- 您现在的位置：买卖IC网 > PDF目录10736 > LT1715CMS#PBF (Linear Technology)IC COMPARATOR 150MHZ DUAL 10MSOP PDF资料下载
参数资料
| 型号： | LT1715CMS#PBF |
| 厂商： | Linear Technology |
| 文件页数： | 3/20页 |
| 文件大小： | 0K |
| 描述： | IC COMPARATOR 150MHZ DUAL 10MSOP |
| 标准包装： | 50 |
| 系列： | UltraFast™ |
| 类型： | 通用 |
| 元件数： | 2 |
| 输出类型： | CMOS，满摆幅，TTL |
| 电压 - 电源，单路/双路(±)： | 2.7 V ~ 12 V |
| 电压 - 输入偏移（最小值）： | 2.5mV @ ±5V |
| 电流 - 输入偏压（最小值）： | 6µA @ ±5V |
| 电流 - 输出（标准）： | 20mA |
| 电流 - 静态（最大值）： | 2mA |
| CMRR, PSRR（标准）： | 70dB CMRR，80dB PSRR |
| 传输延迟（最大）： | 9ns |
| 磁滞： | 6mV |
| 工作温度： | 0°C ~ 70°C |
| 封装/外壳： | 10-TFSOP，10-MSOP（0.118"，3.00mm 宽） |
| 安装类型： | 表面贴装 |
| 包装： | 管件 |
| 产品目录页面： | 1323 (CN2011-ZH PDF) |
LT1715
11
1715fa
APPLICATIONS INFORMATION
The ground trace from Pin 6 runs under the device up
to the bypass capacitor, shielding the inputs from the
outputs. Note the use of a common via for the LT1715
and the bypass capacitors, which minimizes interference
from high frequency energy running around the ground
plane or power distribution traces.
The supply bypass should include an adjacent 10nF ceramic
capacitor and a 2.2μF tantalum capacitor no farther than
5cm away; use more capacitance on +VS if driving more
than 4mA loads. To prevent oscillations, it is helpful to
balance the impedance at the inverting and noninverting
inputs; source impedances should be kept low, preferably
1kΩ or less.
The outputs of the LT1715 are capable of very high slew
rates. To prevent overshoot, ringing and other problems
with transmission line effects, keep the output traces
shorter than 10cm, or be sure to terminate the lines
to maintain signal integrity. The LT1715 can drive DC
terminations of 200Ω or more, but lower characteristic
impedance traces can be used with series termination or
AC termination topologies.
Channel Interactions
The LT1715’s two channels are designed to be entirely
independent. However, at frequencies approaching and
exceeding 100MHz, bond wire inductance begins to
interfere with overlapping switching edges on the two
channels. Figure 3 shows one channel of the comparator
toggling at 100MHz with the other channel driven low
with the scope set to display innite persistence. Jitter is
almost nonexistent. Figure 4 displays the same channel
at 100MHz with innite persistence, but the other channel
ofthe comparator is toggling as well at frequencies swept
from 60MHz to 160MHz. Jitter will occur as rising and fall-
ing edges align for any non harmonic or non fundamental
frequency of the high frequency signal.
At frequencies well beyond 100MHz, the toggling of one
channel may be impaired by toggling on the other. This
is a rather complex interaction of supply bypassing and
bond inductance, and it cannot be entirely prevented.
However, good bypassing and board layout techniques
will effectively minimize it.
Power Supply Sequencing
The LT1715 is designed to tolerate any power supply
sequencing at system turn-on and power down. In any
of the previously shown power supply congurations, the
various supplies can activate in any order without exces-
sive current drain by the LT1715.
As always, the Absolute Maximum Ratings must not be
exceeded, either on the power supply terminals or the
input terminals. Power supply sequencing problems can
occur when input signals are powered from supplies that
are independent of the LT1715’s supplies. No problems
should occur if the input signals are powered from the
same VCC and VEE supplies as the LT1715.
Figure 4. 100MHz Jitter with Both Channels Driven
Figure 3. Clean 100MHz Toggling
5ns/DIV
1715 F03
–5V
0V
1V/DIV
OUT A
5ns/DIV
1715 F04
–5V
0V
1V/DIV
OUT A
相关PDF资料 |
PDF描述 |
|---|---|
| VI-JNV-MY-F4 | CONVERTER MOD DC/DC 5.8V 50W |
| VI-BWZ-MX-B1 | CONVERTER MOD DC/DC 2V 30W |
| ADCMP552BRQZ | IC COMPARATOR PECL/LVPECL 20QSOP |
| VI-BWZ-MW-B1 | CONVERTER MOD DC/DC 2V 40W |
| VE-2N1-IW | CONVERTER MOD DC/DC 12V 100W |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LT1715CMSTRPBF | 制造商:LINER 制造商全称:Linear Technology 功能描述:4ns, 150MHz Dual Comparator with Independent Input/Output Supplies |
| LT1715HMS#PBF | 功能描述:IC COMP DUAL 150MHZ 4NS 10-MSOP RoHS:是 类别:集成电路 (IC) >> 线性 - 比较器 系列:UltraFast™ 标准包装:1 系列:- 类型:通用 元件数:1 输出类型:CMOS，开路集电极，TTL 电压 - 电源，单路/双路(±):2.7 V ~ 5.5 V 电压 - 输入偏移（最小值）:7mV @ 5V 电流 - 输入偏压（最小值）:0.25µA @ 5V 电流 - 输出（标准）:84mA @ 5V 电流 - 静态（最大值）:120µA CMRR, PSRR（标准）:- 传输延迟（最大）:600ns 磁滞:- 工作温度:-40°C ~ 85°C 封装/外壳:SC-74A，SOT-753 安装类型:表面贴装 包装:剪切带 (CT) 产品目录页面:1268 (CN2011-ZH PDF) 其它名称:*LMV331M5*LMV331M5/NOPBLMV331M5CT |
| LT1715HMS#PBF | 制造商:Linear Technology 功能描述:IC, HIGH SPEED COMP, DUAL, 4NS, MSOP-10 |
| LT1715HMS#TRPBF | 功能描述:IC COMPARATOR 4NS DUAL 10-MSOP RoHS:是 类别:集成电路 (IC) >> 线性 - 比较器 系列:UltraFast™ 产品培训模块:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 标准包装:2,500 系列:- 类型:通用 元件数:1 输出类型:CMOS，推挽式，满摆幅，TTL 电压 - 电源，单路/双路(±):2.5 V ~ 5.5 V，±1.25 V ~ 2.75 V 电压 - 输入偏移（最小值）:5mV @ 5.5V 电流 - 输入偏压（最小值）:1pA @ 5.5V 电流 - 输出（标准）:- 电流 - 静态（最大值）:24µA CMRR, PSRR（标准）:80dB CMRR，80dB PSRR 传输延迟（最大）:450ns 磁滞:±3mV 工作温度:-40°C ~ 85°C 封装/外壳:6-WFBGA，CSPBGA 安装类型:表面贴装 包装:管件 其它名称:Q3554586 |
| LT1715HMSPBF | 制造商:LINER 制造商全称:Linear Technology 功能描述:4ns, 150MHz Dual Comparator with Independent Input/Output Supplies |
发布紧急采购，3分钟左右您将得到回复。