- 您现在的位置：买卖IC网 > PDF目录4701 > LT1763CS8-3.3#TRPBF (Linear Technology)IC REG LDO 3.3V .5A 8-SOIC PDF资料下载
参数资料
| 型号： | LT1763CS8-3.3#TRPBF |
| 厂商： | Linear Technology |
| 文件页数： | 15/22页 |
| 文件大小： | 0K |
| 描述： | IC REG LDO 3.3V .5A 8-SOIC |
| 产品培训模块： | More Information on LDOs |
| 标准包装： | 2,500 |
| 稳压器拓扑结构： | 正，固定式 |
| 输出电压： | 3.3V |
| 输入电压： | 最高 20V |
| 电压 - 压降（标准）： | 0.3V @ 500mA |
| 稳压器数量： | 1 |
| 电流 - 输出： | 500mA |
| 电流 - 限制（最小）： | 520mA |
| 工作温度： | -40°C ~ 125°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 8-SOIC（0.154"，3.90mm 宽） |
| 供应商设备封装： | 8-SOIC |
| 包装： | 带卷 (TR) |
LT1763 Series
APPLICATIONS INFORMATION
The LT1763 series are 500mA low dropout regulators with
micropower quiescent current and shutdown. The devices
are capable of supplying 500mA at a dropout voltage of
300mV. Output voltage noise can be lowered to 20μV RMS
over a 10Hz to 100kHz bandwidth with the addition of
a 0.01μF reference bypass capacitor. Additionally, the
to 1.22V: V OUT /1.22V. For example, load regulation for an
output current change of 1mA to 500mA is –2mV typical
at V OUT = 1.22V. At V OUT = 12V, load regulation is:
(12V/1.22V)(–2mV) = –19.6mV
? + ( I ADJ )( R 2 )
V OUT = 1 . 22 V ? 1 +
referencebypasscapacitorwillimprovetransientresponse
of the regulator, lowering the settling time for transient load
conditions. The low operating quiescent current (30μA)
drops to less than 1μA in shutdown. In addition to the
low quiescent current, the LT1763 regulators incorporate
several protection features which make them ideal for use
in battery-powered systems. The devices are protected
V IN
IN
LT1763
GND
OUT
ADJ
R2
R1
1763 F02
+
V OUT
? R2 ?
? R 1 ?
V ADJ = 1 . 22 V
I ADJ = 30 nA AT 25 ° C
OUTPUT RANGE = 1.22V TO 20V
against both reverse input and reverse output voltages.
In battery backup applications where the output can be
held up by a backup battery when the input is pulled to
ground, the LT1763-X acts like it has a diode in series with
its output and prevents reverse current ?ow. Additionally,
in dual supply applications where the regulator load is
returned to a negative supply, the output can be pulled
below ground by as much as 20V and still allow the device
to start and operate.
Adjustable Operation
The adjustable version of the LT1763 has an output voltage
range of 1.22V to 20V. The output voltage is set by the
ratio of two external resistors, as shown in Figure 2. The
device servos the output to maintain the ADJ pin voltage
at 1.22V referenced to ground. The current in R1 is then
equal to 1.22V/R1 and the current in R2 is the current
in R1 plus the ADJ pin bias current. The ADJ pin bias
current, 30nA at 25°C, ?ows through R2 into the ADJ pin.
The output voltage can be calculated using the formula in
Figure 2. The value of R1 should be no greater than 250k
to minimize errors in the output voltage caused by the
ADJ pin bias current. Note that in shutdown the output
is turned off and the divider current will be zero. Curves
of ADJ Pin Voltage vs Temperature and ADJ Pin Bias
Figure 2. Adjustable Operation
Bypass Capacitance and Low Noise Performance
The LT1763 regulators may be used with the addition of
a bypass capacitor from V OUT to the BYP pin to lower
output voltage noise. A good quality low leakage capacitor
is recommended. This capacitor will bypass the reference
of the regulator, providing a low frequency noise pole.
The noise pole provided by this bypass capacitor will
lower the output voltage noise to as low as 20μV RMS
with the addition of a 0.01μF bypass capacitor. Using
a bypass capacitor has the added bene?t of improving
transient response. With no bypass capacitor and a 10μF
output capacitor, a 10mA to 500mA load step will settle
to within 1% of its ?nal value in less than 100μs. With
the addition of a 0.01μF bypass capacitor, the output will
settle to within 1% for a 10mA to 500mA load step in less
than 10μs, with total output voltage deviation of less than
2.5% (see the LT1763-5 Transient Response curve in the
Typical Performance Characteristics section). However,
regulator start-up time is proportional to the size of the
bypass capacitor, slowing to 15ms with a 0.01μF bypass
capacitor and 10μF output capacitor.
Current vs Temperature appear in the Typical Performance
Characteristics section.
The adjustable device is tested and speci?ed with the ADJ
pin tied to the OUT pin for an output voltage of 1.22V.
Speci?cations for output voltages greater than 1.22V will
be proportional to the ratio of the desired output voltage
1763fg
15
相关PDF资料 |
PDF描述 |
|---|---|
| LT1763CS8-3#TRPBF | IC REG LDO 3V .5A 8-SOIC |
| ACB10DHAT | CONN EDGECARD 20POS R/A .050 DIP |
| ABM12DTMN-S664 | CONN EDGECARD 24POS R/A .156 |
| ABM12DTMD-S664 | CONN EDGECARD 24POS R/A .156 |
| ABM12DTBN-S664 | CONN EDGECARD 24POS R/A .156 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LT1763CS8-3PBF | 制造商:Linear Technology 功能描述:LDO Regulator Positive 3V 0.5A SOIC8 |
| LT1763CS8-3-PBF | 制造商:LINER 制造商全称:Linear Technology 功能描述:500mA, Low Noise, LDO Micropower Regulators |
| LT1763CS8-3TR | 制造商:LINER 制造商全称:Linear Technology 功能描述:500mA, Low Noise, LDO Micropower Regulators |
| LT1763CS8-3-TR | 制造商:LINER 制造商全称:Linear Technology 功能描述:500mA, Low Noise, LDO Micropower Regulators |
| LT1763CS8-3TRPBF | 制造商:LINER 制造商全称:Linear Technology 功能描述:500mA, Low Noise, LDO Micropower Regulators |
发布紧急采购，3分钟左右您将得到回复。