参数资料
| 型号： | LT3080EST#PBF |
| 厂商： | Linear Technology |
| 文件页数： | 4/28页 |
| 文件大小： | 0K |
| 描述： | IC REG LDO ADJ 1.1A SOT223-3 |
| 产品培训模块： | LT3080 Linear Voltage Regulator More Information on LDOs |
| 特色产品： | LT3080 |
| 标准包装： | 78 |
| 稳压器拓扑结构： | 正，可调式 |
| 输出电压： | 可调至 36V |
| 输入电压： | 1.2 V ~ 36 V |
| 电压 - 压降（标准）： | 1.35V @ 1.1A |
| 稳压器数量： | 1 |
| 电流 - 输出： | 1.1A |
| 电流 - 限制（最小）： | 1.1A |
| 工作温度： | -40°C ~ 125°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | TO-261-4，TO-261AA |
| 供应商设备封装： | SOT-223 |
| 包装： | 管件 |
| 产品目录页面： | 1331 (CN2011-ZH PDF) |
第1页第2页第3页当前第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页
LT3080
ELECTRICAL CHARACTERISTICS The l denotes the specifications which apply over the full operating
temperature range, otherwise specifications are at T A = 25°C. (Note 11)
PARAMETER
CONDITIONS
MIN
TYP
MAX
UNITS
SET Pin Current
I SET
V IN = 1V, V CONTROL = 2.0V, I LOAD = 1mA, T J = 25°C
V IN ≥ 1V, V CONTROL ≥ 2.0V, 1mA ≤ I LOAD ≤ 1.1A (Note 9)
l
9.90
9.80
10
10
10.10
10.20
μA
μA
Output Offset Voltage (V OUT – V SET )
V IN = 1V, V CONTROL = 2V, I OUT = 1mA
V OS DFN and MSOP Package
SOT-223, DD-Pak and T0-220 Package
l
l
–2
–3.5
–5
–6
2
3.5
5
6
mV
mV
mV
mV
Load Regulation
Δ I SET
Δ V OS
Δ I LOAD = 1mA to 1.1A
Δ I LOAD = 1mA to 1.1A (Note 8)
l
–0.1
0.6
1.3
nA
mV
Line Regulation (Note 9)
DFN and MSOP Package
Line Regulation (Note 9)
SOT-223, DD-Pak and T0-220 Package
Minimum Load Current (Notes 3, 9)
V CONTROL Dropout Voltage (Note 4)
V IN Dropout Voltage (Note 4)
V CONTROL Pin Current
Δ I SET V IN = 1V to 25V, V CONTROL = 2V to 25V, I LOAD = 1mA
Δ V OS V IN = 1V to 25V, V CONTROL = 2V to 25V, I LOAD = 1mA
ΔI SET V IN = 1V to 26V, V CONTROL = 2V to 26V, I LOAD = 1mA
ΔV OS V IN = 1V to 26V, V CONTROL = 2V to 26V, I LOAD = 1mA
V IN = V CONTROL = 10V
V IN = V CONTROL = 25V (DFN and MSOP Package)
V IN = V CONTROL = 26V (SOT-223, DD-Pak and T0-220 Package)
I LOAD = 100mA
I LOAD = 1.1A
I LOAD = 100mA
I LOAD = 1.1A
I LOAD = 100mA
I LOAD = 1.1A
l
l
l
l
l
l
l
l
l
l
0.1
0.003
0.1
0.003
300
1.2
1.35
100
350
4
17
0.5
0.5
500
1
1
1.6
200
500
6
30
nA/V
mV/V
nA/V
mV/V
μA
mA
mA
V
V
mV
mV
mA
mA
Current Limit
Error Amplifier RMS Output Noise (Note 6 )
Reference Current RMS Output Noise (No te 6)
Ripple Rejection
Thermal Regulation, I SET
V IN = 5V, V CONTROL = 5V, V SET = 0V, V OUT = –0.1V
I LOAD = 1.1A, 10Hz ≤ f ≤ 100kHz, C OUT = 10μF, C SET = 0.1μF
10Hz ≤ f ≤ 100kHz
f = 120Hz, V RIPPLE = 0.5V P-P , I LOAD = 0.2A, C SET = 0.1μF, C OUT = 2.2μF
f = 10kHz
f = 1MHz
10ms Pulse
l
1.1
1.4
40
1
75
55
20
0.003
A
μV RMS
nA RMS
dB
dB
dB
%/W
Note 1: Stresses beyond those listed under Absolute Maximum Ratings
may cause permanent damage to the device. Exposure to any Absolute
Maximum Rating condition for extended periods may affect device
reliability and lifetime.
Note 2: Unless otherwise specified, all voltages are with respect to V OUT .
The LT3080 is tested and specified under pulse load conditions such that
T J ? T A . The LT3080E is tested at T A = 25°C. Performance of the LT3080E
over the full –40°C and 125°C operating temperature range is assured by
design, characterization, and correlation with statistical process controls.
The LT3080I is guaranteed over the full –40°C to 125°C operating junction
temperature range.
Note 3: Minimum load current is equivalent to the quiescent current of
the part. Since all quiescent and drive current is delivered to the output
of the part, the minimum load current is the minimum current required to
maintain regulation.
Note 4: For the LT3080, dropout is caused by either minimum control
voltage (V CONTROL ) or minimum input voltage (V IN ). Both parameters are
specified with respect to the output voltage. The specifications represent the
minimum input-to-output differential voltage required to maintain regulation.
Note 5: The V CONTROL pin current is the drive current required for the
output transistor. This current will track output current with roughly a 1:60
ratio. The minimum value is equal to the quiescent current of the device.
4
Note 6: Output noise is lowered by adding a small capacitor across the
voltage setting resistor. Adding this capacitor bypasses the voltage setting
resistor shot noise and reference current noise; output noise is then equal
to error amplifier noise (see Applications Information section).
Note 7: SET pin is clamped to the output with diodes. These diodes only
carry current under transient overloads.
Note 8: Load regulation is Kelvin sensed at the package.
Note 9: Current limit may decrease to zero at input-to-output differential
voltages (V IN –V OUT ) greater than 25V (DFN and MSOP package) or 26V
(SOT-223, DD-Pak and T0-220 Package). Operation at voltages for both IN
and V CONTROL is allowed up to a maximum of 36V as long as the difference
between input and output voltage is below the specified differential
(V IN –V OUT ) voltage. Line and load regulation specifications are not
applicable when the device is in current limit.
Note 10: This IC includes overtemperature protection that is intended
to protect the device during momentary overload conditions. Junction
temperature will exceed the maximum operating junction temperature when
overtemperature protection is active. Continuous operation above the specified
maximum operating junction temperature may impair device reliability.
Note 11: The SOT-223 package connects the IN and V CONTROL pins
together internally. Therefore, test conditions for this pin follow the
V CONTROL conditions listed in the Electrical Characteristics Table.
3080fc
相关PDF资料 |
PDF描述 |
|---|---|
| ACM25DRYF | CONN EDGECARD 50POS DIP .156 SLD |
| ASM18DRXN | CONN EDGECARD 36POS DIP .156 SLD |
| ASM18DRXH | CONN EDGECARD 36POS DIP .156 SLD |
| HBC25DRYS-S93 | CONN EDGECARD 50POS DIP .100 SLD |
| 1210-682J | INDUCTOR FERRITE CORE 6.8UH SMD |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LT3080EST-TR | 制造商:LINER 制造商全称:Linear Technology 功能描述:Adjustable1.1A Single Resistor Low Dropout Regulator |
| LT3080EST-TRPBF | 制造商:LINER 制造商全称:Linear Technology 功能描述:Adjustable1.1A Single Resistor Low Dropout Regulator |
| LT3080ET | 制造商:LINER 制造商全称:Linear Technology 功能描述:Adjustable1.1A Single Resistor Low Dropout Regulator |
| LT3080ET#31PBF | 制造商:Linear Technology 功能描述:IC REG LDO ADJ 1.1A TO220-5 |
| LT3080ET#PBF | 功能描述:IC REG LDO ADJ 1.1A TO220-5 RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - 线性 系列:- 标准包装:1 系列:- 稳压器拓扑结构:正，固定式 输出电压:8V 输入电压:10.5 V ~ 23 V 电压 - 压降（标准）:1.7V @ 40mA 稳压器数量:1 电流 - 输出:100mA（最小值） 电流 - 限制（最小）:- 工作温度:0°C ~ 125°C 安装类型:表面贴装 封装/外壳:8-SOIC（0.154"，3.90mm 宽） 供应商设备封装:8-SOIC 包装:剪切带 (CT) 产品目录页面:1075 (CN2011-ZH PDF) 其它名称:296-24390-1 |
发布紧急采购，3分钟左右您将得到回复。