- 您现在的位置：买卖IC网 > PDF目录15307 > LT1725IGN#TRPBF (Linear Technology)IC REG CTRLR FLYBK ISO CM 16SSOP PDF资料下载
参数资料
| 型号： | LT1725IGN#TRPBF |
| 厂商： | Linear Technology |
| 文件页数： | 20/28页 |
| 文件大小： | 0K |
| 描述： | IC REG CTRLR FLYBK ISO CM 16SSOP |
| 标准包装： | 2,500 |
| PWM 型： | 电流模式 |
| 输出数： | 1 |
| 频率 - 最大： | 125kHz |
| 占空比： | 90% |
| 电源电压： | 最高 22V |
| 降压： | 无 |
| 升压： | 无 |
| 回扫： | 是 |
| 反相： | 无 |
| 倍增器： | 无 |
| 除法器： | 无 |
| Cuk： | 无 |
| 隔离： | 是 |
| 工作温度： | -40°C ~ 125°C |
| 封装/外壳： | 16-SSOP（0.154"，3.90mm 宽） |
| 包装： | 带卷 (TR) |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页当前第20页第21页第22页第23页第24页第25页第26页第27页第28页
LT1725
APPLICATIO S I FOR ATIO
MAXIMUM LOAD/SHORT-CIRCUIT CONSIDERATIONS
The LT1725 is a current mode controller. It uses the V C
node voltage as an input to a current comparator which
turns off the output switch on a cycle-by-cycle basis as
this peak current is reached. The internal clamp on the V C
node, nominally 2.5V, then acts as an output switch peak
current limit.
This 2.5V at the V C pin corresponds to a value of 250mV
at the I SENSE pin, when the (ON) switch duty cycle is less
than 40%. For a duty cycle above 40%, the internal slope
compensation mechanism lowers the effective I SENSE
voltage limit. For example, at a duty cycle of 80%, the
nominal I SENSE voltage limit is 220mV. This action be-
comes the switch current limit specification. Maximum
available output power is then determined by the switch
current limit, which is somewhat duty cycle dependent
due to internal slope compensation action.
Overcurrent conditions are handled by the same mecha-
nism. The output switch turns on, the peak current is
quickly reached and the switch is turned off. Because the
output switch is only on for a small fraction of the available
period, power dissipation is controlled.
Loss of current limit is possible under certain conditions.
Remember that the LT1725 normally exhibits a minimum
switch on time, irrespective of current trip point. If the duty
cycle exhibited by this minimum on time is greater than the
ratio of secondary winding voltage (referred-to-primary)
divided by input voltage, then peak current will not be
controlled at the nominal value, and will cycle-by-cycle
ratchet up to some higher level. Expressed mathemati-
cally, the requirement to maintain short-circuit control is:
t ON ? f < ( V F + I SC ? R SEC ) where
V IN ? N SP
t ON = output switch minimum on time
f = switching frequency
I SC = short-circuit output current
V IN = input voltage
N SP = secondary-to-primary turns ratio ( N SEC /N PRI )
Trouble is typically only encountered in applications with
a relatively high product of input voltage times secondary-
to-primary turns ratio and/or a relatively long minimum
switch on time. (Additionally, several real world effects such
as transformer leakage inductance, AC winding losses, and
output switch voltage drop combine to make this simple
theoretical calculation a conservative estimate.)
THERMAL CONSIDERATIONS
Care should be taken to ensure that the worst-case input
voltage condition does not cause excessive die tempera-
tures. The 16-lead SO package is rated at 100 ° C/W, and
the 16-lead GN at 110 ° C/W.
Average supply current is simply the sum of quiescent
current given in the specifications section plus gate drive
current. Gate drive current can be computed as:
I G = f ? Q G where
Q G = total gate charge
f = switching frequency
(Note: Total gate charge is more complicated than C GS ? V G
as it is frequently dominated by Miller effect of the C GD .
Furthermore, both capacitances are nonlinear in practice.
Fortunately, most MOSFET data sheets provide figures
and graphs which yield the total gate charge directly per
operating conditions.) Nearly all gate drive power is dissi-
pated in the IC, except for a small amount in the external
gate series resistor, so total IC dissipation may be com-
puted as:
P D(TOTAL) = V CC (I Q + ? f ? Q G ), where
I Q = quiescent current (from specifications)
Q G = total gate charge
f = switching frequency
V CC = LT1725 supply voltage
V F = output diode forward voltage at I SC
R SEC = resistance of transformer secondary
1725fa
20
相关PDF资料 |
PDF描述 |
|---|---|
| LT1737IGN#TRPBF | IC REG CTRLR FLYBK ISO CM 16SSOP |
| UCY2G220MPD | CAP ALUM 22UF 400V 20% RADIAL |
| LTC3778EF#TRPBF | IC REG CTRLR BUCK PWM CM 20TSSOP |
| URS2A331MHD | CAP ALUM 330UF 100V 20% RADIAL |
| SEK330M250ST | CAP ALUM 33UF 250V 20% RADIAL |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LT1725IS | 功能描述:IC REG CTRLR FLYBK ISO CM 16SOIC RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR) |
| LT1725IS#PBF | 功能描述:IC REG CTRLR FLYBK ISO CM 16SOIC RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR) |
| LT1725IS#TR | 功能描述:IC REG CTRLR FLYBK ISO CM 16SOIC RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR) |
| LT1725IS#TRPBF | 功能描述:IC REG CTRLR FLYBK ISO CM 16SOIC RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR) |
| LT1737 | 制造商:LINER 制造商全称:Linear Technology 功能描述:High Power Isolated Flyback Controller |
发布紧急采购，3分钟左右您将得到回复。