参数资料
型号: LT1307CMS8
厂商: Linear Technology
文件页数: 9/20页
文件大小: 0K
描述: IC REG BOOST 3.3V/5V 0.1A 8MSOP
标准包装: 50
类型: 升压(升压)
输出类型: 固定
输出数: 1
输出电压: 3.3V,5V
输入电压: 1 V ~ 5 V
PWM 型: 电流模式,混合
频率 - 开关: 600kHz
电流 - 输出: 100mA
同步整流器:
工作温度: -40°C ~ 85°C
安装类型: 表面贴装
封装/外壳: 8-TSSOP,8-MSOP(0.118",3.00mm 宽)
包装: 管件
供应商设备封装: 8-MSOP
LT1307/LT1307B
APPLICATIO S I FOR ATIO
Trace B. Similarly, Figure 4 details the two circuits with a
load step from 5mA to 45mA with a 1.5V input.
The LT1307B also can be used in lower current applica-
tions where a clean, low ripple output is needed. Figure 5
details transient response of a single cell to 3.3V con-
verter, using an inductor value of 100 μ H. This high induc-
tance minimizes ripple current, allowing the LT1307B to
regulate without skipping cycles. As the load current is
stepped from 5mA to 10mA, the output voltage responds
cleanly. Note that the V C pin loop compensation has been
made more conservative (increased C, decreased R).
quite evident, as is this particular device’s 575kHz switch-
ing frequency (nominal switching frequency is 600kHz).
Note, however, the absence of significant energy at 455kHz.
Figure 7’s plot reduces the frequency span from 255kHz to
655kHz with a 455kHz center. Burst Mode low frequency
ripple creates sidebands around the 575kHz switching
fundamental. These sidebands have low signal amplitude
at 455kHz, measuring – 55dBmV RMS . As load current is
further reduced, the Burst Mode frequency decreases.
This spaces the sidebands around the switching fre-
quency closer together, moving spectral energy further
40
RBW = 100Hz
I L 10mA
V OUT
100mV/DIV
AC COUPLED
I L
20mA/DIV
5mA
30
20
10
0
–10
–20
–30
V IN = 1.25V
V OUT = 3.3V
1ms/DIV
1307 F05
–40
–50
Figure 5. Increasing L to 100 μ H, Along with R C = 36k,
C C = 20nF and C OUT = 10 μ F, Low Noise Performance of
LT1307B Can Be Realized at Light Loads of 5mA to 10mA
–60
1
10 100
FREQUENCY (kHz)
1000
1307 F06
At light loads, the LT1307B will begin to skip alternate
cycles. The load point at which this occurs can be de-
creased by increasing the inductor value. However, output
ripple will continue to be significantly less than the LT1307
Figure 6. Spectral Noise Plot of 3.3V Converter Delivering
5mA Load. Burst Mode Fundamental at 5.1kHz is 23dBmV RMS
or 14mV RMS
output ripple. Further, the LT1307B can be forced into
micropower mode, where I Q falls from 1mA to 50 μ A by
pulling down V C to 0.3V or less externally.
DC/DC CONVERTER NOISE CONSIDERATIONS
–20
–25
–30
–35
–40
–45
R BW  = 100H z
Switching regulator noise is a significant concern in many
communications systems. The LT1307 is designed to
keep noise energy out of the sensitive 455kHz band at all
load levels while consuming only 60 μ W to 100 μ W at no
load. At light load levels, the device is in Burst Mode,
causing low frequency ripple to appear at the output.
–50
–55
–60
–65
–70
255
455
FREQUENCY (kHz)
655
1307 F07
Figure 6 details spectral noise directly at the output of
Figure 1’s circuit in a 1kHz to 1MHz bandwidth. The
converter supplies a 5mA load from a 1.25V input. The
Figure 7. Span Centered at 455kHz Shows – 55dBmV RMS
(1.8 μ V RMS ) at 455kHz. Burst Mode Creates Sidebands 5.1kHz
Apart Around the Switching Frequency Fundamental of 575kHz
Burst Mode fundamental at 5.1kHz and its harmonics are
1307fa
9
相关PDF资料
PDF描述
LT1307BCMS8 IC REG BOOST 3.3V/5V 0.1A 8MSOP
VI-J2K-EZ CONVERTER MOD DC/DC 40V 25W
LTC1144CS8 IC REG SWITCHED CAP INV 8SOIC
VI-J2J-EZ CONVERTER MOD DC/DC 36V 25W
LT3467IS6#TRMPBF IC REG BOOST ADJ 1.1A SOT23-6
相关代理商/技术参数
参数描述
LT1307CMS8#PBF 功能描述:IC REG BOOST 3.3V/5V 0.1A 8MSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 标准包装:2,500 系列:- 类型:升压(升压) 输出类型:可调式 输出数:1 输出电压:1.24 V ~ 30 V 输入电压:1.5 V ~ 12 V PWM 型:电流模式,混合 频率 - 开关:600kHz 电流 - 输出:500mA 同步整流器:无 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:8-SOIC(0.154",3.90mm 宽) 包装:带卷 (TR) 供应商设备封装:8-SOIC
LT1307CMS8#TR 功能描述:IC REG BOOST 3.3V/5V 0.1A 8MSOP RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 标准包装:2,500 系列:- 类型:升压(升压) 输出类型:可调式 输出数:1 输出电压:1.24 V ~ 30 V 输入电压:1.5 V ~ 12 V PWM 型:电流模式,混合 频率 - 开关:600kHz 电流 - 输出:500mA 同步整流器:无 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:8-SOIC(0.154",3.90mm 宽) 包装:带卷 (TR) 供应商设备封装:8-SOIC
LT1307CMS8#TRPBF 功能描述:IC REG BOOST 3.3V/5V 0.1A 8MSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 标准包装:2,500 系列:- 类型:升压(升压) 输出类型:可调式 输出数:1 输出电压:1.24 V ~ 30 V 输入电压:1.5 V ~ 12 V PWM 型:电流模式,混合 频率 - 开关:600kHz 电流 - 输出:500mA 同步整流器:无 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:8-SOIC(0.154",3.90mm 宽) 包装:带卷 (TR) 供应商设备封装:8-SOIC
LT1307CN8 功能描述:IC REG BOOST 3.3V/5V 0.1A 8DIP RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 标准包装:2,500 系列:- 类型:升压(升压) 输出类型:可调式 输出数:1 输出电压:1.24 V ~ 30 V 输入电压:1.5 V ~ 12 V PWM 型:电流模式,混合 频率 - 开关:600kHz 电流 - 输出:500mA 同步整流器:无 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:8-SOIC(0.154",3.90mm 宽) 包装:带卷 (TR) 供应商设备封装:8-SOIC
LT1307CN8#PBF 功能描述:IC REG BOOST 3.3V/5V 0.1A 8DIP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 标准包装:2,500 系列:- 类型:升压(升压) 输出类型:可调式 输出数:1 输出电压:1.24 V ~ 30 V 输入电压:1.5 V ~ 12 V PWM 型:电流模式,混合 频率 - 开关:600kHz 电流 - 输出:500mA 同步整流器:无 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:8-SOIC(0.154",3.90mm 宽) 包装:带卷 (TR) 供应商设备封装:8-SOIC