- 您现在的位置：买卖IC网 > PDF目录13861 > LT1506IS8-3.3#TRPBF (Linear Technology)IC REG BUCK 3.3V 4.5A 8SOIC PDF资料下载
参数资料
| 型号： | LT1506IS8-3.3#TRPBF |
| 厂商： | Linear Technology |
| 文件页数： | 9/24页 |
| 文件大小： | 0K |
| 描述： | IC REG BUCK 3.3V 4.5A 8SOIC |
| 标准包装： | 2,500 |
| 类型： | 降压（降压） |
| 输出类型： | 固定 |
| 输出数： | 1 |
| 输出电压： | 3.3V |
| 输入电压： | 4 V ~ 15 V |
| PWM 型： | 电流模式 |
| 频率 - 开关： | 500kHz |
| 电流 - 输出： | 4.5A |
| 同步整流器： | 无 |
| 工作温度： | -40°C ~ 125°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 8-SOIC（0.154"，3.90mm 宽） |
| 包装： | 带卷 (TR) |
| 供应商设备封装： | 8-SOIC |
LT1506
APPLICATIO N S I N FOR M ATIO N
I OUT(MAX) = ( V OUT ) ( V IN ? V OUT )
2 ( )( )( )
Continuous Mode L f V
The internal circuitry which forces reduced switching
frequency also causes current to flow out of the feedback
pin when output voltage is low. The equivalent circuitry is
shown in Figure 2. Q1 is completely off during normal
operation. If the FB pin falls below 1V, Q1 begins to
conduct current and reduces frequency at the rate of
approximately 5kHz/ μ A. To ensure adequate frequency
foldback (under worst-case short-circuit conditions), the
external divider Thevinin resistance must be low enough
to pull 150 μ A out of the FB pin with 0.6V on the pin (R DIV
≤ 4k). The net result is that reductions in frequency and
finite inductor size, maximum load current is reduced by
one-half peak-to-peak inductor current. The following
formula assumes continuous mode operation, implying
that the term on the right is less than one-half of I P .
I P ?
IN
For the conditions above and L = 3.3 μ H,
2 ? 3 . 3 ? 10 ? ?? 500 ? 10 ? ()
currentlimitareaffectedbyoutputvoltagedividerimped-
ance. Although divider impedance is not critical, caution
should be used if resistors are increased beyond the
suggested values and short-circuit conditions will occur
I OUT ( MAX ) = 4 . 3 ?
( 5 ) ( 8 ? 5 )
? 6 3
2 ? 3 . 3 ? 10 ? ?? 500 ? 10 ? ( 15 )
V OUT ( V IN ? V OUT )
2 ( )( )( )
with high input voltage. High frequency pickup will
increase and the protection accorded by frequency and
current foldback will decrease.
MAXIMUM OUTPUT LOAD CURRENT
Maximum load current for a buck converter is limited by
the maximum switch current rating (I P ) of the LT1506.
This current rating is 4.5A up to 50% duty cycle (DC),
decreasing to 3.7A at 80% duty cycle. This is shown
graphically in Typical Performance Characteristics and as
shown in the formula below:
I P = 4.5A for DC ≤ 50%
I P = 3.21 + 5.95(DC) – 6.75(DC) 2 for 50% < DC < 90%
DC = Duty cycle = V OUT /V IN
Example: with V OUT = 5V, V IN = 8V; DC = 5/8 = 0.625, and;
I SW(MAX) = 3.21 + 5.95(0.625) – 6.75(0.625) 2 = 4.3A
Current rating decreases with duty cycle because the
LT1506 has internal slope compensation to prevent cur-
rent mode subharmonic switching. For more details, read
Application Note 19. The LT1506 is a little unusual in this
regard because it has nonlinear slope compensation which
gives better compensation with less reduction in current
limit.
= 4 . 3 ? 0 . 57 = 3 . 73 A
At V IN = 15V, duty cycle is 33%, so I P is just equal to a fixed
4.5A, and I OUT(MAX) is equal to:
4 . 5 ? ( 5 ) ( 15 ? 5 )
? 6 3
= 4 . 5 ? 1 . 01 = 3 . 49 A
Note that there is less load current available at the higher
input voltage because inductor ripple current increases.
This is not always the case. Certain combinations of
inductor value and input voltage range may yield lower
available load current at the lowest input voltage due to
reduced peak switch current at high duty cycles. If load
current is close to the maximum available, please check
maximum available current at both input voltage ex-
tremes. To calculate actual peak switch current with a
given set of conditions, use:
I SW ( PEAK ) = I OUT + L f V
IN
Maximum load current would be equal to maximum
switch current for an infinitely large inductor, but with
9
相关PDF资料 |
PDF描述 |
|---|---|
| LT1506IS8-3.3#TR | IC REG BUCK 3.3V 4.5A 8SOIC |
| MAX6716AUTTID3+T | IC SUPERVISOR MPU SOT23-6 |
| LT1374IT7 | IC REG BUCK ADJ 4.5A TO220-7 |
| LT1270CT | IC REG MULTI CONFIG 8A TO220-5 |
| LT1170CT | IC REG MULTI CONFIG ADJ TO220-5 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LT1507 | 制造商:LINER 制造商全称:Linear Technology 功能描述:500kHz Monolithic Buck Mode Switching Regulator |
| LT1507C | 制造商:LINER 制造商全称:Linear Technology 功能描述:500kHz Monolithic Buck Mode Switching Regulator |
| LT1507CN8 | 功能描述:IC REG BUCK ADJ 1.5A 8DIP RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 标准包装:2,500 系列:- 类型:降压（降压） 输出类型:固定 输出数:1 输出电压:1.2V，1.5V，1.8V，2.5V 输入电压:2.7 V ~ 20 V PWM 型:- 频率 - 开关:- 电流 - 输出:50mA 同步整流器:是 工作温度:-40°C ~ 125°C 安装类型:表面贴装 封装/外壳:10-TFSOP，10-MSOP（0.118"，3.00mm 宽）裸露焊盘 包装:带卷 (TR) 供应商设备封装:10-MSOP 裸露焊盘 |
| LT1507CN8#PBF | 功能描述:IC REG BUCK ADJ 1.5A 8DIP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 标准包装:20 系列:SIMPLE SWITCHER® 类型:降压（降压） 输出类型:固定 输出数:1 输出电压:12V 输入电压:4 V ~ 60 V PWM 型:电压模式 频率 - 开关:52kHz 电流 - 输出:1A 同步整流器:无 工作温度:-40°C ~ 125°C 安装类型:通孔 封装/外壳:16-DIP（0.300"，7.62mm） 包装:管件 供应商设备封装:16-DIP 其它名称:*LM2575HVN-12LM2575HVN-12 |
| LT1507CN8-3.3 | 功能描述:IC REG BUCK 3.3V 1.5A 8DIP RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 标准包装:2,500 系列:- 类型:降压（降压） 输出类型:固定 输出数:1 输出电压:1.2V，1.5V，1.8V，2.5V 输入电压:2.7 V ~ 20 V PWM 型:- 频率 - 开关:- 电流 - 输出:50mA 同步整流器:是 工作温度:-40°C ~ 125°C 安装类型:表面贴装 封装/外壳:10-TFSOP，10-MSOP（0.118"，3.00mm 宽）裸露焊盘 包装:带卷 (TR) 供应商设备封装:10-MSOP 裸露焊盘 |
发布紧急采购，3分钟左右您将得到回复。