参数资料
型号: LT1300CS8#TR
厂商: LINEAR TECHNOLOGY CORP
元件分类: 稳压器
英文描述: 0.75 A SWITCHING REGULATOR, 155 kHz SWITCHING FREQ-MAX, PDSO8
封装: SOIC-8
文件页数: 5/8页
文件大小: 219K
代理商: LT1300CS8#TR
5
LT1300
TEST CIRCUITS
Oscillator Test Circuit
OPERATION
U
20
s/DIV
reduced by tying the ILIM pin to ground, causing 15A to
flow through R2 into Q3’s collector. Q3’s current causes
a 10.4mV drop in R2 so that only an additional 7.6mV is
required across R1 to turn off the switch. This corre-
sponds to a 400mA switch current as shown in Figure 2,
trace B. The reduced peak switch current reduces I2R
loses in Q1, L1, C1 and D1. Efficiency can be increased by
doing this provided that the accompanying reduction in
full load output current is acceptable. Lower peak currents
also extend alkaline battery life due to the alkaline cell’s
high internal impedance. Typical operating waveforms are
shown in Figure 3.
Operation of the LT1300 is best understood by referring to
the Block Diagram in Figure 1. When A1’s negative input,
related to the Sense pin voltage by the appropriate resis-
tor-divider ratio, is higher that the 1.25V reference voltage,
A1’s output is low. A2, A3 and the oscillator are turned off,
drawing no current. Only the reference and A1 consume
current, typically 120
A. When the voltage at A1’s nega-
tive input decreases below 1.25V, overcoming A1’s 6mV
hysteresis, A1’s output goes high, enabling the oscillator,
current comparator A2, and driver A3. Quiescent current
increases to 2mA as the device prepares for high current
switching. Q1 then turns on in a controlled saturation for
(nominally) 5.3
s or until current comparator A2 trips,
whichever comes first. After a fixed off-time of (nominally)
1.2
s, Q1 turns on again. The LT1300’s switching causes
current to alternately build up in L1 and dump into capaci-
tor C2 via D1, increasing the output voltage. When the
output is high enough to cause A1’s output to go to low,
switching action ceases. C2 is left to supply current to the
load until VOUT decreases enough to force A1’s output
high, and the entire cycle repeats.
If switch current reaches 1A, causing A2 to trip, switch on-
time is reduced and off-time increases slightly. This allows
continuous mode operation during bursts. Current com-
parator A2 monitors the voltage across 3
resistor R1
which is directly related to inductor L1’s current. Q2’s
collector current is set by the emitter-area ratio to 0.6%
of Q1’s collector current. When R1’s voltage drop exceeds
18mV, corresponding to 1A inductor current, A2’s output
goes high, truncating the on-time portion of the oscillator
cycle and increasing off-time to about 2
s as shown in
Figure 2, trace A. This programmed peak current can be
Figure 3. Burst Mode Operation in Action
TRACE B
500mA/DIV
ILIM PIN
GROUNDED
LT1300 F2
Figure 2. Switch Pin Current With ILIM Floating or Grounded
TRACE A
500mA/DIV
ILIM PIN
OPEN
VOUT
20mV/DIV
AC COUPLED
VSW
5V/DIV
ISW
IA/DIV
20
S/DIV
LT1300 F2
2V
100F
VIN
SEL
SENSE
GND
PGND
SHDN
SW
LT1300
IL
100
5V
fOUT
相关PDF资料
PDF描述
LT1377CN8 1.5 A SWITCHING REGULATOR, 1000 kHz SWITCHING FREQ-MAX, PDIP8
LT1526J883B 0.2 A SWITCHING CONTROLLER, 400 kHz SWITCHING FREQ-MAX, CDIP18
LT1615IS5-1#PBF 0.125 A SWITCHING REGULATOR, PDSO5
LT202A BRUSHLESS DC MOTOR CONTROLLER, 0.75 A, PDSO8
LT260A SPECIALTY ANALOG CIRCUIT, PDSO4
相关代理商/技术参数
参数描述
LT1301 制造商:LINER 制造商全称:Linear Technology 功能描述:Micropower High Efficiency 5V/12V Step-Up DC/DC Converter for Flash Memory
LT1301C 制造商:LINER 制造商全称:Linear Technology 功能描述:Micropower High Efficiency 5V/12V Step-Up DC/DC Converter for Flash Memory
LT1301CN8 功能描述:IC REG BOOST 5V/12V 8DIP RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 标准包装:2,500 系列:- 类型:升压(升压) 输出类型:可调式 输出数:1 输出电压:1.24 V ~ 30 V 输入电压:1.5 V ~ 12 V PWM 型:电流模式,混合 频率 - 开关:600kHz 电流 - 输出:500mA 同步整流器:无 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:8-SOIC(0.154",3.90mm 宽) 包装:带卷 (TR) 供应商设备封装:8-SOIC
LT1301CN8#PBF 功能描述:IC REG BOOST 5V/12V 8DIP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 标准包装:2,500 系列:- 类型:升压(升压) 输出类型:可调式 输出数:1 输出电压:1.24 V ~ 30 V 输入电压:1.5 V ~ 12 V PWM 型:电流模式,混合 频率 - 开关:600kHz 电流 - 输出:500mA 同步整流器:无 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:8-SOIC(0.154",3.90mm 宽) 包装:带卷 (TR) 供应商设备封装:8-SOIC
LT1301CN8PBF 制造商:Linear Technology 功能描述:LT1301CN8PBF