参数资料
型号: LT1300CS8#TRPBF
厂商: Linear Technology
文件页数: 7/8页
文件大小: 0K
描述: IC REG BOOST 3.3V/5V 0.22A 8SOIC
标准包装: 2,500
类型: 升压(升压)
输出类型: 固定
输出数: 1
输出电压: 3.3V,5V
输入电压: 1.8 V ~ 10 V
PWM 型: Burst Mode?
电流 - 输出: 220mA
同步整流器:
工作温度: 0°C ~ 70°C
安装类型: 表面贴装
封装/外壳: 8-SOIC(0.154",3.90mm 宽)
包装: 带卷 (TR)
供应商设备封装: 8-SOIC
LT1300
APPLICATIO N S I N FOR M ATIO N
Table 1. Recommended Inductors
PART NUMBER
DO1608-103
DO3316-223
DO1608-223
CTX10-1
CTX20-1
LQH3C2204K0M00
CD54-100M
CDRH62-220M
CDRH62-100M
GA10-102K
VENDOR
Coilcraft
Coilcraft
Coilcraft
Coiltronics
Coiltronics
Murata-Frie
Sumida
Sumida
Sumida
Gowanda
L ( μ H)
10
22
22
10
20
22
10
22
10
10
DCR ( ? )
0.11
0.050
0.31
0.038
0.175
0.7
0.11
0.38
0.17
0.038
I LIM PIN
Float
Float
Ground
Float
Ground
Ground
Float
Ground
Float
Float
EFFICIENCY 2.5V IN , 5V OUT
50mA LOAD 200mA LOAD
83 83
85 85
85 —
85 85
86 —
81 —
85 85
84 —
81 82
85 86
COMPONENT
HEIGHT (mm)
3.5
5.5
3.5
4.2
4.2
2.0
4.5
3.0
3.0
6.6 Through-Hole
PHONE NUMBER
(708) 639–6400
(407) 241–7876
(404) 436–1300
(708) 956–0666
(716) 532–2234
Inductor Selection
Table 2. Recommended Capacitors
For full output power, the inductor should have a satura-
tion current rating of 1.25A for worst-case current limit,
although it is acceptable to bias an inductor 20% or more
into saturation. Smaller inductors can be used in conjunc-
VENDOR
AVX
Sanyo
Panasonic
SERIES
TPS
OS-CON
HFQ
TYPE
Surface Mount
Through-Hole
Through-Hole
PHONE#
(803)448–9411
(619) 661–6835
(201) 348–5200
tion with the I LIM pin. Efficiency is significantly affected by
inductor DCR. For best efficiency limit the DCR to 0.03 ?
or less. Toroidal types are preferred in some cases due to
their closed design and inherent EMI/RFI superiority.
Recommended inductors are listed in Table 1.
Capacitor Selection
Low ESR capacitors are required for both input and output
of the LT1300. ESR directly affects ripple voltage and
efficiency. For surface mount applications AVX TPS series
tantalum capacitors are recommended. These have been
specially designed for SMPS and have low ESR along with
high surge current ratings. For through-hole application
Sanyo OS-CON capacitors offer extremely low ESR in a
small size. Again, if peak switch current is reduced using
the I LIM pin, capacitor requirements can be relaxed and
smaller, higher ESR units can be used. Low frequency
output ripple can be reduced by adding multiple output
capacitors. If capacitance is reduced, output ripple will
increase. Suggested capacitor sources are listed in Table 2.
Diode Selection
Best performance is obtained with a Schottky rectifier
diode such as the 1N5817. Phillips Components makes
this in surface mount as the PRLL5817. Motorola makes
the MBRS130LT3 which is slightly better and also in
surface mount. For lower output power a 1N4148 can be
used although efficiency will suffer substantially.
Layout Considerations
The LT1300 is a high speed, high current device. The input
capacitor must be no more than 0.2" from V IN (pin 6) and
ground. Connect the PGND and GND (pins 8 and 1)
together under the package. Place the inductor adjacent to
SW (pin 7) and make the switch pin trace as short as
possible. This keeps radiated noise to a minimum.
Information furnished by Linear Technology Corporation is believed to be accurate and reliable.
However, no responsibility is assumed for its use. Linear Technology Corporation makes no represen-
tation that the interconnection of its circuits as described herein will not infringe on existing patent rights.
7
相关PDF资料
PDF描述
LT1301IN8#PBF IC REG BOOST 5V/12V 8DIP
LT1302CS8-5#TRPBF IC REG BOOST 5V 0.6A 8SOIC
LT1303IN8-5#PBF IC REG BOOST 5V 0.2A 8DIP
LT1304CS8-5#TRPBF IC REG BOOST 5V 0.2A 8SOIC
LT1305CS8#TRPBF IC REG BOOST 5V 0.4A 8SOIC
相关代理商/技术参数
参数描述
LT1301 制造商:LINER 制造商全称:Linear Technology 功能描述:Micropower High Efficiency 5V/12V Step-Up DC/DC Converter for Flash Memory
LT1301C 制造商:LINER 制造商全称:Linear Technology 功能描述:Micropower High Efficiency 5V/12V Step-Up DC/DC Converter for Flash Memory
LT1301CN8 功能描述:IC REG BOOST 5V/12V 8DIP RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 标准包装:2,500 系列:- 类型:升压(升压) 输出类型:可调式 输出数:1 输出电压:1.24 V ~ 30 V 输入电压:1.5 V ~ 12 V PWM 型:电流模式,混合 频率 - 开关:600kHz 电流 - 输出:500mA 同步整流器:无 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:8-SOIC(0.154",3.90mm 宽) 包装:带卷 (TR) 供应商设备封装:8-SOIC
LT1301CN8#PBF 功能描述:IC REG BOOST 5V/12V 8DIP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 标准包装:2,500 系列:- 类型:升压(升压) 输出类型:可调式 输出数:1 输出电压:1.24 V ~ 30 V 输入电压:1.5 V ~ 12 V PWM 型:电流模式,混合 频率 - 开关:600kHz 电流 - 输出:500mA 同步整流器:无 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:8-SOIC(0.154",3.90mm 宽) 包装:带卷 (TR) 供应商设备封装:8-SOIC
LT1301CN8PBF 制造商:Linear Technology 功能描述:LT1301CN8PBF