参数资料
型号: LT1330CG
厂商: Linear Technology
文件页数: 8/10页
文件大小: 0K
描述: IC TXRX 5V RS232 W/3VLOGC 28SSOP
标准包装: 47
类型: 收发器
驱动器/接收器数: 3/5
规程: RS232
电源电压: 4.5 V ~ 5.5 V
安装类型: 表面贴装
封装/外壳: 28-SSOP(0.209",5.30mm 宽)
供应商设备封装: 28-SSOP
包装: 管件
LT1330
7
1330fb
ESD PROTECTION
The RS232 line inputs of the LT1330 have on-chip protection
from ESD transients up to ±10kV. The protection structures
act to divert the static discharge safely to system ground.
In order for the ESD protection to function effectively,
the power supply and ground pins of the LT1330 must
be connected to ground through low impedances. The
power supply decoupling capacitors and charge pump
storage capacitors provide this low impedance in normal
application of the circuit. The only constraint is that low
ESR capacitors must be used for bypassing and charge
storage. ESD testing must be done with pins VCC, VL, V+,
V , and GND shorted to ground or connected with low
ESR capacitors.
1330 TC01
5V VCC
1μF
0.2μF
0.1μF
RS232
LINE PINS
PROTECTED
TO ±10kV
LT1330
1
2
3
4
5
6
7
8
9
10
11
12
13
14
DRIVER 1 OUT
RX1 IN
DRIVER 2 OUT
RX2 IN
RX3 IN
RX4 IN
DRIVER 3 OUT
RX5 IN (LOW-Q)
ON/OFF
3V VL
28
27
26
25
24
23
22
21
20
19
18
17
16
15
0.2μF
DRIVER 1 IN
RX1 OUT
DRIVER 2 IN
RX2 OUT
RX3 OUT
RX4 OUT
DRIVER 3 IN
RX5 OUT (LOW-Q)
V
V+
0.1μF
GND
DRIVER DISABLE
0.1μF
ESD Test Circuit
APPLICATIONS INFORMATION
Storage Capacitor Selection
The V+ and V storage capacitors must be chosen care-
fully to insure low ripple and stable operation. The LT1330
charge pump operates in a power efcient Burst Mode
operation. When storage capacitor voltage drops below
a preset threshold, the oscillator is gated on until V+ and
Vare boosted up to levels exceeding a second threshold.
The oscillator then turns off, and current is supplied from
the V+ and V storage capacitors.
The Vpotential is monitored to control charge pump
operation. It is therefore important to insure lower V+ ripple
than V ripple, or erratic operation of the charge pump will
result. Proper operation is insured in most applications
by choosing the V+ lter capacitor to be at least 5 times
the Vlter capacitor value. If V+ is more heavily loaded
than V, a larger ratio may be needed.
The V lter capacitor should be selected to obtain low
ripple when the drivers are loaded, forcing the charge
pump into continuous mode. A minimum value 0.1μF is
suggested.
Do not attempt to reduce Vripple when the charge pump
is in discontinuous Burst Mode operation. The ripple in this
mode is determined by internal comparator thresholds.
Larger storage capacitor values increase the burst period,
and do not reduce ripple amplitude.
Power Saving Operational Modes
The LT1330 has both shutdown and driver disable operating
modes. These operating modes can optimize power
consumption based upon applications needs.
The On/Off shutdown control turns off all circuitry except
for Low-Q RX5. When RX5 detects a signal, this information
can be used to wake up the system for full operation.
If more than one line must be monitored, the driver
disable mode provides a power efcient operating option.
The driver disable mode turns off the charge pump and
RS232 drivers, but keeps all ve receivers active. Power
consumption in driver disable mode is 3mA from VCC.
Burst Mode is a registered trademark of Linear Technology Corporation.
相关PDF资料
PDF描述
IDT72241L10J8 IC FIFO 2048X18 SYNC 10NS 32PLCC
LTC2222IUK#TR IC ADC 12BIT 105MSPS SAMPL 48QFN
LT1341CG IC TXRX 5V RS232 W/SHTDWN 28SSOP
VI-B4Z-MV-F1 CONVERTER MOD DC/DC 2V 60W
LTC2222IUK#PBF IC ADC 12BIT 105MSPS SAMPL 48QFN
相关代理商/技术参数
参数描述
LT1330CG#PBF 功能描述:IC TXRX 5V RS232 W/3VLOGC 28SSOP RoHS:是 类别:集成电路 (IC) >> 接口 - 驱动器,接收器,收发器 系列:- 标准包装:27 系列:- 类型:收发器 驱动器/接收器数:3/3 规程:RS232,RS485 电源电压:4.75 V ~ 5.25 V 安装类型:表面贴装 封装/外壳:28-SOIC(0.295",7.50mm 宽) 供应商设备封装:28-SOIC 包装:管件
LT1330CG#TR 功能描述:IC TXRX 5V RS232 3V LOGIC 28SSOP RoHS:否 类别:集成电路 (IC) >> 接口 - 驱动器,接收器,收发器 系列:- 标准包装:27 系列:- 类型:收发器 驱动器/接收器数:3/3 规程:RS232,RS485 电源电压:4.75 V ~ 5.25 V 安装类型:表面贴装 封装/外壳:28-SOIC(0.295",7.50mm 宽) 供应商设备封装:28-SOIC 包装:管件
LT1330CG#TRPBF 功能描述:IC TXRX 5V RS232 W/3VLOGC 28SSOP RoHS:是 类别:集成电路 (IC) >> 接口 - 驱动器,接收器,收发器 系列:- 标准包装:27 系列:- 类型:收发器 驱动器/接收器数:3/3 规程:RS232,RS485 电源电压:4.75 V ~ 5.25 V 安装类型:表面贴装 封装/外壳:28-SOIC(0.295",7.50mm 宽) 供应商设备封装:28-SOIC 包装:管件
LT1330CJ 制造商:未知厂家 制造商全称:未知厂家 功能描述:Transceiver
LT1330CJW 制造商:LINER 制造商全称:Linear Technology 功能描述:5V RS232 Transceiver with 3V Logic Interface and One Receiver Active in Shutdown