- 您现在的位置：买卖IC网 > PDF目录377714 > LT1765 (Linear Technology Corporation) Isolated Flyback Switching Regulator with 9V Output PDF资料下载
参数资料
| 型号： | LT1765 |
| 厂商： | Linear Technology Corporation |
| 元件分类： | 基准电压源/电流源 |
| 英文描述： | Isolated Flyback Switching Regulator with 9V Output |
| 中文描述： | 隔离反激式开关稳压9V输出 |
| 文件页数： | 10/20页 |
| 文件大小： | 247K |
| 代理商： | LT1765 |
LT1765/LT1765-1.8/LT1765-2.5/
LT1765-3.3/LT1765-5
10
sn1765 1765fas
supply is used. The boost diode can be connected to the
input, although, care must be taken to prevent the 2x V
IN
boost voltage from exceeding the BOOST pin absolute
maximum rating. The additional voltage across the switch
driver also increases power loss, reducing efficiency. If
available, an independent supply can be used with a local
bypass capacitor.
A 0.18
μ
F boost capacitor is recommended for most appli-
cations. Almost any type of film or ceramic capacitor is
suitable, but the ESR should be <1
to ensure it can be
fully recharged during the off time of the switch. The
capacitor value is derived from worst-case conditions of
700ns on-time, 90mA boost current, and 0.7V discharge
ripple. This value is then guard banded by 2x for secondary
factors such as capacitor tolerance, ESR and temperature
effects. The boost capacitor value could be reduced under
less demanding conditions, but this will not improve
circuit operation or efficiency. Under low input voltage and
low load conditions, a higher value capacitor will reduce
discharge ripple and improve start up operation.
SHUTDOWN AND UNDERVOLTAGE LOCKOUT
Figure 4 shows how to add undervoltage lockout (UVLO)
to the LT1765. Typically, UVLO is used in situations where
the input supply is current limited or has a relatively high
source resistance. A switching regulator draws constant
power from the source, so source current increases as
source voltage drops. This looks like a negative resistance
load to the source and can cause the source to current limit
or latch low under low source voltage conditions. UVLO
prevents the regulator from operating at source voltages
where these problems might occur.
APPLICATIOU
W
U
U
Figure 4. Undervoltage Lockout
1.33V
GND
V
SW
INPUT
R1
1765 F04
OUTPUT
SHDN
V
CC
IN
LT1765
3
μ
A
R2
C1
+
7
μ
A
Table 3
VALUE
(
μ
H)
I
RMS
(Amps)
DCR
(
)
HEIGHT
(mm)
PART NUMBER
Coiltcraft
DO1608C-222
Sumida
CDRH3D16-1R5
CDRH4D18-1R0
CDC5D23-2R2
CR43-1R4
CDRH5D28-2R6
Toko
(D62F)847FY-2R4M
(D73LF)817FY-2R2M
2.2
2.4
0.07
2.9
1.5
1.0
2.2
1.4
2.6
1.6
1.7
2.2
2.5
2.6
0.043
0.035
0.03
0.056
0.013
1.8
2.0
2.5
3.5
3.0
2.4
2.2
2.5
2.7
0.037
0.03
2.7
3.0
CATCH DIODE
The diode D1 conducts current only during switch off time.
Peak reverse voltage is equal to regulator input voltage.
Average forward current in normal operation can be calcu-
lated from:
(
I
I
V
V
V
D AVG
OUT
IN
OUT
IN
)
=
)
The only reason to consider a larger than 3A diode is the
worst-case condition of a high input voltage and shorted
output. With a shorted condition, diode current will in-
crease to a typical value of 4A, determined by peak switch
current limit of the LT1765. A higher forward voltage will
also limit switch current. This is safe for short periods of
time, but it would be prudent to check with the diode
manufacturer if continuous operation under these condi-
tions must be tolerated.
BOOSTPIN
For most applications, the boost components are a 0.18
μ
F
capacitor and a CMDSH-3 diode. The anode is typically
connected to the regulated output voltage to generate a
voltage approximately V
OUT
above V
IN
to drive the output
stage. The output driver requires at least 2.7V of head-
room throughout the on period to keep the switch fully
saturated. However, the output stage discharges the boost
capacitor during this on time. If the output voltage is less
than 3.3V, it is recommended that an alternate boost
相关PDF资料 |
PDF描述 |
|---|---|
| LT1765-2.5 | Isolated Flyback Switching Regulator with 9V Output |
| LT1767-2.5 | Direct mounting on the PCB, Crimping connection, Discrete wire connectors; HRS No: 544-0063-6 00; No. of Positions: 15; Connector Type: Wire; Contact Gender: Male; Contact Spacing (mm): 2; Terminal Pitch (mm): 2; Termination Style: IDC; Current Rating(Amps)(Max.): 1; Contact Mating Area Plating: Tin; Operating Temperature Range (degrees C): -30 to 85; General Description: Housing; Straight; Direct PCB mounting; For AWG#26 |
| LT1767EMS8 | RADIATION HARDENED HIGH EFFICIENCY, 5 AMP SWITCHING REGULATORS |
| LT1767EMS8-1.8 | RADIATION HARDENED HIGH EFFICIENCY, 5 AMP SWITCHING REGULATORS |
| LT1767EMS8-2.5 | RADIATION HARDENED HIGH EFFICIENCY, 5 AMP SWITCHING REGULATORS |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LT1765-1.8 | 制造商:LINER 制造商全称:Linear Technology 功能描述:Monolithic 3A, 1.25MHz Step-Down Switching Regulator |
| LT1765-2.5 | 制造商:LINER 制造商全称:Linear Technology 功能描述:Monolithic 3A, 1.25MHz Step-Down Switching Regulator |
| LT1765-3.3 | 制造商:LINER 制造商全称:Linear Technology 功能描述:Monolithic 3A, 1.25MHz Step-Down Switching Regulator |
| LT1765-5 | 制造商:LINER 制造商全称:Linear Technology 功能描述:Monolithic 3A, 1.25MHz Step-Down Switching Regulator |
| LT1765EFE | 功能描述:IC REG BUCK ADJ 3A 16TSSOP RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 设计资源:Design Support Tool 标准包装:1 系列:- 类型:升压（升压） 输出类型:固定 输出数:1 输出电压:3V 输入电压:0.75 V ~ 2 V PWM 型:- 频率 - 开关:- 电流 - 输出:100mA 同步整流器:是 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:SOT-23-5 细型，TSOT-23-5 包装:剪切带 (CT) 供应商设备封装:TSOT-23-5 其它名称:AS1323-BTTT-30CT |
发布紧急采购，3分钟左右您将得到回复。