- 您现在的位置：买卖IC网 > PDF目录15991 > LT1510CGN#TRPBF (Linear Technology)IC BATT CHARGER CONST V/I 16SSOP PDF资料下载
参数资料
| 型号： | LT1510CGN#TRPBF |
| 厂商： | Linear Technology |
| 文件页数： | 6/16页 |
| 文件大小： | 0K |
| 描述： | IC BATT CHARGER CONST V/I 16SSOP |
| 标准包装： | 2,500 |
| 功能： | 充电管理 |
| 电池化学： | 锂离子，镍镉，镍氢 |
| 电源电压： | 6.2 V ~ 28 V |
| 工作温度： | 0°C ~ 70°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 16-SSOP（0.154"，3.90mm 宽） |
| 供应商设备封装： | 16-SSOP |
| 包装： | 带卷 (TR) |
LT1510/LT1510-5
TYPICAL PERFOR M A N CE CHARACTERISTICS
50
Switch Current vs Boost Current
vs Boost Voltage
2.470
Reference Voltage vs
Temperature
96
V BOOST vs
Maximum Duty Cycle
45
V CC = 16V
95
40
35
30
25
20
15
10
5
V BOOST = 38V
28V
18V
2.468
2.466
2.464
2.462
2.460
94
93
92
91
90
89
88
87
0
0 0.2 0.4 0.6 0.8 1.0 1.2 1.4 1.6 1.8 2.0
2.458
0
25
50 75 100
125
150
86
2
4
6
8
10 12 14 16 18 20 22
SWITCH CURRENT (A)
PI N FU N CTIO N S
1510 G07
TEMPERATURE ( ° C)
1510 G14
V BOOST (V)
LT1510 ? TPC15
GND: Ground Pin.
SW: Switch Output. The Schottky catch diode must be
placed with very short lead length in close proximity to SW
pin and GND.
V CC : Supply for the Chip. For good bypass, a low ESR
capacitor of 10 μ F or higher is required, with the lead length
kept to a minimum. V CC should be between 8V and 28V
and at least 2V higher than V BAT for V BAT less than 10V, and
2.5V higher than V BAT for V BAT greater than 10V. Under-
voltage lockout starts and switching stops when V CC goes
below 7V. Note that there is a parasitic diode inside from
SW pin to V CC pin. Do not force V CC below SW by more
than 0.7V with battery present. All V CC pins should be
shorted together close to the pins.
BOOST: This pin is used to bootstrap and drive the switch
power NPN transistor to a low on-voltage for low power
dissipation. In normal operation, V BOOST = V CC + V BAT
when switch is on. Maximum allowable V BOOST is 55V.
SENSE: Current Amplifier CA1 Input. Sensing can be at
either terminal of the battery. Note that current sense
resistor R S1 (0.08 ? ) is between Sense and BAT pins.
6
BAT: Current Amplifier CA1 Input.
PROG: This pin is for programming the charging current
and for system loop compensation. During normal opera-
tion, V PROG stays close to 2.465V. If it is shorted to GND
the switching will stop. When a microprocessor-controlled
DAC is used to program charging current, it must be
capable of sinking current at a compliance up to 2.465V.
V C : This is the control signal of the inner loop of the current
mode PWM. Switching starts at 0.7V and higher V C
corresponds to higher charging current in normal opera-
tion. A capacitor of at least 0.1 μ F to GND filters out noise
and controls the rate of soft start. To shut down switching,
pull this pin low. Typical output current is 30 μ A.
OVP: This is the input to the amplifier VA with a threshold
of 2.465V. Typical input current is about 50nA into pin. For
charging lithium-ion batteries, VA monitors the battery
voltage and reduces charging current when battery volt-
age reaches the preset value. If it is not used, the OVP pin
should be grounded.
相关PDF资料 |
PDF描述 |
|---|---|
| SSL0.75SV | 3/4" STAINLESS STEEL XC 50' |
| DS1233MS-5+ | IC ECONORESET 5V(MC33164)8-SOIC |
| DS1706TEUA+ | IC MICROMONITOR 3.3V 5% 8-USOP |
| DS1232LPN | IC MICRO MONITOR LP IND 8-DIP |
| DS1232LPS+ | IC MICRO MONITOR LP 16-SOIC |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LT1510CN | 功能描述:IC BATT CHARGER CONST V/I 16-DIP RoHS:否 类别:集成电路 (IC) >> PMIC - 电池管理 系列:- 产品培训模块:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 标准包装:2,500 系列:- 功能:电池监控器 电池化学:碱性，锂离子，镍镉，镍金属氢化物 电源电压:1 V ~ 5.5 V 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:SOT-23-6 供应商设备封装:SOT-6 包装:带卷 (TR) |
| LT1510CN#PBF | 功能描述:IC BATT CHARGER CONST V/I 16-DIP RoHS:是 类别:集成电路 (IC) >> PMIC - 电池管理 系列:- 产品培训模块:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 标准包装:2,500 系列:- 功能:电池监控器 电池化学:碱性，锂离子，镍镉，镍金属氢化物 电源电压:1 V ~ 5.5 V 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:SOT-23-6 供应商设备封装:SOT-6 包装:带卷 (TR) |
| LT1510CS | 功能描述:IC BATT CHARGER CONST V/I 16SOIC RoHS:否 类别:集成电路 (IC) >> PMIC - 电池管理 系列:- 产品培训模块:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 标准包装:2,500 系列:- 功能:电池监控器 电池化学:碱性，锂离子，镍镉，镍金属氢化物 电源电压:1 V ~ 5.5 V 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:SOT-23-6 供应商设备封装:SOT-6 包装:带卷 (TR) |
| LT1510CS#PBF | 功能描述:IC BATT CHARGER CONST V/I 16SOIC RoHS:是 类别:集成电路 (IC) >> PMIC - 电池管理 系列:- 其它有关文件:STC3100 View All Specifications 特色产品:STC3100 - Battery Monitor IC 标准包装:4,000 系列:- 功能:燃料，电量检测计/监控器 电池化学:锂离子（Li-Ion） 电源电压:2.7 V ~ 5.5 V 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:8-TSSOP，8-MSOP（0.118"，3.00mm 宽） 供应商设备封装:8-MiniSO 包装:带卷 (TR) 其它名称:497-10526-2 |
| LT1510CS#PBF | 制造商:Linear Technology 功能描述:Battery Management IC 制造商:Linear Technology 功能描述:IC, BATTERY CHARGER, 1.5A, SOIC-16 |
发布紧急采购，3分钟左右您将得到回复。