参数资料
| 型号： | LT1963AET#06PBF |
| 厂商： | Linear Technology |
| 文件页数： | 20/28页 |
| 文件大小： | 0K |
| 描述： | IC REG LDO ADJ 1.5A TO220-5 |
| 产品培训模块： | More Information on LDOs |
| 标准包装： | 50 |
| 稳压器拓扑结构： | 正，可调式 |
| 输出电压： | 1.21 V ~ 20 V |
| 输入电压： | 2.1 V ~ 20 V |
| 电压 - 压降（标准）： | 0.34V @ 1.5A |
| 稳压器数量： | 1 |
| 电流 - 输出： | 1.5A |
| 电流 - 限制（最小）： | 1.6A |
| 工作温度： | -40°C ~ 125°C |
| 安装类型： | 通孔 |
| 封装/外壳： | TO-220-5 成形引线 |
| 供应商设备封装： | TO-220-5 |
| 包装： | 管件 |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页当前第20页第21页第22页第23页第24页第25页第26页第27页第28页
LT1963A Series
APPLICATIONS INFORMATION
LT1963A
V OUT = V FB
LT1963A-3.3
OUTPUT VOLTAGE (V)
The output of the LT1963A can be pulled below ground
without damaging the device. If the input is left open circuit
or grounded, the output can be pulled below ground by
20V. For fixed voltage versions, the output will act like a
large resistor, typically 5k or higher, limiting current flow
to typically less than 600μA. For adjustable versions, the
output will act like an open circuit; no current will flow out
of the pin. If the input is powered by a voltage source, the
output will source the short-circuit current of the device
and will protect itself by thermal limiting. In this case,
grounding the SHDN pin will turn off the device and stop
the output from sourcing the short-circuit current.
The ADJ pin of the adjustable device can be pulled above
or below ground by as much as 7V without damaging the
device. If the input is left open circuit or grounded, the ADJ
pin will act like an open circuit when pulled below ground
and like a large resistor (typically 5k) in series with a diode
when pulled above ground.
In situations where the ADJ pin is connected to a resistor
divider that would pull the ADJ pin above its 7V clamp volt-
age if the output is pulled high, the ADJ pin input current
must be limited to less than 5mA. For example, a resistor
divider is used to provide a regulated 1.5V output from the
1.21V reference when the output is forced to 20V. The top
resistor of the resistor divider must be chosen to limit the
current into the ADJ pin to less than 5mA when the ADJ
pin is at 7V. The 13V difference between OUT and ADJ
pins divided by the 5mA maximum current into the ADJ
pin yields a minimum top resistor value of 2.6k.
In circuits where a backup battery is required, several
different input/output conditions can occur. The output
voltage may be held up while the input is either pulled
to ground, pulled to some intermediate voltage, or is left
open circuit. Current flow back into the output will follow
the curve shown in Figure 12.
When the IN pin of the LT1963A is forced below the OUT
pin or the OUT pin is pulled above the IN pin, input cur-
rent will typically drop to less than 2μA. This can happen
if the input of the device is connected to a discharged
(low voltage) battery and the output is held up by either
a backup battery or a second regulator circuit. The state
of the SHDN pin will have no effect on the reverse output
current when the output is pulled above the input.
5.0
4.5 V OUT = V ADJ
4.0 LT1963A-1.5
3.5
LT1963A-1.8
3.0 V OUT = V FB
2.5 LT1963A-2.5
V OUT = V FB
2.0
1.5 V OUT = V FB
1.0 T J = 25°C
V IN = 0V
0.5 CURRENT FLOWS
INTO OUTPUT PIN
0
0 1 2 3 4 5 6 7 8 9 10
1963A F12
Figure 12. Reverse Output Current
20
For more information www.linear.com/LT1963A
1963aff
相关PDF资料 |
PDF描述 |
|---|---|
| GSA31DTKN-S288 | CONN EDGECARD 62POS .125 EXTEND |
| LT1120CS8#PBF | IC REG LDO ADJ 125MA 8SOIC |
| LT1963AEQ-3.3#PBF | IC REG LDO 3.3V 1.5A 5DD |
| GMA31DTKN-S288 | CONN EDGECARD 62POS .125 EXTEND |
| EL7641ILTZ-T7 | IC BOOST REG DC/DC TFT-LCD 32QFN |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LT1963AET-1.5 | 功能描述:IC REG LDO 1.5V 1.5A TO220-5 RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - 线性 系列:- 标准包装:800 系列:- 稳压器拓扑结构:正，固定式 输出电压:2.5V 输入电压:最高 16V 电压 - 压降（标准）:0.7V @ 4A 稳压器数量:1 电流 - 输出:4A 电流 - 限制（最小）:4.2A 工作温度:0°C ~ 125°C 安装类型:表面贴装 封装/外壳:TO-263-6，D²Pak（5 引线+接片），TO-263BA 供应商设备封装:TO-263-5 包装:带卷 (TR) 其它名称:AP1184K525L-13AP1184K525LDITR |
| LT1963AET-1.5#06PBF | 功能描述:IC REG LDO 1.5V 1.5A TO-220-5 RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - 线性 系列:- 标准包装:800 系列:- 稳压器拓扑结构:正，固定式 输出电压:2.5V 输入电压:最高 16V 电压 - 压降（标准）:0.7V @ 4A 稳压器数量:1 电流 - 输出:4A 电流 - 限制（最小）:4.2A 工作温度:0°C ~ 125°C 安装类型:表面贴装 封装/外壳:TO-263-6，D²Pak（5 引线+接片），TO-263BA 供应商设备封装:TO-263-5 包装:带卷 (TR) 其它名称:AP1184K525L-13AP1184K525LDITR |
| LT1963AET-1.5#PBF | 功能描述:IC REG LDO 1.5V 1.5A TO220-5 RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - 线性 系列:- 标准包装:800 系列:- 稳压器拓扑结构:正，固定式 输出电压:2.5V 输入电压:最高 16V 电压 - 压降（标准）:0.7V @ 4A 稳压器数量:1 电流 - 输出:4A 电流 - 限制（最小）:4.2A 工作温度:0°C ~ 125°C 安装类型:表面贴装 封装/外壳:TO-263-6，D²Pak（5 引线+接片），TO-263BA 供应商设备封装:TO-263-5 包装:带卷 (TR) 其它名称:AP1184K525L-13AP1184K525LDITR |
| LT1963AET-1.5PBF | 制造商:LINER 制造商全称:Linear Technology 功能描述:1.5A, Low Noise,Fast Transient Response LDO Regulators |
| LT1963AET-1.5TR | 制造商:LINER 制造商全称:Linear Technology 功能描述:1.5A, Low Noise,Fast Transient Response LDO Regulators |
发布紧急采购，3分钟左右您将得到回复。