参数资料
| 型号： | LT1994IMS8#TRPBF |
| 厂商： | Linear Technology |
| 文件页数： | 5/20页 |
| 文件大小： | 0K |
| 描述： | IC DIFF AMP/DRIVER LN 8-MSOP |
| 标准包装： | 2,500 |
| 放大器类型： | 差分 |
| 电路数： | 1 |
| 输出类型： | 满摆幅 |
| 转换速率： | 65 V/µs |
| 增益带宽积： | 70MHz |
| 电流 - 输入偏压： | 18µA |
| 电压 - 输入偏移： | 3000µV |
| 电流 - 电源： | 14.8mA |
| 电流 - 输出 / 通道： | 85mA |
| 电压 - 电源，单路/双路(±)： | 2.375 V ~ 12.6 V，±1.188 V ~ 6.3 V |
| 工作温度： | -40°C ~ 85°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 8-TSSOP，8-MSOP（0.118"，3.00mm 宽） |
| 供应商设备封装： | 8-MSOP |
| 包装： | 带卷 (TR) |
13
1994fb
LT1994
Input Common Mode Voltage Range
The LT1994’s input common mode voltage (VICM)isdened
as the average of the two input voltages, VIN+, and VIN–.
It extends from V– to approximately 1.25V below V+. The
input common mode range depends on the circuit con-
guration (gain), VOCM and VCM (refer to Figure 4). For
fully differential input applications, where VINP = –VINM,
the common mode input is approximately:
V
VV
V
R
RR
V
R
RR
ICM
IN
OCM
I
IF
CM
F
FI
=
+
≈
+
+
+
–
2
With singled-ended inputs, there is an input signal com-
ponent to the input common mode voltage. Applying only
VINP (setting VINM to zero), the input common voltage is
approximately:
V
VV
V
R
RR
V
R
RR
VR
RR
ICM
IN
OCM
I
IF
CM
F
FI
INP
F
FI
=
+
≈
+
+
+
+
–
2
Output Common Mode Voltage Range
The output common mode voltage is dened as the aver-
age of the two outputs:
VV
OUTCM
OCM
OUT
==
+
–
2
The VOCM sets this average by an internal common mode
feedback loop which internally forces VOUT+ = –VOUT–. The
output common mode range extends from approximately
1.1V above V– to approximately 0.8V below V+. The VOCM
pin sits in the middle of an 80k
Ω to 80kΩ voltage divider
that sets the default mid-supply open-circuit potential.
In single-supply applications, where the LT1994 is used
to interface to an ADC, the optimal common mode input
range to the ADC is often determined by the ADC’s refer-
ence. If the ADC makes a reference available for setting
the input common mode voltage, it can be directly tied
to the VOCM pin, but must be capable of driving a 40k
equivalent resistance that is tied to a mid-supply potential.
If an external reference drives the VOCM pin, it should still
be bypassed with a high quality 0.1μF capacitor to a low
impedance ground plane to lter any thermal noise and
to prevent common mode signals on this pin from being
inadvertently converted to differential signals.
Noise Considerations
The LT1994’s input referred voltage noise is on the order
of 3nV/√Hz. Its input referred current noise is on the
order of 2.5pA/√Hz. In addition to the noise generated
by the amplier, the surrounding feedback resistors also
contribute noise. The output noise generated by both the
amplier and the feedback components is given by the
equation:
e
R
IR
e
R
e
no
ni
F
I
nF
nRI
F
I
nRF
=
+
+
() +
+
12
22
2
Figure 4. Circuit for Common Mode Range
VCM
1994 F04
RI
RF
RL
VS
VSHDNB
VINM
VINP
+
–
+
3
7
6
8
1
2
5
4
LT1994
VOCM
VOUT
+
VIN
–
VOUT
–
VIN
+
0.1μF
RI
RF
RL
SHDN
APPLICATIONS INFORMATION
相关PDF资料 |
PDF描述 |
|---|---|
| EL5252IY-T13 | IC AMP VFA DUAL 300MHZ 10-MSOP |
| EL5251IY-T13 | IC AMP VFA DUAL 200MHZ 8-MSOP |
| LT1490ACMS8#TRPBF | IC OPAMP DUAL R-R MCRPWR 8MSOP |
| EL5251IS-T13 | IC AMP VFA DUAL 200MHZ 8-SOIC |
| RT0603DRD07124RL | RES 124 OHM 1/10W .5% 0603 SMD |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LT1994MPDD#PBF | 功能描述:IC OP AMP I/O DIFF LN 8-DFN RoHS:是 类别:集成电路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 标准包装:2,500 系列:- 放大器类型:通用 电路数:4 输出类型:- 转换速率:0.6 V/µs 增益带宽积:1MHz -3db带宽:- 电流 - 输入偏压:45nA 电压 - 输入偏移:2000µV 电流 - 电源:1.4mA 电流 - 输出 / 通道:40mA 电压 - 电源，单路/双路(±):3 V ~ 32 V，±1.5 V ~ 16 V 工作温度:0°C ~ 70°C 安装类型:表面贴装 封装/外壳:14-TSSOP（0.173"，4.40mm 宽） 供应商设备封装:14-TSSOP 包装:带卷 (TR) 其它名称:LM324ADTBR2G-NDLM324ADTBR2GOSTR |
| LT1994MPDD#TRPBF | 功能描述:IC DIFF AMP/DRIVER LN 8-MSOP RoHS:是 类别:集成电路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 标准包装:50 系列:- 放大器类型:J-FET 电路数:2 输出类型:- 转换速率:3.5 V/µs 增益带宽积:1MHz -3db带宽:- 电流 - 输入偏压:30pA 电压 - 输入偏移:2000µV 电流 - 电源:200µA 电流 - 输出 / 通道:- 电压 - 电源，单路/双路(±):7 V ~ 36 V，±3.5 V ~ 18 V 工作温度:0°C ~ 70°C 安装类型:通孔 封装/外壳:8-DIP（0.300"，7.62mm） 供应商设备封装:8-PDIP 包装:管件 |
| LT1995 | 制造商:LINER 制造商全称:Linear Technology 功能描述:32MHz, 1000V/μs Gain Selectable Amplifier |
| LT1995CDD | 制造商:LINER 制造商全称:Linear Technology 功能描述:32MHz, 1000V/μs Gain Selectable Amplifier |
| LT1995CDD#PBF | 功能描述:IC AMP GAIN SELECT 10-DFN RoHS:是 类别:集成电路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 标准包装:1 系列:- 放大器类型:通用 电路数:4 输出类型:满摆幅 转换速率:0.028 V/µs 增益带宽积:105kHz -3db带宽:- 电流 - 输入偏压:3nA 电压 - 输入偏移:100µV 电流 - 电源:3.3µA 电流 - 输出 / 通道:12mA 电压 - 电源，单路/双路(±):2.7 V ~ 12 V，±1.35 V ~ 6 V 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:14-TSSOP（0.173"，4.40mm 宽） 供应商设备封装:14-TSSOP 包装:剪切带 (CT) 其它名称:OP481GRUZ-REELCT |
发布紧急采购，3分钟左右您将得到回复。