- 您现在的位置：买卖IC网 > PDF目录20897 > LT1937ESC6#TRM (Linear Technology)IC LED DRVR WHITE BCKLGT SC-70-6 PDF资料下载
参数资料
| 型号： | LT1937ESC6#TRM |
| 厂商： | Linear Technology |
| 文件页数： | 4/12页 |
| 文件大小： | 0K |
| 描述： | IC LED DRVR WHITE BCKLGT SC-70-6 |
| 标准包装： | 500 |
| 恒定电流： | 是 |
| 拓扑： | PWM，升压（升压） |
| 输出数： | 1 |
| 内部驱动器： | 是 |
| 类型 - 主要： | 背光 |
| 类型 - 次要： | 白色 LED |
| 频率： | 800kHz ~ 1.6MHz |
| 电源电压： | 2.5 V ~ 10 V |
| 输出电压： | 36V |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 6-TSSOP，SC-88，SOT-363 |
| 供应商设备封装： | SC-70-6 |
| 包装： | 带卷 (TR) |
| 工作温度： | -40°C ~ 85°C |
| 其它名称： | LT1937ESC6 LT1937ESC6-ND |
LT1937
BLOCK DIAGRA
V IN
(PIN 6 FOR
SC70 PACKAGE) 5
FB
3
–
COMPARATOR
1 SW
V REF
1.25V
95mV
+
A1
R C
A2
R
S
Q
DRIVER
Q1
C C
Σ
+
0.2 ?
–
RAMP
SHDN
GENERATOR
4
SHUTDOWN
1.2MHz
(PINS 2 AND 5 FOR
SC70 PACKAGE)
2 GND
1937 BD1
OSCILLATOR
Figure 2. LT1937 Block Diagram
OPERATIO
The LT1937 uses a constant frequency, current mode
control scheme to provide excellent line and load regula-
tion. Operation can be best understood by referring to the
block diagram in Figure 2. At the start of each oscillator
cycle, the SR latch is set, which turns on the power switch
Q1. A voltage proportional to the switch current is added
to a stabilizing ramp and the resulting sum is fed into the
positive terminal of the PWM comparator A2. When this
voltage exceeds the level at the negative input of A2, the SR
latch is reset turning off the power switch. The level at the
negative input of A2 is set by the error amplifier A1, and is
simply an amplified version of the difference between the
feedback voltage and the reference voltage of 95mV. In
this manner, the error amplifier sets the correct peak
pulses. This will result in some low frequency ripple,
although the LED current remains regulated on an average
basis down to zero. The photo in Figure 3 details circuit
operation driving three white LEDs at a 4mA load. Peak
inductor current is less than 50mA and the regulator
operates in discontinuous mode, meaning the inductor
current reaches zero during the discharge phase. After the
inductor current reaches zero, the switch pin exhibits
ringing due to the LC tank circuit formed by the inductor
in combination with switch and diode capacitance. This
ringing is not harmful; far less spectral energy is contained
in the ringing than in the switch transitions. The ringing
can be damped by application of a 300 ? resistor across
the inductor, although this will degrade efficiency.
current level to keep the output in regulation. If the error
amplifier’s output increases, more current is delivered to
the output; if it decreases, less current is delivered.
V SW
Minimum Output Current
The LT1937 can regulate three series LEDs connected at
low output currents, down to approximately 4mA from a
4.2V supply, without pulse skipping, using the same
5V/DIV
I L2
50mA/DIV
V OUT
100mV/DIV
external components as specified for 15mA operation. As
0.2 μ s/DIV
1937 F03
current is further reduced, the device will begin skipping
Figure 3. Switching Waveforms at I LED = 4mA, V IN = 3.6V
1937f
4
相关PDF资料 |
PDF描述 |
|---|---|
| LT1937ESC6#TRPBF | IC LED DRVR WHITE BCKLGT SC-70-6 |
| LT1937ESC6#TR | IC LED DRVR WHITE BCKLGT SC-70-6 |
| P51-1000-S-M-I36-20MA-000-000 | SENSOR 1000PSIS M10 4-20 MA |
| MIC3231YTSE TR | IC LED DRVR HP CONS CURR 16TSSOP |
| P51-75-S-M-D-4.5V-000-000 | SENSOR 75PSI M10-1.0 6G .5-4.5V |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LT1938EDD#PBF | 功能描述:IC REG BUCK ADJ 2.2A 10DFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 标准包装:250 系列:- 类型:降压（降压） 输出类型:固定 输出数:1 输出电压:1.2V 输入电压:2.05 V ~ 6 V PWM 型:电压模式 频率 - 开关:2MHz 电流 - 输出:500mA 同步整流器:是 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:6-UFDFN 包装:带卷 (TR) 供应商设备封装:6-SON（1.45x1） 产品目录页面:1032 (CN2011-ZH PDF) 其它名称:296-25628-2 |
| LT1938EDD#TRPBF | 功能描述:IC REG BUCK ADJ 2.2A 10DFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 标准包装:2,500 系列:- 类型:降压（降压） 输出类型:固定 输出数:1 输出电压:1.2V，1.5V，1.8V，2.5V 输入电压:2.7 V ~ 20 V PWM 型:- 频率 - 开关:- 电流 - 输出:50mA 同步整流器:是 工作温度:-40°C ~ 125°C 安装类型:表面贴装 封装/外壳:10-TFSOP，10-MSOP（0.118"，3.00mm 宽）裸露焊盘 包装:带卷 (TR) 供应商设备封装:10-MSOP 裸露焊盘 |
| LT1938EDDPBF | 制造商:Linear Technology 功能描述:2.2A 2.8MHz Step down Regulator LT1938 |
| LT1938IDD#PBF | 功能描述:IC REG BUCK ADJ 2.2A 10DFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 产品培训模块:MIC23xxx HyperLight Load™ Regulators 标准包装:5,000 系列:HyperLight Load® 类型:降压（降压） 输出类型:固定 输出数:1 输出电压:1.8V 输入电压:2.7 V ~ 5.5 V PWM 型:混合物 频率 - 开关:4MHz 电流 - 输出:2A 同步整流器:是 工作温度:-40°C ~ 125°C 安装类型:表面贴装 封装/外壳:8-VFDFN 裸露焊盘，8-MLF? 包装:带卷 (TR) 供应商设备封装:8-MLF?（2x2） 产品目录页面:1094 (CN2011-ZH PDF) 其它名称:576-3303-2 |
| LT1938IDD#TRPBF | 功能描述:IC REG BUCK ADJ 2.2A 10DFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 标准包装:2,500 系列:- 类型:降压（降压） 输出类型:固定 输出数:1 输出电压:1.2V，1.5V，1.8V，2.5V 输入电压:2.7 V ~ 20 V PWM 型:- 频率 - 开关:- 电流 - 输出:50mA 同步整流器:是 工作温度:-40°C ~ 125°C 安装类型:表面贴装 封装/外壳:10-TFSOP，10-MSOP（0.118"，3.00mm 宽）裸露焊盘 包装:带卷 (TR) 供应商设备封装:10-MSOP 裸露焊盘 |
发布紧急采购，3分钟左右您将得到回复。