- 您现在的位置：买卖IC网 > PDF目录1823 > LT3009ESC8-1.5#TRMPBF (Linear Technology)IC REG LDO 1.5V 20MA SC70-8 PDF资料下载
参数资料
| 型号： | LT3009ESC8-1.5#TRMPBF |
| 厂商： | Linear Technology |
| 文件页数： | 5/20页 |
| 文件大小： | 0K |
| 描述： | IC REG LDO 1.5V 20MA SC70-8 |
| 产品培训模块： | More Information on LDOs |
| 标准包装： | 1 |
| 稳压器拓扑结构： | 正，固定式 |
| 输出电压： | 1.5V |
| 输入电压： | 最高 20V |
| 电压 - 压降（标准）： | 0.28V @ 20mA |
| 稳压器数量： | 1 |
| 电流 - 输出： | 20mA |
| 电流 - 限制（最小）： | 22mA |
| 工作温度： | -40°C ~ 125°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 8-VFSOP（0.492"，1.25mm 宽） |
| 供应商设备封装： | SC-70-8 |
| 包装： | 剪切带 (CT) |
| 产品目录页面： | 1330 (CN2011-ZH PDF) |
| 其它名称： | LT3009ESC8-1.5#TRMPBFCT |
LT3009 Series
ELECTRICAL CHARACTERISTICS The l denotes the speci?cations which apply over the full operating
temperature range, otherwise speci?cations are at T J = 25°C. (Note 2)
PARAMETER
Output Voltage Noise (Note 9)
ADJ Pin Bias Current
CONDITIONS
C OUT = 1μF, I LOAD = 20mA, BW = 10Hz to 100kHz
l
MIN
–10
TYP
150
0.3
MAX
10
UNITS
μV RMS
nA
Shutdown Threshold
SHDN Pin Current
Quiescent Current in Shutdown
V OUT = Off to On
V OUT = On to Off
V SHDN = 0V, V IN = 20V
V SHDN = 20V, V IN = 20V
V IN = 6V, V SHDN = 0V
l
l
l
l
l
0.2
0.66
0.36
0.5
1.5
±1
1.6
<1
V
V
μA
μA
μA
Ripple Rejection (Note 3)
V IN – V OUT = 1.5V, V RIPPLE = 0.5V P-P ,
f RIPPLE = 120Hz, I LOAD = 20mA
LT3009
LT3009-1.2
LT3009-1.5
LT3009-1.8
LT3009-2.5
LT3009-3.3
LT3009-5
60
57
55.5
54
52
49
44
72
68
67
66
63
61
56
dB
dB
dB
dB
dB
dB
dB
Current Limit
V IN = 20V, V OUT = 0
V IN = V OUT(NOMINAL) + 1V, V OUT = – 5%
l
22
60
mA
mA
Input Reverse Leakage Current
Reverse Output Current
V IN = –20V, V OUT = 0
V OUT = 1.2V, V IN = 0
l
200
0.6
350
10
μA
μA
Note 1: Stresses beyond those listed under Absolute Maximum Ratings
may cause permanent damage to the device. Exposure to any Absolute
Maximum Rating condition for extended periods may affect device
reliability and lifetime.
Note 2: The LT3009 regulators are tested and speci?ed under pulse
load conditions such that T J ≈ T A . The LT3009E is guaranteed to meet
performance speci?cations from 0°C to 125°C operating junction
temperature. Speci?cations over the –40 °C to 125°C operating junction
temperature range are assured by design, characterization and correlation
with statistical process controls. The LT3009I is guaranteed over the full
–40°C to 125°C operating junction temperature range.
Note 3: The LT3009 adjustable version is tested and speci?ed for these
conditions with the ADJ pin connected to the OUT pin.
Note 4: Operating conditions are limited by maximum junction temperature.
The regulated output voltage speci?cation will not apply for all possible
combinations of input voltage and output current. When operating at the
maximum input voltage, the output current range must be limited. When
operating at the maximum output current, the input voltage must be limited.
Note 5: Dropout voltage is the minimum input to output voltage differential
needed to maintain regulation at a speci?ed output current. In dropout,
the output voltage equals (V IN – V DROPOUT ). For the LT3009-1.2, dropout
voltage will be limited by the minimum input voltage under some voltage/
load conditions.
Note 6: To satisfy minimum input voltage requirements, the LT3009
adjustable version is tested and speci?ed for these conditions with an
external resistor divider (61.9k bottom, 280k top) which sets V OUT to 3.3V.
The external resistor divider adds 9.69μA of DC load on the output. This
external current is not factored into GND pin current.
Note 7: GND pin current is tested with V IN = V OUT(NOMINAL) + 0.5V and a
current source load. GND pin current will increase in dropout. For the ?xed
output voltage versions, an internal resistor divider will add to the GND
pin current ( 2μA for the LT3009-5, 1μA for the LT3009-1.2, LT3009-1.5,
LT3009-1.8, LT3009-2.5 and LT3009-3.3). See the GND Pin Current curves
in the Typical Performance Characteristics section.
Note 8: The SHDN pin can be driven below GND only when tied to the IN
pin directly or through a pull-up resistor. If the SHDN pin is driven below
GND by more than –0.3V while IN is powered, the output will turn on.
Note 9: Output noise is listed for the adjustable version with the ADJ pin
connected to the OUT pin. See the RMS Output Noise vs Load Current
curve in the Typical Performance Characteristics Section.
3009fd
5
相关PDF资料 |
PDF描述 |
|---|---|
| LT3010MPMS8E-5#TRPBF | IC REG LDO 5V 50MA 8-MSOP |
| LT3011HMSE#TRPBF | IC REG LDO ADJ 50MA 12-MSOP |
| LT3012HFE#TRPBF | IC REG LDO ADJ .2A 16-TSSOP |
| LT3013MPFE#PBF | IC REG LDO ADJ .25A 16-TSSOP |
| LT3014HVIS5#TRPBF | IC REG LDO ADJ 20MA SOT23-5 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LT3009ESC8-2.5#PBF | 制造商:Linear Technology 功能描述:LDO Regulator Pos 2.5V 0.02A 8-Pin SC-70 制造商:Linear Technology 功能描述:LDO Regulator Pos 2.5V 0.02A 8-Pin SC-70 Bulk |
| LT3009ESC8-2.5#TRMPBF | 制造商:Linear Technology 功能描述:LDO Regulator Pos 2.5V 0.02A 8-Pin SC-70 |
| LT3009ESC8-2.5#TRPBF | 制造商:Linear Technology 功能描述:LDO Regulator Pos 2.5V 0.02A 8-Pin SC-70 T/R |
| LT3009ESC8-3.3#PBF | 制造商:Linear Technology 功能描述:LDO Regulator Pos 3.3V 0.02A 8-Pin SC-70 制造商:Linear Technology 功能描述:LDO Regulator Pos 3.3V 0.02A 8-Pin SC-70 Bulk |
| LT3009ESC8-3.3#TRMPBF | 功能描述:IC REG LDO 3.3V 20MA SC70-8 RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - 线性 系列:- 标准包装:1 系列:- 稳压器拓扑结构:正，固定式 输出电压:2.7V 输入电压:最高 5.5V 电压 - 压降（标准）:0.21V @ 150mA 稳压器数量:1 电流 - 输出:150mA 电流 - 限制（最小）:- 工作温度:-40°C ~ 125°C 安装类型:表面贴装 封装/外壳:SOT-23-5 细型，TSOT-23-5 供应商设备封装:TSOT-23-5 包装:剪切带 (CT) 产品目录页面:1100 (CN2011-ZH PDF) 其它名称:576-1852-1 |
发布紧急采购，3分钟左右您将得到回复。