output of the error amplifier can be clamped below
4.4V in order to reduce the maximum voltage allowed
across the current sensing resistor to less than 1V. The
supply current will increase by the value of the output
source current when the output voltage of the error
amplifier is clamped.
相关PDF资料
PDF描述
VI-2WP-EW-F1 CONVERTER MOD DC/DC 13.8V 100W
LT1245IS8#TR IC REG CTRLR ISO PWM CM 8-SOIC
GCM24DTAD CONN EDGECARD 48POS R/A .156 SLD
LT1243IS8#TRPBF IC REG CTRLR ISO PWM CM 8-SOIC
GSM15DSEI CONN EDGECARD 30POS .156 EYELET
相关代理商/技术参数
参数描述
LT1245MJ8 制造商:未知厂家 制造商全称:未知厂家 功能描述:Current-Mode SMPS Controller
LT1245MJ8/883 制造商:Linear Technology 功能描述:Current Mode PWM Controller 1A 8-Pin CDIP
LT1245MJ8/883C 制造商:未知厂家 制造商全称:未知厂家 功能描述:Current-Mode SMPS Controller
LT1246 制造商:LINER 制造商全称:Linear Technology 功能描述:1MHz Off-Line Current Mode PWM and DC/DC Converter
LT1246C 制造商:LINER 制造商全称:Linear Technology 功能描述:1MHz Off-Line Current Mode PWM and DC/DC Converter