参数资料
| 型号： | LT1994CMS8#TRPBF |
| 厂商： | Linear Technology |
| 文件页数： | 5/20页 |
| 文件大小： | 0K |
| 描述： | IC DIFF AMP/DRIVER LN 8-MSOP |
| 标准包装： | 2,500 |
| 放大器类型： | 差分 |
| 电路数： | 1 |
| 输出类型： | 满摆幅 |
| 转换速率： | 65 V/µs |
| 增益带宽积： | 70MHz |
| 电流 - 输入偏压： | 18µA |
| 电压 - 输入偏移： | 3000µV |
| 电流 - 电源： | 14.8mA |
| 电流 - 输出 / 通道： | 85mA |
| 电压 - 电源，单路/双路(±)： | 2.375 V ~ 12.6 V，±1.188 V ~ 6.3 V |
| 工作温度： | 0°C ~ 70°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 8-TSSOP，8-MSOP（0.118"，3.00mm 宽） |
| 供应商设备封装： | 8-MSOP |
| 包装： | 带卷 (TR) |
13
1994fb
LT1994
Input Common Mode Voltage Range
The LT1994’s input common mode voltage (VICM)isdened
as the average of the two input voltages, VIN+, and VIN–.
It extends from V– to approximately 1.25V below V+. The
input common mode range depends on the circuit con-
guration (gain), VOCM and VCM (refer to Figure 4). For
fully differential input applications, where VINP = –VINM,
the common mode input is approximately:
V
VV
V
R
RR
V
R
RR
ICM
IN
OCM
I
IF
CM
F
FI
=
+
≈
+
+
+
–
2
With singled-ended inputs, there is an input signal com-
ponent to the input common mode voltage. Applying only
VINP (setting VINM to zero), the input common voltage is
approximately:
V
VV
V
R
RR
V
R
RR
VR
RR
ICM
IN
OCM
I
IF
CM
F
FI
INP
F
FI
=
+
≈
+
+
+
+
–
2
Output Common Mode Voltage Range
The output common mode voltage is dened as the aver-
age of the two outputs:
VV
OUTCM
OCM
OUT
==
+
–
2
The VOCM sets this average by an internal common mode
feedback loop which internally forces VOUT+ = –VOUT–. The
output common mode range extends from approximately
1.1V above V– to approximately 0.8V below V+. The VOCM
pin sits in the middle of an 80k
Ω to 80kΩ voltage divider
that sets the default mid-supply open-circuit potential.
In single-supply applications, where the LT1994 is used
to interface to an ADC, the optimal common mode input
range to the ADC is often determined by the ADC’s refer-
ence. If the ADC makes a reference available for setting
the input common mode voltage, it can be directly tied
to the VOCM pin, but must be capable of driving a 40k
equivalent resistance that is tied to a mid-supply potential.
If an external reference drives the VOCM pin, it should still
be bypassed with a high quality 0.1μF capacitor to a low
impedance ground plane to lter any thermal noise and
to prevent common mode signals on this pin from being
inadvertently converted to differential signals.
Noise Considerations
The LT1994’s input referred voltage noise is on the order
of 3nV/√Hz. Its input referred current noise is on the
order of 2.5pA/√Hz. In addition to the noise generated
by the amplier, the surrounding feedback resistors also
contribute noise. The output noise generated by both the
amplier and the feedback components is given by the
equation:
e
R
IR
e
R
e
no
ni
F
I
nF
nRI
F
I
nRF
=
+
+
() +
+
12
22
2
Figure 4. Circuit for Common Mode Range
VCM
1994 F04
RI
RF
RL
VS
VSHDNB
VINM
VINP
+
–
+
3
7
6
8
1
2
5
4
LT1994
VOCM
VOUT
+
VIN
–
VOUT
–
VIN
+
0.1μF
RI
RF
RL
SHDN
APPLICATIONS INFORMATION
相关PDF资料 |
PDF描述 |
|---|---|
| TA35-C2F4F050C0 | CIRCUIT BRKR THERMAL 5A 1POLE |
| 8564-4500PL | CONN SOCKET PCB VERT 64POS .1" |
| LTC6244CDD#TRPBF | IC OP AMP DUAL R-R 8-DFN |
| 0459844113 | CONN RCPT R/A 4PWR 12SGL 1.57MM |
| LTC6244CMS8#TRPBF | IC OP AMP DUAL R-R 8-MSOP |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LT1994HDD#PBF | 功能描述:IC DIFF AMP/DRIVER LN-LD 8-DFN RoHS:是 类别:集成电路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 标准包装:50 系列:- 放大器类型:通用 电路数:2 输出类型:满摆幅 转换速率:1.8 V/µs 增益带宽积:6.5MHz -3db带宽:4.5MHz 电流 - 输入偏压:5nA 电压 - 输入偏移:100µV 电流 - 电源:65µA 电流 - 输出 / 通道:35mA 电压 - 电源，单路/双路(±):1.8 V ~ 5.25 V，±0.9 V ~ 2.625 V 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:10-TFSOP，10-MSOP（0.118"，3.00mm 宽） 供应商设备封装:10-MSOP 包装:管件 |
| LT1994HDD#TR | 制造商:Linear Technology 功能描述:DIFF-AMPLIFIER, 70MHZ, 65V/US, DFN-8, No. of Amplifiers:1, Input Offset Voltage:2mV, Bandwidth:70MHz, Amplifier Case Style:DFN, No. of Pins:8, Supply Voltage Range:2.375V to 12.6V, Slew Rate:65V/s, Supply Current:14.8mA, MSL:- , RoHS Compliant: No |
| LT1994HDD#TRPBF | 功能描述:IC DIFF AMP/DRIVER LN-LD 8-DFN RoHS:是 类别:集成电路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 标准包装:50 系列:- 放大器类型:通用 电路数:2 输出类型:满摆幅 转换速率:1.8 V/µs 增益带宽积:6.5MHz -3db带宽:4.5MHz 电流 - 输入偏压:5nA 电压 - 输入偏移:100µV 电流 - 电源:65µA 电流 - 输出 / 通道:35mA 电压 - 电源，单路/双路(±):1.8 V ~ 5.25 V，±0.9 V ~ 2.625 V 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:10-TFSOP，10-MSOP（0.118"，3.00mm 宽） 供应商设备封装:10-MSOP 包装:管件 |
| LT1994IDD | 制造商:Linear Technology 功能描述:SP Amp DIFF AMP Single R-R O/P ±6.3V/12.6V 8-Pin DFN EP |
| LT1994IDD#PBF | 功能描述:IC DIFF AMP/DRIVER LN 8-DFN RoHS:是 类别:集成电路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 产品培训模块:Differential Circuit Design Techniques for Communication Applications 标准包装:1 系列:- 放大器类型:RF/IF 差分 电路数:1 输出类型:差分 转换速率:9800 V/µs 增益带宽积:- -3db带宽:2.9GHz 电流 - 输入偏压:3µA 电压 - 输入偏移:- 电流 - 电源:40mA 电流 - 输出 / 通道:- 电压 - 电源，单路/双路(±):3 V ~ 3.6 V 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:16-VQFN 裸露焊盘，CSP 供应商设备封装:16-LFCSP-VQ 包装:剪切带 (CT) 产品目录页面:551 (CN2011-ZH PDF) 其它名称:ADL5561ACPZ-R7CT |
发布紧急采购，3分钟左右您将得到回复。