- 您现在的位置：买卖IC网 > PDF目录79869 > LT1701-7DB1 (POWER-ONE INC) 1-OUTPUT 550 W AC-DC REG PWR SUPPLY MODULE PDF资料下载
参数资料
| 型号： | LT1701-7DB1 |
| 厂商： | POWER-ONE INC |
| 元件分类： | 电源模块 |
| 英文描述： | 1-OUTPUT 550 W AC-DC REG PWR SUPPLY MODULE |
| 封装： | CASE T01, MODULE |
| 文件页数： | 33/33页 |
| 文件大小： | 838K |
| 代理商： | LT1701-7DB1 |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页当前第33页
Rugged Environment
AC-DC Converters >100 Watt
T Series
Edition 4/4.99
9/33
MELCHER
The Power Partners.
Uo
Uo min u
Ut
mains failure
warning time
thold
t
U
low load
heavy load
05049
Fig. 10
Hold up and warning time with power down output signal.
The table:
Hold up time also gives information about the
warning time of the power down signal. If for example the
threshold level
Ut of the power down signal is set to 43 V
and the minimum acceptable voltage of the load is 38 V the
time between the activation of the power down signal and
the switch-off of the load (550 W) will be 15 ms (55 ms -
40 ms).
Pulse Loading (Rectifier Version)
To prevent an overload of the output and filter capacitors
the superimposed AC ripple current at the output should be
limited as shown below. For high current pulse loads exter-
nal capacitors are recommended.
For other pulse loads than stated in the figure below, e.g.
Ui
< U
i nom, Io
> I
o nom, please contact Melcher.
15
10
5
0
100
1 k
10 k
Io PL [Arms]
fPL [Hz]
TC = 50°C
TC = TC max
Ui = Ui nom
Average output current = Io nom
Sinusoidal
ripple
current
50
05050
Fig. 11
Maximum allowable AC ripple output current superim-
posed on the average output current Io nom with LT 1701
unit.
Fig. 12
Dynamic characteristics under varying load conditions
(see: Electrical Output Data)
Uo
t d
DUo I
10%
DUo d
t
Io /Io nom
1
0.9
0.1
DUod
05051
Uo
Table 6: Characteristics of the inhibit signal
Characteristics
Conditions
min
typ max
Unit
Uinh Inhibit
Uo = on
Ui min...Ui max
2.5
60
V
voltage
TC min...TC max
Rinh Resistance Uo = on
30
k
to Vo–
Uinh Inhibit
Uo = off
-0.7
0.4
V
voltage
Rinh Resistance Uo = off
50
tr
Switch-on time
Ui nom
100
ms
until full power avail.
Pinh Input power with
3
W
inhibited unit
Fig. 13
Inhibit signal connection
Inhibit input (Rectifier Version)
The rectifier versions are equipped with the inhibit function
only. (The Ucr remote control is used with the battery char-
ger version.)
The unit is enabled by a logic high signal and disabled by a
logic low signal. This input is TTL/CMOS compatible, a re-
sistor
<50 disables the unit, a resistor >30 k enables it.
The switch-on time
tr of the unit, i.e. the time delay between
powering until the full output power is available, is typically
100 ms.
The hold up time at the output after inhibiting depends on
the load, the internal capacitance of the unit and additional
capacitance on the DC bus.
The inhibit input is protected against DC overvoltage up to
60 V.
P~
N~
Vo–
i/Ucr
Vo+
Iinh
Uinh
06116
4
28
12
22
6
T1000
相关PDF资料 |
PDF描述 |
|---|---|
| LM3711YNBP-308 | 1-CHANNEL POWER SUPPLY SUPPORT CKT, PBGA9 |
| LS4001-7EPD8 | 1-OUTPUT 100 W AC-DC PWR FACTOR CORR MODULE |
| LS4001-7EPDDB1 | 1-OUTPUT 100 W AC-DC PWR FACTOR CORR MODULE |
| LS4001-9EPV2T | 1-OUTPUT 100 W AC-DC PWR FACTOR CORR MODULE |
| LS4001-9ERD6B2 | 1-OUTPUT 100 W AC-DC PWR FACTOR CORR MODULE |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LT1702-7 | 功能描述:AC-DC BATTERY CHARGER 48V 11A RoHS:否 类别:电源 - 外部/内部（非板载） >> AC DC 转换器 系列:* 产品培训模块:MP Modular-Configurable AC-DC Power Supply 特色产品:Configurable Power Supplies 标准包装:1 系列:MP |
| LT170A | 制造商:未知厂家 制造商全称:未知厂家 功能描述:Linear Hall-Effect Sensor |
| LT170E2 | 制造商:未知厂家 制造商全称:未知厂家 功能描述:LT170E2 |Data Sheet |
| LT170Z | 制造商:SEOUL 制造商全称:Seoul Semiconductor 功能描述:GREEN OVAL LAMP LED |
| LT171 | 制造商:SEOUL 制造商全称:Seoul Semiconductor 功能描述:RED LAMP LED |
发布紧急采购，3分钟左右您将得到回复。