- 您现在的位置：买卖IC网 > PDF目录80206 > LT1701-7 (POWER-ONE INC) 1-OUTPUT 550 W AC-DC REG PWR SUPPLY MODULE PDF资料下载
参数资料
| 型号： | LT1701-7 |
| 厂商： | POWER-ONE INC |
| 元件分类： | 电源模块 |
| 英文描述： | 1-OUTPUT 550 W AC-DC REG PWR SUPPLY MODULE |
| 封装： | CASE T01, MODULE |
| 文件页数： | 6/32页 |
| 文件大小： | 1000K |
| 代理商： | LT1701-7 |
第1页第2页第3页第4页第5页当前第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页
BCD20023 Rev. AA, 3-Sep-2008
Page 14 of 32
www.power-one.com
T Series Data Sheet
500 Watt AC-DC Converters
Table 12: Characteristics of power down functions
Characteristics
Conditions
min
typ
max
Unit
ID
Output
TC min – TC max
50 1
mA
sink current
Vsat Saturation voltage ID = 50 mA
0.2
V
Vz
Zener voltage
62
Pz
Z-diode PLoss
TC = 95 °C
500
mW
1 To be limited to 50 mA by the external circuitry.
Fig. 23
Power down function (D output)
– External adjustment of threshold level Vt
– Signal electrically isolated by an external relay
Fig. 24
Remote indication of signal D by LED
Fig. 25
Remote indication of the output voltage status (output D) by
CMOS/TTL interface (e.g., for data saving)
Upper threshold level
The upper threshold level of the power down function is given.
The rectifier models have a relatively small hysteresis of 1 V to
prevent the signal from oscillation.
The battery chargers have a larger hysteresis. The upper level
is set at 2.05 V/cell.
To avoid deep discharge of the battery, the load should be
disconnected from the battery at the low level of the power
down signal. The battery voltage will then recover slowly up to
its chemical equilibrium, about 2 V/cell. The load may not be
connected again to the battery, until the T converter is
operating and charging it. Then the output voltage will be
higher than 2.05 V/cell.
High level of output signal D (pin 30):
LT/UT1240:
24.6 V
±0.3 V
LT/UT1840:
49.2 V
±0.5 V
LT/UT1740:
43.9 V
±0.4 V
Fig. 22
Hysteresis of D output signal for battery chargers with
corresponding level of Power Down signal
VBat
Vfloat
Battery
recovery
Battery
low
Mains failure
Return of mains
Hysteresis
Power Down
Load switch ON
Load switch OFF
t
Vt
Z
t
high
low
Power down signal
2.05 V/cell
2.0 V/cell
06052a
Signal output characteristics
Output D (pin 30) is an open-collector signal, referenced to
Vo–, protected by a 62 V Zener diode; it is well suited to drive
an external relay.
Under normal operating conditions (Vo
> Vt), output D has low
impedance. If the output voltage drops below the power down
threshold level, output D becomes high impedance.
Vo+
D
Vo–
D set
Rext
06053
red LED
Vo+
D
Vo–
LED is "ON"
in case of
power down
R
06054
Vo+
D
Vo–
+5 V
CMOS, TTL
R
06055
Fig. 26
Output D signal used as inhibit to enable a system start-up in
the case of subsequently connected step-down converters
PSK/PSS/PSx with low start-up voltage. (For 48Q/CQ units,
no pull-up resistor is required.)
Vo+
D
Vo–
LT/UT
Vi+
i
Gi–
PSK/PSS/PSx
10 k
0.5 W
06056a
12
30
22
相关PDF资料 |
PDF描述 |
|---|---|
| LTC4413EDD-1 | SPECIALTY ANALOG CIRCUIT, PDSO10 |
| LW025A8 | 1-OUTPUT 25 W DC-DC REG PWR SUPPLY MODULE |
| LTC3109IUF#TRPBF | 0.026 A SWITCHING REGULATOR, PQCC20 |
| LM4040CSD-250GT3 | 1-OUTPUT TWO TERM VOLTAGE REFERENCE, 2.5 V, PDSO5 |
| LWN2880-6ERD2M1FK2G | 2-OUTPUT DC-DC REG PWR SUPPLY MODULE |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LT1702-7 | 功能描述:AC-DC BATTERY CHARGER 48V 11A RoHS:否 类别:电源 - 外部/内部（非板载） >> AC DC 转换器 系列:* 产品培训模块:MP Modular-Configurable AC-DC Power Supply 特色产品:Configurable Power Supplies 标准包装:1 系列:MP |
| LT170A | 制造商:未知厂家 制造商全称:未知厂家 功能描述:Linear Hall-Effect Sensor |
| LT170E2 | 制造商:未知厂家 制造商全称:未知厂家 功能描述:LT170E2 |Data Sheet |
| LT170Z | 制造商:SEOUL 制造商全称:Seoul Semiconductor 功能描述:GREEN OVAL LAMP LED |
| LT171 | 制造商:SEOUL 制造商全称:Seoul Semiconductor 功能描述:RED LAMP LED |
发布紧急采购，3分钟左右您将得到回复。