- 您现在的位置：买卖IC网 > PDF目录377712 > LT1680IN (LINEAR TECHNOLOGY CORP) High Power DC/DC Step-Up Controller PDF资料下载
参数资料
| 型号： | LT1680IN |
| 厂商： | LINEAR TECHNOLOGY CORP |
| 元件分类： | 稳压器 |
| 英文描述： | High Power DC/DC Step-Up Controller |
| 中文描述： | SWITCHING CONTROLLER, 200 kHz SWITCHING FREQ-MAX, PDIP16 |
| 封装： | 0.300 INCH, PLASTIC, DIP-16 |
| 文件页数： | 8/16页 |
| 文件大小： | 322K |
| 代理商： | LT1680IN |
8
LT1680
OPERATIO
Basic Control Loop
The LT1680 uses a constant frequency, current mode
architecture. The timing of the IC is provided through an
internal oscillator circuit that can be synchronized to an
external clock and is programmable to operate at frequen-
cies up to 200kHz. The oscillator creates a modified
sawtooth wave at its timing node (C
T
) with a slow charge,
rapid discharge characteristic.
During typical boost converter operation, the MOSFET
switch is enabled at the start of each oscillator cycle. The
switch stays enabled until the current through the switched
inductor, sensed via the voltage across a series sense
resistor (R
SENSE
), is sufficient to trip the current com-
parator (IC1) and reset the RS latch. When the switch is
disabled, the inductor current is redirected to the supply
output. If the current comparator threshold is not reached
throughout the entire oscillator charge period, the RS
latch is bypassed and the main switch is disabled during
the oscillator discharge time. This “minimum off time”
protects the switch, and is typically about 1
μ
s.
The current comparator trip threshold is set on the V
C
pin,
which is the output of a transconductance amplifier, or
error amplifier (EA). The error amplifier integrates the
difference between a feedback voltage (on the V
FB
pin) and
an internal bandgap generated reference voltage of 1.25V,
forming a signal that represents required load current. If
the supplied current is insufficient for a given load, the
output will droop, thus reducing the feedback voltage. The
error amplifier responds by forcing current out of the V
C
pin, increasing the current comparator threshold. Thus,
the circuit will servo until the provided current is equal to
the required load and the average output voltage is at the
value programmed by the feedback resistors.
U
Input Average Current Limit
The output of the sense amplifier is monitored by a single
pole integrator comprised of an external capacitor on the
I
AVG
pin and an output impedance of approximately 50k
.
If this averaged value signal exceeds a level corresponding
to 120mV across the external sense resistor, the current
comparator threshold is clamped and cannot continue to
rise in response to the error amplifier. Thus, if average
input current requirements exceed 120mV/R
SENSE
, the
supply will current limit and the output voltage will fall out
of regulation. The average current limit circuit monitors
the sense amplifier output without slope compensation or
ripple current contributions. Therefore, the average input
current limit threshold is unaffected by duty cycle.
Undervoltage Lockout
The LT1680 employs an undervoltage lockout circuit
(UVLO) that monitors the 12V
IN
supply rail. This circuit
disables the output drive capability of the LT1680 if the
12V supply drops below 9V. Unstable mode switching is
prevented through 350mV of UVLO threshold hysteresis.
Shutdown
The LT1680 can be put into low current shutdown by
pulling the RUN/SHDN pin low, disabling all circuit func-
tions. The shutdown threshold is a bandgap referred
voltage of 1.25V typical. Use of a precision threshold on
the shutdown circuit enables use of this pin for under-
voltage protection of the V
IN
supply and/or power supply
sequencing.
Soft Start
The LT1680 incorporates a soft start function that oper-
ates by slowly increasing current limit. This limit is
controlled by internally clamping the V
C
pin to a low
voltage that climbs with time as an external capacitor on
the SS pin is charged with about 10
μ
A. This forces a
graceful climb of output current source capability, and
thus a graceful increase in output voltage until steady-
state regulation is achieved. The soft start timing capaci-
tor is clamped to ground during shutdown and during
undervoltage lockout, yielding a graceful output recovery
from either condition.
5V Internal Reference
Power for the oscillator timing elements and most other
internal LT1680 circuits is derived from an internal 5V
reference, accessible at the 5V
REF
pin. This supply pin
can be loaded with up to 10mA DC (20mA pulsed) for
convenient biasing of local elements such as control
logic, etc.
相关PDF资料 |
PDF描述 |
|---|---|
| LT1680ISW | High Power DC/DC Step-Up Controller |
| LT1680 | High Power DC/DC Step-Up Controller(大功率，DC/DC步升转换器) |
| LT1683IG | Ultralow Noise Push-Pull DC/DC Controller |
| LT1683 | Ultralow Noise Push-Pull DC/DC Controller |
| LT1683EG | Ultralow Noise Push-Pull DC/DC Controller |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LT1680IN#PBF | 功能描述:IC REG CTRLR BST PWM CM 16-DIP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:4,500 系列:PowerWise® PWM 型:控制器 输出数:1 频率 - 最大:1MHz 占空比:95% 电源电压:2.8 V ~ 5.5 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:6-WDFN 裸露焊盘 包装:带卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名称:LM1771SSDX |
| LT1680ISW | 功能描述:IC REG CTRLR BST PWM CM 16-SOIC RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:4,500 系列:PowerWise® PWM 型:控制器 输出数:1 频率 - 最大:1MHz 占空比:95% 电源电压:2.8 V ~ 5.5 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:6-WDFN 裸露焊盘 包装:带卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名称:LM1771SSDX |
| LT1680ISW#PBF | 功能描述:IC REG CTRLR BST PWM CM 16-SOIC RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 特色产品:LM3753/54 Scalable 2-Phase Synchronous Buck Controllers 标准包装:1 系列:PowerWise® PWM 型:电压模式 输出数:1 频率 - 最大:1MHz 占空比:81% 电源电压:4.5 V ~ 18 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-5°C ~ 125°C 封装/外壳:32-WFQFN 裸露焊盘 包装:Digi-Reel® 产品目录页面:1303 (CN2011-ZH PDF) 其它名称:LM3754SQDKR |
| LT1680ISW#TR | 功能描述:IC REG CTRLR BST PWM CM 16-SOIC RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:4,500 系列:PowerWise® PWM 型:控制器 输出数:1 频率 - 最大:1MHz 占空比:95% 电源电压:2.8 V ~ 5.5 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:6-WDFN 裸露焊盘 包装:带卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名称:LM1771SSDX |
| LT1680ISW#TRPBF | 功能描述:IC REG CTRLR BST PWM CM 16-SOIC RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:4,500 系列:PowerWise® PWM 型:控制器 输出数:1 频率 - 最大:1MHz 占空比:95% 电源电压:2.8 V ~ 5.5 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:6-WDFN 裸露焊盘 包装:带卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名称:LM1771SSDX |
发布紧急采购，3分钟左右您将得到回复。