参数资料
型号: LT1571EGN-5#TRPBF
厂商: Linear Technology
文件页数: 10/16页
文件大小: 0K
描述: IC CHARGER BATT CONST V/I 16SSOP
标准包装: 2,500
功能: 充电管理
电池化学: 铅酸,锂离子,镍镉,镍氢
电源电压: 8 V ~ 26 V
工作温度: -40°C ~ 85°C
安装类型: 表面贴装
封装/外壳: 16-SSOP(0.154",3.90mm 宽)
供应商设备封装: 16-SSOP
包装: 带卷 (TR)
LT1571 Series
APPLICATIO S I FOR ATIO
Lithium-Ion Charging
The circuit in Figure 4 uses the 28-pin LT1571-2 to charge
lithium-ion batteries at a constant 1A until the battery
voltage reaches 8.4V preset battery voltage. The charger
will then automatically go into a constant-voltage mode
with current decreasing to near zero over time as the
battery reaches full charge.
Lithium-Ion Charge Completion
CAP pin to filter out the switching noise and a pull-up
resistor is also needed at FLAG pin.
Charge Termination Flag Threshold Setting
The charge termination flag threshold can be reduced
from the default 20% level to as low as 7.5% of the
programmed full charge current. This is done by adding a
resistor R CAP from the CAP pin to ground (see Figure 5).
The formula for selecting the R CAP resistor is:
Some battery manufacturers recommend termination of
constant-voltage float mode after charge current has
dropped below a specified level (typically around 10% to
20% of the full current) and a further time-out period of 30
Threshold = 0 . 20 – ( 1 . 331 )
or
R PROG
R CAP
minutes to 90 minutes has elapsed. Check with manufac-
turer for details. The LT1571 provides a signal at the FLAG
pin when the charger is in voltage mode and charge
R CAP =
( 1 . 331 ) R PROG
0 . 20 – Threshold
current has reduced to approximately 20% of full current.
Note that full current is (2.465V × 2000)/R PROG . Compara-
tor E6 in the Block Diagram compares the charge current
sample I PROG to the output current I VA voltage amplifier
VA. When the charge current drops to 20% of full current,
R PROG is the charge current setting resistor.
LT1571
CAP
I PROG will be equal to 0.25 I VA and the open-collector
output V FLAG will go low. This signal can be used to start
0.1 μ F
R CAP
an external timer or to terminate the charge. When this
feature is used, a capacitor of at least 0.1 μ F is required at
1571 F05
Figure 5. Reducing Charge Termination Threshold
D1
MBRM120T3
D3
MBRM120T3
V IN
C1
0.22 μ F
SW
LT1571-2
V CC
C IN *
10 μ F
11V
TO 26V
L1**
33 μ H
D2
MMBD914L
BOOST
PROG
0.3 μ F
1 μ F
4.93k
100k
SENSE
CAP
V C
1k
300 ?
0.1 μ F
SELECT
GND
FLAG
BAT
BAT2
+
C OUT
22 μ F
+
8.4V
TANT
NOTE: COMPLETE LITHIUM-ION CHARGER
* TOKIN OR MARCON CERAMIC SURFACE MOUNT
** COILTRONICS CTX33-2
1571 F04
Figure 4. 200kHz Charging Lithium Batteries (Efficiency at 1A > 87%)
10
相关PDF资料
PDF描述
415-0009-030 CABLE SMB-RA/SMB-RA 30" RG-179
63RX30330MG412.5X25 CAP ALUM 330UF 63V 20% RADIAL
LT1571EGN-5#TR IC CHARGER BATT CONST V/I 16SSOP
MAX824MEUK+T IC SUPERVISOR MPU SOT23-5
415-0014-030 CABLE MCX/MCX 30" RG-178
相关代理商/技术参数
参数描述
LT1572 制造商:LINER 制造商全称:Linear Technology 功能描述:100kHz, 1.25A Switching Regulator with Catch Diode
LT1572CS 功能描述:IC REG MULTI CONFIG 1.25A 16SOIC RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 标准包装:2,500 系列:- 类型:降压(降压) 输出类型:固定 输出数:1 输出电压:1.2V,1.5V,1.8V,2.5V 输入电压:2.7 V ~ 20 V PWM 型:- 频率 - 开关:- 电流 - 输出:50mA 同步整流器:是 工作温度:-40°C ~ 125°C 安装类型:表面贴装 封装/外壳:10-TFSOP,10-MSOP(0.118",3.00mm 宽)裸露焊盘 包装:带卷 (TR) 供应商设备封装:10-MSOP 裸露焊盘
LT1572CS#PBF 功能描述:IC REG MULTI CONFIG 1.25A 16SOIC RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 标准包装:2,500 系列:- 类型:降压(降压) 输出类型:固定 输出数:1 输出电压:1.2V,1.5V,1.8V,2.5V 输入电压:2.7 V ~ 20 V PWM 型:- 频率 - 开关:- 电流 - 输出:50mA 同步整流器:是 工作温度:-40°C ~ 125°C 安装类型:表面贴装 封装/外壳:10-TFSOP,10-MSOP(0.118",3.00mm 宽)裸露焊盘 包装:带卷 (TR) 供应商设备封装:10-MSOP 裸露焊盘
LT1572CS#TR 功能描述:IC REG MULTI CONFIG 1.25A 16SOIC RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 标准包装:2,500 系列:- 类型:降压(降压) 输出类型:固定 输出数:1 输出电压:1.2V,1.5V,1.8V,2.5V 输入电压:2.7 V ~ 20 V PWM 型:- 频率 - 开关:- 电流 - 输出:50mA 同步整流器:是 工作温度:-40°C ~ 125°C 安装类型:表面贴装 封装/外壳:10-TFSOP,10-MSOP(0.118",3.00mm 宽)裸露焊盘 包装:带卷 (TR) 供应商设备封装:10-MSOP 裸露焊盘
LT1572CS#TRPBF 功能描述:IC REG MULTI CONFIG 1.25A 16SOIC RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 标准包装:2,500 系列:- 类型:降压(降压) 输出类型:固定 输出数:1 输出电压:1.2V,1.5V,1.8V,2.5V 输入电压:2.7 V ~ 20 V PWM 型:- 频率 - 开关:- 电流 - 输出:50mA 同步整流器:是 工作温度:-40°C ~ 125°C 安装类型:表面贴装 封装/外壳:10-TFSOP,10-MSOP(0.118",3.00mm 宽)裸露焊盘 包装:带卷 (TR) 供应商设备封装:10-MSOP 裸露焊盘